Durkopp Adler 467 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Durkopp Adler 467 (31 pagina's) in de categorie Naaimachine. Deze handleiding was nuttig voor 48 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/31
467
Spe zial näh ma schi ne
Ser vi ce an lei tung
Ser vi ce in struc tions
Post fach 17 03 51, D-33703 Bie le feld Pots da mer Stra ße 190, D-33719 Bie le feld
Te le fon +49 (0) 521 / 9 25-00 Te le fax +49 (0) 521 / 9 25 24 35 www.du er kopp-ad ler.com
Aus ga be/Edi ti on: 03/1984 Tei le-Nr./Part-No.: 0791 467651
D
GB
General safety instructions
The non-observance of the following safety instructions can cause
bodily injuries or damages to the machine.
1. The machine must only be commissioned in full knowledge of the
instruction book and operated by persons with appropriate
training.
2. Before putting into service also read the safety rules and
instructions of the motor supplier.
3. The machine must be used only for the purpose intended. Use of
the machine without the safety devices is not permitted. Observe
all the relevant safety regulations.
4. When gauge parts are exchanged (e.g. needle, presser foot,
needle plate, feed dog and bobbin) when threading, when the
workplace is left, and during service work, the machine must be
disconnected from the mains by switching off the master switch or
disconnecting the mains plug.
5. Daily servicing work must be carried out only by appropriately
trained persons.
6. Repairs, conversion and special maintenance work must only be
carried out by technicians or persons with appropriate training.
7. For service or repair work on pneumatic systems, disconnect the
machine from the compressed air supply system (max. 7-10 bar).
Before disconnecting, reduce the pressure of the maintenance
unit.
Exceptions to this are only adjustments and functions checks
made by appropriately trained technicians.
8. Work on the electrical equipment must be carried out only by
electricians or appropriately trained persons.
9. Work on parts and systems under electric current is not permitted,
except as specified in regulations DIN VDE 0105.
10. Conversion or changes to the machine must be authorized by us
and made only in adherence to all safety regulations.
11. For repairs, only replacement parts approved by us must be used.
12. Commissioning of the sewing head is prohibited until such time
as the entire sewing unit is found to comply with EC directives.


Product specificaties

Merk: Durkopp Adler
Categorie: Naaimachine
Model: 467

Heb je hulp nodig?

Als je hulp nodig hebt met Durkopp Adler 467 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Naaimachine Durkopp Adler

Handleiding Naaimachine

Nieuwste handleidingen voor Naaimachine