GE JSS26BDBB Handleiding

GE Fornuis JSS26BDBB

Lees hieronder de 📖 handleiding in het Nederlandse voor GE JSS26BDBB (12 pagina's) in de categorie Fornuis. Deze handleiding was nuttig voor 44 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/12
11
229C4053P557-2
31-10567-2 05-04 JR
Installation
30” Electric
Instructions Slide-In Range
BEFORE YOU BEGIN
Read these instructions completely
and carefully.
•IMPORTANT — Save these
instructions for local inspector’s use.
•IMPORTANT — Observe all
governing codes and ordinances.
•Note to Installer – Be sure to leave these
instructions with the Consumer.
•Note to Consumer – Keep these
instructions for future reference.
•Skill level – Installation of this appliance
requires basic mechanical skills.
•Completion time – 1 to 3 hours
• Proper installation is the responsibility of
the installer.
• Product failure due to improper installation
is not covered under the Warranty.
WARNING — This appliance must
be properly grounded.
FOR YOUR SAFETY:
CAUTION: —For Personal Safety
remove house fuse or open circuit breaker
before beginning installation. Failure to do so
could result in serious injury or even death.
ANTI-TIP DEVICE
WARNING —To reduce the risk
of tipping, the appliance must be secured by
properly installed Anti-Tip bracket packed
with this appliance.
If the Anti-Tip device supplied with the range
does not fit this application, use the universal
Anti-Tip device WB2X7909.
WARNING —
• All ranges can tip
• Injury to persons could result
• Install Anti-Tip bracket packed
with range
• See Installation Instructions
If you pull the range out and away from the
wall for any reason, make sure the Anti-Tip
bracket is engaged when the range is pushed
back against the wall.
Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: www.GEAppliances.com
2
Installation Instructions
FOR YOUR SAFETY:
All rough-in and spacing dimensions must be
met for safe use of your range. Electricity to
the range can be disconnected at the outlet
without moving the range if the outlet is in
the preferred location (remove lower drawer).
To reduce the risk of burns or fire when
reaching over hot surface elements, cabinet
storage space above the cooktop should be
avoided. If cabinet storage space is to be
provided above the cooktop, the risk can
be reduced by installing a range hood that
sticks out at least 5″beyond the front of the
cabinets. Cabinets installed above a cooktop
must be no deeper than 13″.
Be sure your appliance is properly installed
and grounded by a qualified technician.
PREPARE TO INSTALL THE RANGE
TOOLS YOU WILL NEED
Straight Edge
Drill with 1/8″Bit
Hand or Saber Saw
Pencil
Safety Glasses
Tape Measure
REMOVE SHIPPING MATERIALS
Remove all parts from the plastic bag found
inside the prepack of the oven and save
packaging tape.
1
ANTI-TIP DEVICE INSTALLATION
Before placing range in the counter, check the
factory location of the stability device on the
back of the range. For convenience you can
hook the stability chain in the upper set of
holes. Make sure there is no structural
interference when using the upper set of holes.
Decide on a location
that has no electrical
wiring or plumbing.
With the long screw
provided anchor the
chain to the floor or wall.
Make sure the
screw is going
into the wall plate
or stud at the
base of the wall
at least 3/4″.
Attach the stability chain so that it lines up
with the bracket on the back of the range.
Tug the chain to make sure it is securely
fastened.
Take the packaging
tape and temporarily
attach the loose end
of the chain to the
rear of the countertop.
Slide the range
into the counter
leaving enough
space behind to attach
the chain to the bracket.
G
F
E
D
C
B
A
2
Backguard (some models)
Mainback
Bracket Optional
Location
Chain
Chain
Chain
Long
Screw
Washer
Tape
Wall
Plate
Washer
and
Screw
Bracket Factory
Location
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Chain
MINIMUM CLEARANCES (CONT.)
MINIMUM DIMENSIONS BETWEEN
COOKTOP AND CABINETS OR WALLS
Electrical Outlet Area
(Back of counter in cutout not shown for clarity)
• The distance from the floor to the top
of the counter must be at least 35-7/8″.
The maximum countertop height is 38″.
Make sure the wall coverings, countertop and
cabinets around the cooktop can withstand
the heat (up to 200°F) generated by the range.
NOTE: Dimension for Wall to Front of Door
Handle (door closed).
*28″FOR MODELS – JSP26, JSS26, JSC26,
JSS16, RS734, RS504
**28-1/2″FOR MODELS – JSP39, JSP38, JSP31,
JSP28, RS744, RS622, JS960, JSP40, JSP34
3
3
Installation Instructions
MINIMUM CLEARANCES
• The distance from the floor to the top
of the counter must be at least 35-7/8″.
The maximum counter height is 38″.
•30″ranges conform to U.L. requirements
for 0″spacing from vertical walls above
countertops. However, some kitchen cabinet
finishes can be damaged by heat from the
range surface elements. Where varnished
wood or plastic film finishes are used,
a minimum clearance of 6″must be
maintained.
• For listed over-the-range microwave
ovens, the microwave ovens can be
installed above the cooktop as per
manufacturer’s installation instructions.
•The range may be placed with 0″clearance
(flush) at the back wall and side walls if the
range side trims extend beyond the cabinet
fronts at least 1/4″.
• See Figures 1 and 2 for all rough-in and
spacing dimensions. These dimensions
must be met for safe use of your range.
The location of the electrical outlet may
be changed as needed, but electricity to
the range can be disconnected at the outlet
without moving the range if the outlet is
in the suggested location (remove lower
drawer).
3
ANTI-TIP DEVICE INSTALLATION
(CONT.)
Slip the nearest link of the chain onto the
bracket. Pull to make sure it is as snug as
possible.
Slide the range all the way back. It is
normal to have some slack in the chain,
but it should not be excessive.
I
H
2
0”
18” Min.
30” Min.
0”
6”
Min.
6”
41⁄ ”2
21⁄ ”4
30”
36”
30”
Acceptable
electrical
outlet area.
Backguard (some models)
Mainback
Bracket Optional
Location
Chain
Bracket Factory
Location
281⁄2”** Wall to front
of door handle
(door closed) 45”
with door open
Fig. 5
Fig. 6
Fig. 7
28”*
1⁄ ”4
5”

