Dimplex DTT20 Handleiding
Lees hieronder de 📖 handleiding in het Nederlandse voor Dimplex DTT20 (4 pagina's) in de categorie Openhaard. Deze handleiding was nuttig voor 51 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/4
08/50625/0 (UK) Issue 0
The product complies with the European Safety Standards EN60335-2-30 and the European Standard Electromagnetic Compatibility (EMC)
EN55014, EN60555-2, EN60555-3. These cover the essential requirements of EEC Directives 2006/95/EC and 2004/108/EC.
DETROIT
123
I
I
I
II
II
II
II
II
IIII
1
4
32
5
424
536
A
B
670
614
229
Detroit
IMPORTANT : THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
Important Safety Advice
When using electrical appliances, basic precautions should
always be followed to reduce the risk of fire, electrical shock,
and injury to persons, including the following:
If the appliance is damaged, check with the supplier before
installation and operation.
Do not use outdoors.
Do not use in the immediate surroundings of a bath, shower or
swimming pool.
Do not locate the heater immediately below a fixed socket outlet
or connection box.
Do not cover the heater. Do not place material or garments on
the heater, or obstruct the air circulation around the heater, for
instance by curtains or furniture, as this could cause
overheating and a fire risk.
This appliance is not intended for use by children or other
persons without assistance or supervision if their physical,
sensory or mental capabilities prevent them from using it safely.
Children should be supervised to ensure that they do not play
with the appliance.
Do not use this heater in series with a thermal control, a program
controller, a timer or any other device that switches on the heat
automatically, since a fire risk exists when the heater is
accidentally covered or displaced.
Ensure that furniture, curtains or other combustible material
are positioned no closer than 1 metre from the heater.
In the event of a fault unplug the heater.
Unplug the heater when not required for long periods.
Although this heater complies with safety standards, we do
not recommend its use on deep pile carpets or on long hair
type of rugs.
The appliance must be positioned so that the plug is accessible.
If the supply cord is damaged it must be replaced by the
manufacturer or service agent or a similarly qualified person
in order to avoid a hazard.
Keep the supply cord away from the front of the heater.
General
Unpack the heater carefully and retain the packaging for possible future
use, in the event of moving or returning the fire to your supplier. Loose
coals and pebbles are packed separately within the carton. When the
heater is assembled the coals or pebbles are placed on top of the fuel
bed up to a maximum weight of 6kg.
The fire incorporates a flame effect, which can be used with or without
heating, so that the comforting effect may be enjoyed at any time of the
year. Using the flame effect on its own only requires little electricity.
These models are designed to be free standing and are normally
positioned against a wall.
Before connecting the heater check that the supply voltage is the same
as that stated on the heater.
Please note: Used in an environment where background noise is very
low, it may be possible to hear a sound which is related to the operation
of the flame effect. This is normal and should not be a cause for
concern.
Electrical connection
WARNING – THIS APPLIANCE MUST BE EARTHED.
This heater must be used on an AC ~ supply only and the voltage marked
on the heater must correspond to the supply voltage.
Before switching on, please read the safety warnings and operating
Instructions.
Controls - see
Fig. 2
Three switches provide a choice of heat settings. A switch is in the ON
position when the side with the markings on (i.e. I I, , or II) is pushed in.
Switch 1 (I) Controls the electricity supply to the heater and flame
effect.
Note: This switch must be in the ON (I) position for
heater to operate with or without heat.
Switch 2 (I) Provides 1kW heat output
Switch 3 (II) Provides 2kW heat output with switch 2
Thermal Safety Cut-out
A thermal safety cut-out is incorporated in the heater to prevent damage
due to overheating. This can happen if the heat outlet was restricted in
any way. The heater will switch on once the obstruction has been
removed and the heater has cooled. If the cut-out continues to operate
intermittently, the heater should be switched off and a service agent
contacted.
Maintenance
WARNING: ALWAYS DISCONNECT FROM THE POWER SUPPLY
BEFORE ATTEMPTING ANY MAINTENANCE.
