Digital Watchdog DWC-B1362TIR650 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Digital Watchdog DWC-B1362TIR650 (2 pagina's) in de categorie Bewakingscamera. Deze handleiding was nuttig voor 29 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/2
B1362TIR650
About manual
INSTRUCTION MANUAL
5436 W Crenshaw Street
Tampa, FL 33634
www.digital-watchdog.com
Technical Support : 1-866-446-3595 / 813-888-9555
Do not open or modify
Do not open the case except during maintenance and
installation, as it may be dangerous and cause damages.
Do not put objects inside the unit
Make sure that no metal objects or flammable substances
get inside the camera. It could cause fire, short-circuits or
damages.
Be careful when handling the unit
To prevent damage, do not drop the camera or subject it to
strong shock or vibration.
Install away from electric or magnetic fields
Protect from humidity and dust
Protect from high temperature
Be careful when installing close to the ceiling , in a kitchen
or boiler room, as the temperature may rise to high levels.
Cleaning
Dirt can be removed from the case only by wiping it with
a soft cloth moistened with a soft detergent solution.
Mounting Surface
The mounting surface material must be strong enough to
support the camera.
Before installing and using the camera, please read this
manual carefully.
Be sure to keep it handy for future reference.
DIMENSION (mm)
WARRANTY INFORMATION
PRECAUTIONS
Digital Watchdog (referred to as “the Warrantor”) warrants
the Camera Series against defects in materials or
workmanship as follows:
LABOR: For the initial five
(
5
)
y
ears from the date of ori
g
inal
LIMITS AND EXCLUSIONS
There are no express warranties except as listed above.
The Warrantor will not be liable for incidental or
consequential damages (including, without limitation,
dama
g
e to recordin
g
media
)
resultin
g
from the use of
Before sending the camera out for repair, check the
items below. If the problem persists after checking
these items, contact your service center.
If no image appears.
Is the coaxial cable attached securely?
Are the power and voltage normal?
Has the iris of the lens inside the camera been
adjusted correctly (with the level volume) ?
Is there adequate illumination?
If the image is unclear
Is the lens in focus?
Is the lens dirty?
Dirt of fingerprints on the lens can adversely
affect the images.
Gently wipe any dirt or fingerprints off the lens
with a soft cloth or lens cleaning paper and cleaning
fluid (commercially available).
Is the monitor adjusted correctly?
TROUBLESHOOTING
5436 W Crenshaw Street
Tampa, FL 33634
www.digital-watchdog.com
Technical Support : 1-866-446-3595 / 813-888-9555
Do not open or modify
Do not open the case except during maintenance and
installation, as it may be dangerous and cause damages.
Do not put objects inside the unit
Make sure that no metal objects or flammable substances
get inside the camera. It could cause fire, short-circuits or
damages.
Be careful when handling the unit
To prevent damage, do not drop the camera or subject it to
strong shock or vibration.
Install away from electric or magnetic fields
Protect from humidity and dust
Protect from high temperature
Be careful when installing close to the ceiling , in a kitchen
or boiler room, as the temperature may rise to high levels.
Cleaning
Dirt can be removed from the case only by wiping it with
a soft cloth moistened with a soft detergent solution.
Mounting Surface
The mounting surface material must be strong enough to
support the camera.
Before installing and using the camera, please read this
manual carefully.
Be sure to keep it handy for future reference.
DIMENSION (mm)
WARRANTY INFORMATION
PRECAUTIONS
Digital Watchdog (referred to as “the Warrantor”) warrants
the Camera Series against defects in materials or
workmanship as follows:
LABOR: For the initial five (5) years from the date of original
purchase, if the camera is determined to be defective, the
Warrantor will repair or replace the unit, with
new or refurbished product at its option, at no charge.
PARTS: In addition, the Warrantor will supply replacement
parts for the initial five (5) years. To obtain warranty or out
of warranty service, please contact a Technical Support
Representative at 1-866-446-3595 Monday through Friday
from 8:30 AM to 5:30 PM Eastern Standard Time.
