Electrolux EWS202DX-DWE Handleiding

Electrolux Ketel & boiler EWS202DX-DWE

Lees hieronder de 📖 handleiding in het Nederlandse voor Electrolux EWS202DX-DWE (30 pagina's) in de categorie Ketel & boiler. Deze handleiding was nuttig voor 46 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/30
Máy t c nóng gián ti pắm nướ ế
Tài li ng d n s dệu hướ ng
Dành cho m u máy: EWS202DX-DWM
EWS202DX-DWE
1
TABLE OF CONTENTS
General Remark
The installation and maintenance has to be carried out by qualied professionals or authorized
technicians.
The manufacturer shall held responsible for damage malfunction caused not be any or by
wrong installation or failing to comply with following instructions included in this pamphlet.
For more detailed installation and maintenance guidelines, please refer to below chapters.
TITLE PAGE
1.Cautions ...........................................................................................................................(2)
2.Product introduction .........................................................................................................(3)
3.Unit installation .................................................................................................................(6)
4.Methods of using ..............................................................................................................(8)
5.Maintenance ...................................................................................................................(12)
6.Troubleshooting ..............................................................................................................(13)
2
Before installing this water heater,check and conrm that the earthing on the supply socket is
reliably grounded. Otherwise, the electrical water heater can not be installed and used. Do not
use extension boards. Incorrect installation and use of this electrical water heater may result in
serious injuries and loss of property.
Special Cautions
The supply socket must be earthed reliably. The rated current of the socket shall not be lower
than 16A. The socket and plug shall be kept dry to prevent electrical leakage.
The installation height of the supply socket shall not be lower than 1.8m.
The wall in which the electrical water heater is installed shall be able to bear the load more than
two times of the heater lled fully with water without distortion and cracks. Otherwise, other
strengthening measures shall be adopted.
The pressure relief valve attached with the heater must installed be at the cold water inlet this of
heater(see Fig.1), make sure and it is not exposed in the foggy. The water may be outowed from
pressure relief valve, so the outow pipe must open wide in the air; The pressure relief valve
need to be checked and cleaned regularly, so as to make sure it will not be blocked.
Thread screw
Drain handle
Pressure release hole
(Fig.1)
When using the heater for the rst time(or the rst use after maintenance), the heater can not be
switched on until it has been lled fully with water. When lling the water, at least one of the outlet
valves at the outlet of the heater must be opened to exhaust the air. This valve can be closed
after the heater has been lled fully with water.
The water heater intended for use persons(including children)with reduced physical,is not by
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instructions concerning use of the appliance by a person responsible for
their safety. Children should be supervised to ensure that they do not play with the heater.
During heating, there may water dripping from the pressure release hole thebe drops of of
pressure relief valve. This is a normal phenomenon. If there is a large amount of water leak,
please contact customer care center for repair. This pressure release hole shall, under no
circumstances, be blocked; otherwise, the heater may be damaged, even resulting in accidents.
The drainage pipe connected to the pressure release hole must be kept sloping downwards.
Since the water temperature inside the heater can reach up to 75, the hot water must not be
exposed human bodies when initially used. Adjust the water temperature a suitableto it is to
temperature to avoid scalding.
If the exible power supply cord is damaged, the special supply cord provided by the manufacturer
must be selected, and replaced by the professional maintenance personnel.
1. CAUTIONS
Pressure relief valve
Hot water
Cold water


Product specificaties

Merk: Electrolux
Categorie: Ketel & boiler
Model: EWS202DX-DWE

Heb je hulp nodig?

Als je hulp nodig hebt met Electrolux EWS202DX-DWE stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Ketel & boiler Electrolux

Handleiding Ketel & boiler

Nieuwste handleidingen voor Ketel & boiler