Flymo Hover Vac 250 Handleiding

Flymo Grasmaaier Hover Vac 250

Lees hieronder de 📖 handleiding in het Nederlandse voor Flymo Hover Vac 250 (6 pagina's) in de categorie Grasmaaier. Deze handleiding was nuttig voor 34 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/6
®
Hover Vac 250
Hover Vac 260
Hover Vac 270
Original Instructions
0344 844 4558 1800 882 350
Please register your
product warranty on line.
To register your warranty and for all
your parts requirements please visit
www.flymo.com
For all other enquiries
e
R
f
M
er
AT
ence
IO
NIMPORTANT
e use
INFO
Read befor
& retain for future r
114114226-A 2018-11-02
CARTON CONTENTS
See Picture 1.
1. Upper handle
2. Cable clip
3. Nut (if applicable)
4. Handle knob
5. Washer
6. Bolt
7. Lower handle
8. Fixing pin
9. Spanner/scraper tool
10. Cutting height spacers
11. Instruction manual
12. Warning label
13. Product rating label
14. Power cord (UK)
15. Switchbox
16. Start/stop lever
17. Grassbox
EXPLANATION OF SYMBOLS ON THE PRODUCT
See Picture 2.
1. Warning
2. Read the user instructions carefully to make sure you
understand all the controls and what they do.
3. Always keep the product on the ground when
operating. Tilting or lifting the product may cause
stones to be thrown out.
4. Keep bystanders away. Do not operate whilst people,
especially children or pets, are in the area.
5. Beware of sharp blades. Beware of severing toes or
hands. Do not put hands or feet near a rotating blade.
Blades continue to rotate after the machine is switched
off.
6. Switch off! Remove plug from mains before adjusting,
cleaning or if cable is entangled or damaged.
7. Electric shock hazard
8. Keep the cable supply away from the blade.
9. This product agrees with the applicable EC directives.
10. This symbol on the product or on its packaging
indicates that this product may not be treated as
household waste. Instead it shall be handed over
to the applicable collection point for the recycling of
electrical and electronic equipment. By ensuring this
product is disposed of correctly, you will help prevent
potential negative consequences for the environment
and human health, which could otherwise be caused
by inappropriate waste handling of this product.
For more detailed information about recycling of this
product, please contact your local council ofîš¿ce, your
household waste disposal service or the shop where
you purchased the product.
11. Guaranteed sound power level
12. Double insulated tool
SAFETY PRECAUTIONS
IMPORTANT! READ BEFORE USE AND RETAIN FOR FUTURE REFERENCE.
aWARNING! If not used properly this product
can be dangerous! This product can cause
serious injury to the operator. Warnings and
safety instructions must be followed to ensure
reasonable safety and efîš¿ciency in using this
product. The operator is responsible for following
the warning and safety instructions in this manual
and on the product.
General
1. This product is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning the use of the product by a
person responsible for their safety. Children should
be supervised to ensure that they do not play with the
product. Local regulations may restrict the age of the
operator.
2. Never allow children or people unfamiliar with the
instructions to use the machine.
3. Stop using the machine while people, especially
children, or pets are nearby.
4. Only use the product in the manner and for the
functions described in these instructions.
5. Never operate the product when you are tired, ill or
under the inuence of alcohol, drugs or medicine.
6. The operator or user is responsible for accidents or
hazards occurring to other people or their property.
Electrical
1. The use of a Residual Current Device (R.C.D.)
with a tripping current of not more than 30mA is
recommended. Even with a R.C.D., installed 100%
safety cannot be guaranteed and safe working practice
must be followed at all times. Check your R.C.D. every
time you use it.
2. Before use, examine the cable for signs of damage or
aging. If the cable is found to be defective, take the
product to an Authorised Service Centre and have the
cable replaced.
3. Do not use the product if the electric cables are
damaged or worn.
4. Immediately disconnect from the mains electricity
supply if the cable is cut, or the insulation is damaged.
Do not touch the electric cable until the electrical
supply has been disconnected. Do not repair a cut or
damaged cable. Replace it with a new one.
5. Your extension cable must be uncoiled. Coiled cables
can overheat and reduce the efîš¿ciency of your mower.
6. Keep cable away from product. Always work away
from the power point mowing up and down, never in
circles.
7. Do not pull cable around sharp objects.
8. Always switch off at the mains before disconnecting
any plug, cable connector or extension cable.
9. Switch off, remove plug from mains and examine
electric supply cable for damage or aging before
winding cable for storage. Do not repair a damaged
cable, replace it with a new one. Use only genuine
replacement cable.
5
10. Always wind cable carefully, avoiding kinking.
11. Never carry the product by the cable.
12. Never pull on the cable to disconnect any of the plugs.
