Froggy's Fog Fobbles-F3 Handleiding


Lees hieronder de đź“– handleiding in het Nederlandse voor Froggy's Fog Fobbles-F3 (4 pagina's) in de categorie Effect machine. Deze handleiding was nuttig voor 2 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4
Rev 2.2
1
Fobbles
Fobbles
Fobbles
Fobbles Fobbles F
F
F
FF3
3
3
33 -
-
-
- - U
U
U
U User
ser
ser
ser ser Manual
Manual
Manual
ManualManual
Specifications
Safety Information
• Under normal use, bubble solution can build up on surfaces beneath and in front of the machine. Exercise care during use
to avoid slipping hazards.
• Keep this device dry. The unit may be used outdoors, but must be shielded from inclement weather. Turn off or unplug
when not in use.
• - Use 3 prong grounded electrical outlet only. Take care to determine that the unit is installed at the rated 120V.
• Always unplug your fog bubble machine before filling its tank.
• Always keep the fog bubble machine upright and level.
• The machine is not waterproof or splash proof. If outside moisture gets inside the housing, immediately unplug, and
contact a service technician or your dealer before using it again.
• No user serviceable parts inside. Refer to your dealer or other qualified service personnel.
• For adult use only. Fog machine must be installed out of the reach of children. Never leave the unit running unattended.
• Never point the nozzle directly at people. Fog machine output at the nozzle is very hot (300 degrees C).
• - Never cover the unit’s vents. Operate machine in a well ventilated area and allow free air space of at least 6” around unit.
• - Only specifically designed water based scent additives may be added to the fog or bubble fluid. Never add flammable
liquids of any kind (oil, gas, non-application specific perfumes). Pay attention to all warning labels and instructions
printed on the exterior of your machine.
• Use only the high quality, Froggys Fog, water based fog fluid in the machine. Always make sure there is sufficient liquid in
the fog liquid tank. Operating this unit without liquid will cause damage to the heater and pump systems.
• Always drain reservoirs before mailing or transporting this unit.
• Always disconnect the power from equipment when not in use or before cleaning! Only handle the power-cable by the
plug. Never pull out the plug by pulling the power- cable.
• Make sure that the power-cable is never crimped or damaged. Check the equipment and the power cable periodically. -
• If the equipment is dropped or damaged, disconnect the mains power supply immediately. Have a qualified engineer
inspect the equipment before operating again.
• Do not expose to flammable sources or gases.
• Never drink fog or bubble liquid. If ingestion occurs, seek medical assistance. For contact with skin or eyes, rinse
thoroughly with water.
• Vapor from this fluid may be irritating to some persons with allergic sensitivity. Do not expose at close range to known
asthmatic. Use in a well- ventilated area.
Model
Wattage
FRG FOBBLES- -F3
1200 Watts
5 ,000
6 Min
Rev 2.2
2
Important Notes
• DO NOT PUT BUBBLE FLUID IN THE REAR FOG FLUID RESEVOIR BOTTLE. THIS WILL DAMAGE THE HEATER CORE AND VOID
THE WARRANTY OF THE MACHINE
• The manufacturer will not accept liability for any resulting damages caused by the non-observance of this manual or any
unauthorized modification to the equipment.
• If the equipment has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on
immediately. The arising condensation might damage the equipment. Leave the equipment switched off until it has
reached room temperature.
• Only use fuses of same type and rating.
• Repairs, servicing, and power connection must only be carried out by a qualified technician. THIS UNIT CONTAINS NO
USER SERVICEABLE PARTS.
S etup
• Open the box to verify product integrity. If the unit’s housing or cable is damaged, do not plug it in and do not attempt to
use it until after contacting your dealer for assistance.
• Place fog bubble machine on a level flat surface, remove fog liquid reservoir cap toward rear of the machine. Fill fog fluid
reservoir with Froggys Fog Brand Fog Fluid. Lower quality fluid can damage the unit. Recap tank.
• Fill bubble reservoir at the front with a high-quality bubble fluid, such as Froggys Fog Max Bubbles. Lesser quality bubble
fluids cannot withstand the increased pressure of hot fog and will burst prematurely. The bubble solution can become
diluted with fog moisture over time and occasionally will need to be drained and refilled during usefresh if performance
is impacted.
O peration
After switching on via the On/Off switch, the LCD screen will display
“WARMING UP”. When the unit has reached the correct temperature, the
LCD display will show “READY”, and the unit is now ready for operation
Remote Pairing/ Un Pairing Procedure
• Press the REMOTE button on the machine and hold on until the
REMOTE LED light ands red, release the REMOTE button press the A
or B button on the the REMOTE LED light remote controller until
turns green on machine. Release the A or B button on the remote
controller . to complete the pairing
• If successful, user can control the machine with remote controller as below:
o A button: Choose the 1- 4 different Modes:
1. Fog 2. Haze 3. Bubble 4. Fobbles
o B button: ON or OFF
o C button: Fog Volume Increase
Rev 2.2
3
o D button: Fog Volume Decrease
• Remote button presses will give a green status LED on the machine.
• Un Pairing - Press the REMOTE button on the machine and hold until the REMOTE LED on the machine
illuminates red and flashes three times in red and then off. Release the REMOTE button to complete the
un-pairing. Please note that the un-pairing procedure doesn't require any presses on the remote
controller. After un-pairing, the remote LED will not illuminate, and no functions will be performed by the
machine.
Machine Features
-Manual Output
For manual output at 100% output, simply press the “MANUAL” button and hold until the desired amount of is output
emitted.
- Constant Burst Operation
To set unit for constant burst, press the “LOCK” “LOCK” button. To stop the constant burst simply press the button again.
During this buttons. operation, you can change the fog volume output by pressing the “UP” and “DOWN”
-Timer Mode
Press the timer button to start timer functionality according to the LCD display settings.
LCD Display Settings
LCD Display Settings
Description
Machine Function
Choose the program modes from 1- 4 to display different programs:
1. Fog 2 Fobbles. . Bubble 4. Haze 3
Fog Volume
Adjust the fog volume output within the range from 0% to 100%.
Bubble Wand Speed
Adjust the w s - and peed 0 100% in 10% Increments
Timer Interval
Adjust the interval between each fog emission within the range of 0 to 600S.
Timer Duration
Adjust the duration of each fog emission within the range of 0 to 300S.
Fog Fluid Sensor On/ Off
Deactivate the fog low fluid sensor


Product specificaties

Merk: Froggy's Fog
Categorie: Effect machine
Model: Fobbles-F3

Heb je hulp nodig?

Als je hulp nodig hebt met Froggy's Fog Fobbles-F3 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Effect machine Froggy's Fog

Handleiding Effect machine

Nieuwste handleidingen voor Effect machine