Frigidaire MWTK27FGUD Handleiding

Frigidaire Magnetron MWTK27FGUD

Lees hieronder de 📖 handleiding in het Nederlandse voor Frigidaire MWTK27FGUD (16 pagina's) in de categorie Magnetron. Deze handleiding was nuttig voor 26 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/16
Installation Instructions
Installation
Instructions
Built-in Trim Kit
Model #
BEFORE YOU BEGIN
• IMPORTANT – Save these instructions
for local inspector's use.
• IMPORTANT – Observe all governing
codes and ordinaces.
• Note to Installer – Be sure to leave
these instructions with the Consumer.
• Note to Consumer – Keep these
instructions for future reference.
• Skill level - Installation of this appliance
requires basic mechanical and electrical
skills.
Read these instructions completely and carefully.
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is
not covered under the Warranty.
• Unplug the microwave oven before
attempting installation of this kit.
• Because the kit includes metal parts, caution
should be used in handling and installation to
avoid the possibility of injury.
• Do not remove permanently affixed labels,
warnings, or plates from the product. This
may void the warranty.
FOR YOUR SAFETY:
WARNING – Before beginning the installation,
switch power off at service panel and lock out
When the service
cannot be locked, securely fasten
a prominent warning device, such as a tag, to
the service panel.
IMPORTANT - PLEASE READ
AND FOLLOW
THIS BUILT-IN KIT IS DESIGNED FOR USE
ONLY WITH ELECTROLUX MICROWAVE
OVENS SPECIFYING BUILT-IN KIT
QUESTIONS?
For customers in the United States call:1-800-944-9044
For customers in Canada call: 1-800-265-8352 (English)
1-800-668-4606 ext.8199 (French)
Visit our Website at: www.frigidaire.com
READ CAREFULLY.
KEEP THESE INSTRUCTIONS.
PN:
EN-1
MWTK27FGUF
MWTK30FGUF
MWTK30FGUD
MWTK27FGUD
MWTK30FPUF
A06823511
June 2018
to prevent being switched on accidentally.
PARTS INCLUDED IN THE KIT
1. Front Frame Assembly- QTY 1
2. Exhaust Duct - QTY 1
Mounting
Rail – QTY 2
3. Screw A - QTY 11+
4. Screw B - QTY 4
CHOOSING A LOCATION FOR
YOUR MICROWAVE OVEN IF
BUILT-IN
Built-In Trim Kit allows for the installation of microwaves
listed below to be built into a cabinet or wall by itself or
over an electric wall oven*.
Microwave Models:
See Illustration 1 for proper location and when building
in above a wall oven. Carefully follow both the wall oven
installation instructions and Electrolux’s Built-in Kit
instructions. If building over a wall oven, be sure the
clearance between the wall oven and the microwave
oven is a minimum of 3 inches.See illustration 2.
*NOTE: Trim Kit and microwave can only be built-in
over an electric self-clean or non self-clean
single cavity wall oven.
CABINET OR WALL CUTOUT
Cutout Dimensions( See illustration 3)
Height (A)
Minimum
Maximum
16 (42.5 cm)
17 (43.2 cm)
Width (B)
Minimum
Maximum
24 (62.9 cm)
Depth (C)
Minimum
EN-2
Bottom
3 extra
+ 2 extra
FGMO226NUF FGMO226NUD FPMO227NUF
CGMO226NUF CPMO227NUF
(50.8 cm)
2
Illustration 1
Bottom Mounting
Rail
Exhaust Duct
Front Frame Assembly
Trim Kit Overall Dimensions
Height 18" （458mm）
Width （686mm）（762mm）
Depth
MWTK27 MWTK30
27"
18" （458mm）
30"
Installation Instructions
" (63.5 cm)
25
Screw A
Screw B
Illustration 2
1 1/2" (38.9cm) 1 1/2" (38.9cm)
3"Min
3/4
0"
3/4 "
"
"
EN-3
Installation Instructions
Illustration
ELECTRICAL OUTLET LOCATION
Outlet should NOT be in the shaded area as indicated
on Illustration 3
NOTE 1:
The floor of the opening should be constructed of
plywood strong enough to support the weight of the
oven and floor load (approximately 100 pounds). The
floor should be level for proper operation of the oven. Be
sure to check the local building code as it may require
that the opening be enclosed with side, ceiling and rear
partition. The proper functioning of the oven does not
require the enclosure.
Illustration
EXHAUST DUCT ASSEMBLY
1. Draw a Central Line on floor. Place the Exhaust
Duct in the opening，When the Exhaust Duct
Assembly is in the opening correctly, the Center
Line is in the middle of the Exhaust Duct
Assembly. See Illustration .
2. Secure the Exhaust Duct Assembly with the
three screws A.
IMPORTANT: Secure screws in outer hole.
3 are needed for exhaust duct assembly
Screw A
Center Line
pcs
3 4
4

Product specificaties

Merk: Frigidaire
Categorie: Magnetron
Model: MWTK27FGUD

Heb je hulp nodig?

Als je hulp nodig hebt met Frigidaire MWTK27FGUD stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Magnetron Frigidaire

Frigidaire

Frigidaire FMOS1746BS Handleiding

4 September 2024
Frigidaire

Frigidaire FMOS1745BS Handleiding

24 Maart 2024
Frigidaire

Frigidaire FFCT1278LS Handleiding

21 Juni 2023
Frigidaire

Frigidaire GMOS1266AF Handleiding

19 Juni 2023
Frigidaire

Frigidaire FFMO1611LW Handleiding

19 Juni 2023
Frigidaire

Frigidaire FGBM205KB Handleiding

16 Juni 2023
Frigidaire

Frigidaire FGMV185KF Handleiding

13 Juni 2023
Frigidaire

Frigidaire GLMV169HQ Handleiding

9 Juni 2023
Frigidaire

Frigidaire FFCE1638LW Handleiding

7 Juni 2023
Frigidaire

Frigidaire FFCM0734LS Handleiding

3 Juni 2023

Handleiding Magnetron

Nieuwste handleidingen voor Magnetron

Candy

Candy DIVO G20CR Handleiding

23 November 2024
Candy

Candy DIVO G20CC Handleiding

23 November 2024
Candy

Candy 20CBMW Handleiding

23 November 2024
Candy

Candy Divo G20CMB Handleiding

23 November 2024
Candy

Candy Divo G20CO Handleiding

23 November 2024
Candy

Candy Divo G20CG Handleiding

23 November 2024
Candy

Candy CMGE 20BS Handleiding

23 November 2024
Candy

Candy CPMG2071DS Handleiding

23 November 2024
Candy

Candy CMG2071M Handleiding

23 November 2024
Panasonic

Panasonic NN-GT358W Handleiding

23 November 2024