13. Use only on AC mains supply voltage shown on the
product rating label.
14. Our products are double insulated to EN60335. Under
no circumstances should an earth be connected to any
part of the product.
Cables
If extension cables are used, they must comply with the
minimum cross-sections in the table below:
Voltage Cable length Cross section
220-240V/ 50Hz Up to 20 m 1.5 mm
2
220-240V/ 50Hz 20 - 50 m 2.5 mm
2
Mains cables and extensions are available from your local
Approved Service Centre.
Only use extension cables speciîš¿cally designed for
outdoor use and which conform to one of the following
speciîš¿cations: Ordinary rubber (60245 IEC 53), Ordinary
PVC (60227 IEC 53) or Ordinary PCP (60245 IEC 57).
If the short connection lead is damaged, it must be
replaced by the manufacturer, its service agent or similarly
qualiîš¿ed persons in order to avoid a hazard.
Preparation
1. While using your product always wear substantial
footwear and long trousers. Do not operate the
equipment when barefoot or wearing open sandals.
Make sure the lawn is clear of sticks, stones, bones,
wire and debris; they could be thrown by the blade.
2. Before using the machine and after any impact, check
for signs of wear or damage and repair as necessary.
3. Replace worn or damaged blades together with their
îš¿xings in sets to preserve balance.
Use
1. Use the product only in daylight or good artiîš¿cial light.
2. Avoid operating your product in wet grass, where
feasible.
3. Take care in wet grass, you may lose your footing.
4. On slopes, be extra careful of your footing and wear
non-slip footwear.
5. Operate your product across the face of slopes, never
up and down.
6. Exercise extreme caution when changing direction on
slopes. Walk never run.
7. Make sure you always take up a safe and stable
stance whilst working, especially on slopes. Do not
use the mower close to swimming pools or garden
ponds.
8. Do not walk backwards when operating, you could trip.
9. Never cut grass by pulling the product towards you.
10. Switch off before pushing the product over surfaces
other than grass.
11. Never operate the product with damaged guards or
without guards in place.
12. Keep hands and feet away from the cutting means at
all times and especially when switching on the motor.
13. Do not tilt product when the motor is running.
14. Do not put hands near the grass discharge chute.
15. Never pick up or carry a product when it is operating
or still connected to the mains supply.
16. Remove the plug from the mains:
17. before leaving the product unattended for any period.
18. before clearing a blockage.
19. before checking, cleaning or working on the appliance.
20. if you hit an object. Do not use your product until you
are sure that the entire product is in a safe operating
condition.
21. if the product starts to vibrate abnormally. Check
immediately. Excessive vibration can cause injury.
Maintenance and storage
aCAUTION! Do not touch rotating blade(s).
1. Keep all nuts, bolts and screws tight to be sure the
product is in safe working condition.
2. Check the grassbox frequently for wear or
deterioration.
3. Replace worn or damaged parts for safety.
4. Only use the replacement parts speciîš¿ed for this
product.
5. Be careful during adjustment of the product to prevent
entrapment of the îš¿ngers between moving blades and
îš¿xed parts of the machine.
6. Store in a cool dry place and out of reach of children.
Do not store outdoors.
7. Allow the product to cool for at least 30 minutes before
storing.
ASSEMBLY INSTRUCTIONS
Fitting the lower handles to your lawnmower
(A)
1. Place the end of the lower handle into the slots.
2. Secure lower handles to hood by îš¿rmly pushing îš¿xing
pin through holes in hood and handle.
3. Repeat on the other side.
NOTE: Should a problem occur when securing handle
to hood with the îš¿xing pin, carefully lever îš¿xing pin
out of location and repeat steps 1 to 3 above.
Fitting upper handles to lower handles (B)
1. Ensure the upper handle is located correctly with the
lock-off button on the switchbox uppermost.
2. Ensure the upper handle and the lower handle are
aligned correctly.
3. Insert the nut into the handle knob. (if applicable)
4. Fit the bolts, washers and handle knobs.
Cable clips
1. Fit the cable to the handles with the clips provided.
2. Make sure the cable is not trapped between the upper
and lower handles.
6


Product specificaties

Merk: Flymo
Categorie: Grasmaaier
Model: Hover Vac 250

Heb je hulp nodig?

Als je hulp nodig hebt met Flymo Hover Vac 250 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Grasmaaier Flymo

Handleiding Grasmaaier

Nieuwste handleidingen voor Grasmaaier

Anova

Anova MTC620 Handleiding

22 December 2024
Anova

Anova MC100 Handleiding

22 December 2024
Anova

Anova CC146T Handleiding

20 December 2024
Anova

Anova E60BC Handleiding

20 December 2024
Anova

Anova CC151T Handleiding

20 December 2024
Gude

Gude 320/20-4 Handleiding

19 December 2024
Zipper

Zipper ZI-MOS4T Handleiding

19 December 2024
Ozito

Ozito CPM-300C Handleiding

10 December 2024
Powerblade

Powerblade 350CX Handleiding

10 December 2024
Powerblade

Powerblade V475 Handleiding

10 December 2024