Extech SDL500 Handleiding
Extech
Multimeter
SDL500
Lees hieronder de 📖 handleiding in het Nederlandse voor Extech SDL500 (12 pagina's) in de categorie Multimeter. Deze handleiding was nuttig voor 41 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/12
User Manual
Hygro-Thermometer / Datalogger
Model SDL500
Additional ManualUser Translationsavailable at www.extech.com
2 SDL500-en-GB_1.4 11/16
Introduction
Congratulations on your purchase of the Extech SDL500 Hygro-Thermometer, an SD Logger Series
meter. This meter displays and stores Temperature and Relative Humidity readings from the
supplied probe and Temperature readings from an optional Type J or K Thermocouple probe. WET
BULB and DEW POINT temperature calculations can also be displayed. Logged data readings are
stored on an SD card for transfer to a PC. This meter is shipped fully tested and calibrated and, with
proper use, will provide years of reliable service.
Meter Description
1. Optional Thermocouple Input jack
2. Supplied Relative Humidity / Temperature Probe input jack
3. LCD Display
4. Power ON-OFF key
5. HOLD and Backlight key
6. MAX-MIN key
7. Up arrow â–² key
8. SET and Clock key
9. Down arrow â–¼ / FUNCTION key
10. ENTER and LOG key
11. PC interface jack
12. Reset Button
13. Power Adaptor jack
14. SD card slot
15. Temperature and Humidity sensors
Notes: Items 11 – 13 are located behind the snap-off compartment cover on meter’s right side.
Battery compartment, tilt stand, and tripod mount are located on the rear of the instrument
3 SDL500-en-GB_1.4 11/16
Getting Started
Power ON-OFF
ï‚· Power the meter by pressing and holding the power button for at least 1.5 seconds.
ï‚· Press and hold the power button for at least 1.5 seconds to power OFF the meter.
 This meter is powered by six (6) 1.5VDC ‘AA’ batteries or by optional AC adaptor. If the meter
will not switch ON please check that fresh batteries are installed in the rear battery compartment
or, in the case of the AC adaptor, check that the adaptor is connected correctly to the meter and
to an AC source.
Connecting the Supplied Relative Humidity/Temperature Probe
The supplied RH/Temperature Probe uses a keyed DIN-style plug to connect to the meter.
 Connect the supplied probe to the top right of the meter in the DIN jack labeled ‘Probe Input’.
 Press and hold the FUNCTION button until the ‘RH’ display icon appears. Release the button
when this ‘RH’ display icon appears. The RH reading in % are now on the upper, larger LCD
digits and Temperature in degrees ‘C’ or ‘F’ are now on the lower, smaller LCD digits.
ï‚· Use the Setup Mode to further configure the meter.
Connecting an optional Thermocouple Sensor
The SDL500 accepts an optional Type ‘J’ or Type ‘K’ Thermocouple Temperature sensor.
1. Connect a thermocouple to the sub-miniature jack at the top left of the meter labeled
‘Thermocouple Temp. Probe’.
2. Press and hold the FUNCTION button until the ‘TP’ display icon appears. Release the button
when this ‘TP’ display icon appears. The thermocouple reading in degrees ‘C’ or ‘F’ is now on
the LCD. The thermocouple type (‘J’ or K’) and the unit of measure are also displayed.
3. Use the Setup Mode to further configure the meter.
IMPORTANT SAFETY NOTE: The SDL500 can measure and display temperature up to 1300
o
C
(2372
o
F), however, thermocouple ratings vary widely; ensure that the thermocouple being used
is rated accordingly for the temperature being measured.
If an attempt is made to measure temperatures higher than the thermocouple’s rating, damage
to the thermocouple and the meter can result. If measurements are made outside the range of a
thermocouple personal injury is also possible.
Product specificaties
| Merk: | Extech |
| Categorie: | Multimeter |
| Model: | SDL500 |
Heb je hulp nodig?
Als je hulp nodig hebt met Extech SDL500 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Multimeter Extech
27 November 2023
27 November 2023
27 November 2023
27 November 2023
10 Juni 2023
10 Juni 2023
10 Juni 2023
10 Juni 2023
7 Juni 2023
7 Juni 2023
Handleiding Multimeter
- Multimeter Abus
- Multimeter Aldi
- Multimeter Alecto
- Multimeter Altai
- Multimeter Amiko
- Multimeter Amprobe
- Multimeter Appa
- Multimeter Basetech
- Multimeter Beha-Amprobe
- Multimeter Benning
- Multimeter Brandson
- Multimeter Brennenstuhl
- Multimeter Bruder Mannesmann
- Multimeter Digitus
- Multimeter Elma
- Multimeter Elro
- Multimeter Ferm
- Multimeter Flir
- Multimeter Fluke
- Multimeter Gembird
- Multimeter Gossen Metrawatt
- Multimeter Greenlee
- Multimeter Hager
- Multimeter Hubinont
- Multimeter Ideal
- Multimeter Keithley
- Multimeter Kingcraft
- Multimeter Laserliner
- Multimeter Mastech
- Multimeter Maxwell
- Multimeter Megger
- Multimeter Metrel
- Multimeter Metrix
- Multimeter Micronta
- Multimeter Milwaukee
- Multimeter Monacor
- Multimeter Parkside
- Multimeter PCE Instruments
- Multimeter Perel
- Multimeter Plieger
- Multimeter Powerfix
- Multimeter Profile
- Multimeter Sanwa
- Multimeter Schneider
- Multimeter Silverline
- Multimeter Skandia
- Multimeter Stanley
- Multimeter TFA
- Multimeter Topcraft
- Multimeter Uni-T
- Multimeter Velleman
- Multimeter Voltcraft
- Multimeter Wiha
- Multimeter Workzone
- Multimeter Joy-it
- Multimeter Jung
- Multimeter Clas Ohlson
- Multimeter Steren
- Multimeter Klein Tools
- Multimeter EMOS
- Multimeter Tacklife
- Multimeter Biltema
- Multimeter REV
- Multimeter Etekcity
- Multimeter Testo
- Multimeter Somogyi
- Multimeter Testboy
- Multimeter Yato
- Multimeter Wago
- Multimeter GW Instek
- Multimeter Kyoritsu
- Multimeter Owon
- Multimeter Projecta
- Multimeter Cablexpert
- Multimeter Högert
- Multimeter Multimetrix
- Multimeter Digi-tool
- Multimeter Kewtech
- Multimeter Sonel
- Multimeter Testec
- Multimeter Vimar
- Multimeter Strex
- Multimeter PeakTech
- Multimeter MBS
- Multimeter MGL Avionics
- Multimeter Rigol
- Multimeter Chauvin Arnoux
- Multimeter Aim TTi
- Multimeter CEM
- Multimeter Horex
- Multimeter Cosinus
- Multimeter Kurth Electronic
- Multimeter Weltron
- Multimeter Rohde & Schwarz
- Multimeter EEVBlog
- Multimeter Weidmüller
- Multimeter HT Instruments
- Multimeter Caltek
- Multimeter Elworks
- Multimeter Qian
- Multimeter Bearware
- Multimeter Noyafa
Nieuwste handleidingen voor Multimeter
17 November 2024
14 November 2024
11 November 2024
22 Oktober 2024
16 Oktober 2024
16 Oktober 2024
16 Oktober 2024
16 Oktober 2024
16 Oktober 2024
30 September 2024