Product specificaties

Merk: GE
Categorie: Fornuis
Model: JSS26BDBB

Heb je hulp nodig?

Als je hulp nodig hebt met GE JSS26BDBB stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Fornuis GE

GE

GE EER3000HKC Handleiding

7 December 2024
GE

GE EER3000LBB Handleiding

7 December 2024
GE

GE Adora JB755EJES Handleiding

7 December 2024
GE

GE EER2000MBB Handleiding

7 December 2024
GE

GE EER2002MBS Handleiding

7 December 2024
GE

GE EER3000HBB Handleiding

7 December 2024
GE

GE EER3000LKC Handleiding

7 December 2024
GE

GE EER3001HSS Handleiding

7 December 2024
GE

GE EER3000LTW Handleiding

7 December 2024
GE

GE EER3000HTW Handleiding

7 December 2024

Handleiding Fornuis

Nieuwste handleidingen voor Fornuis

Whirlpool

Whirlpool WLB3965BFIXL Handleiding

21 December 2024
Kaiser

Kaiser KCG 6335 RotEm Turbo Handleiding

20 December 2024
Kaiser

Kaiser KCT 7797 FI ElfEm Handleiding

20 December 2024
Kaiser

Kaiser KCG 9387 Turbo Handleiding

20 December 2024
Svan

Svan SKGW4601 Handleiding

20 December 2024
Svan

Svan SKMW4600X Handleiding

20 December 2024
Kaiser

Kaiser KG 9325 Em Turbo Handleiding

20 December 2024
Kaiser

Kaiser KCT 4795 FI AD Handleiding

20 December 2024
Kaiser

Kaiser KCT 6703 F Handleiding

20 December 2024
Svan

Svan SKM4500X Handleiding

20 December 2024