Lamp Replacement - see Fig.’s 3, 4 & 5
There are two lamps located beneath the fuel effect. To gain access to
the lamps, remove the coal/pebbles and place in a container. Remove
the front fret/fuel effect from the fire by lifting it up and out from the
slots on the fire - see Fig. 3.
Remove the rotisserie by carefully sliding the rubber connecter off the
motor shaft - see Fig. 4.
Remove the defective lamp by unscrewing it as shown in Fig. 5.
Replace with a 60W E14 SES Clear Candle lamp. Take care not to
over-tighten the lamp.
Refit the front fret/fuel effect and replace the coal/pebbles.
Recycling
For electrical products sold within the European
Community.
At the end of the electrical products useful life it should
not be disposed of with household waste. Please
recycle where facilities exist. Check with your Local
Authority or retailer for recycling advice in your country.
Cleaning
WARNING – ALWAYS DISCONNECT FROM THE POWER SUPPLY
BEFORE CLEANING THE HEATER.
For general cleaning use a soft clean duster – never use abrasive
cleaners. The glass viewing screen should be cleaned carefully with a
soft cloth. DO NOT use proprietary glass cleaners.
To remove any accumulation of dust or fluff the soft brush attachment of
a vacuum cleaner should occasionally be used to clean the outlet grille
of the fan heater.
After Sales Service
Your product is guaranteed for one year from the date of purchase.
Within this period, we undertake to repair or exchange this product
free of charge (
excluding lamps & subject to availability
) provided it
has been installed and operated in accordance with these instructions.
Your rights under this guarantee are additional to your statutory rights,
which in turn are not affected by this guarantee.
Should you require after sales information or assistance with this
product please go to www.dimplex.co.uk where you will find our
self help guide by clicking on ‘After Sales’ or ring our help desk on 0845
600 5111 (UK) or 01 842 4833 (R.O.I).
Spare parts are also available on the website www.dimplex.co.uk
Please retain your receipt as proof of purchase.
Product specificaties
| Merk: | Dimplex |
| Categorie: | Openhaard |
| Model: | DTT20 |
Heb je hulp nodig?
Als je hulp nodig hebt met Dimplex DTT20 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Openhaard Dimplex
19 Augustus 2023
19 Augustus 2023
18 Augustus 2023
5 Juli 2023
5 Juli 2023
3 Juli 2023
3 Juli 2023
2 Juli 2023
6 Juni 2023
1 Juni 2023
Handleiding Openhaard
- Openhaard Quigg
- Openhaard Ambiano
- Openhaard Blumfeldt
- Openhaard Bomann
- Openhaard Brixton
- Openhaard Domo
- Openhaard Dovre
- Openhaard Edilkamin
- Openhaard Einhell
- Openhaard Element4
- Openhaard Eurom
- Openhaard EWT
- Openhaard Faber
- Openhaard Firefriend
- Openhaard Hwam
- Openhaard Invicta
- Openhaard Klarstein
- Openhaard La Nordica
- Openhaard Manor House
- Openhaard Napoleon
- Openhaard Norsk Kleber
- Openhaard Qlima
- Openhaard Russell Hobbs
- Openhaard Silvercrest
- Openhaard Smeg
- Openhaard Spartherm
- Openhaard Sylvania
- Openhaard Taurus
- Openhaard Tristar
- Openhaard Wamsler
- Openhaard Well Straler
- Openhaard Jotul
- Openhaard Olsberg
- Openhaard Orbegozo
- Openhaard Scarlett
- Openhaard Cotech
- Openhaard Fieldmann
- Openhaard Ardes
- Openhaard Bimar
- Openhaard Lasko
- Openhaard Lund
- Openhaard Furrion
- Openhaard Deville
- Openhaard Euromac
- Openhaard Haas+Sohn
- Openhaard Uniflame
- Openhaard Eligent
- Openhaard Blue Rhino
- Openhaard Amantii
- Openhaard Planika
Nieuwste handleidingen voor Openhaard
10 December 2024
10 December 2024
9 December 2024
15 November 2024
30 September 2024
30 September 2024
30 September 2024
30 September 2024
30 September 2024
5 September 2024