A purchase receipt or other proof of the date of the original
purchase is required before warranty service is rendered.
This warranty only covers failures due to defects in
materials and workmanship which arise during normal use.
This warranty does not cover damage which occurs in
shipment or failures which are caused by products not
supplied by the Warrantor or failures which result from
accident, misuse, abuse, neglect, mishandling,
misapplication, alteration, modification, faulty installation,
set-up adjustments, improper antenna, inadequate signal
pickup, maladjustment of consumer controls, improper
operation, power line surge, improper voltage supply,
lightning damage, rental use of the product or service by
anyone other than an authorized repair facility or damage
that is attributable to acts of God.
LIMITS AND EXCLUSIONS
There are no express warranties except as listed above.
The Warrantor will not be liable for incidental or
consequential damages (including, without limitation,
damage to recording media) resulting from the use of
these products, or arising out of any breach of the
warranty. All express and implied warranties, including
the warranties of merchantability and fitness for
particular purpose, are limited to the applicable warranty
period set forth above.
Some states do not allow the exclusion or limitation of
incidental or consequential damages, or limitations on
how long an implied warranty lasts, so the above
exclusions or limitations may not apply to you.
This warranty gives you specific legal rights and you may
also have other rights that vary from state to state.
If the problem is not handled to your satisfaction, then
write to the Address above.
Service calls which do not involve defective materials or
workmanship as determined by the Warrantor, in its sole
discretion, are not covered. Costs of such service calls
are the responsibility of the purchaser.
Before sending the camera out for repair, check the
items below. If the problem persists after checking
these items, contact your service center.
If no image appears.
Is the coaxial cable attached securely?
Are the power and voltage normal?
Has the iris of the lens inside the camera been
adjusted correctly (with the level volume) ?
Is there adequate illumination?
If the image is unclear
Is the lens in focus?
Is the lens dirty?
Dirt of fingerprints on the lens can adversely
affect the images.
Gently wipe any dirt or fingerprints off the lens
with a soft cloth or lens cleaning paper and cleaning
fluid (commercially available).
Is the monitor adjusted correctly?
WARNING:
TO PREVENT THE RISK OF FIRE OR
ELECTRIC SHOCK, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE.
TROUBLESHOOTING
HME (Highlight Masking Exposure)
IFC (Intensity Fallout Compensation)
DRC (Dynamic Range Compressor)
CAMERA SETTINGS CONNECTION
ATTENTION
1. Do not rotate more than 360˚.
2. Do not twist many times unnecessarily.
CAUTION :
Check for polarity when using a DC 12V / AC 24V.
CAMERA SETING ANGLE
When a roomcontainingbrightlights is imaged,autoexposurecalculationsusually
result in imagesthataremostlyunderexposedexceptforthelights.WithHighlight
MaskingExposure,verybrightlightsaremaskedfromtheexposurecalculation
producingresultsthathave a higherdynamicrangeofintensities.
CCTVlensesproduce a nonuniformintensity     across the field of view of the camera.
Withtheautomaticnonuniformitycorrectionfeatureturnedon,thecameranormalizes
forthe the the theradiometricfallouttowards edgeof image.As a result, imageryhas
auniformilluminationovertheentirefield of view.
Thecamera'sintegratedDSPextendsthedynamicrangeoftheimagebyautomatically
adjustingthedarkerareas areas.ofscenesthatalsohavebright UnliketraditionalBLC
thatadjusts andthe theimageas a whole, DSPselects processesmanysmallregions
foroptimumdynamicrangescaling.
CAMERA SETTINGS
CONTROL BOARD & LENS ADJUSTMENT
CONNECTION
ATTENTION
1. Do not rotate more than 360˚.
2. Do not twist many times unnecessarily.
CAUTION :
Check for polarity when using a DC 12V / AC 24V.
CAMERA SETING ANGLE
1. Rotate Zoom lever with the supplied Allen key.
2. Rotate Focus lever with the supplied Allen key.
Video Test Output
Connector
OSD controller
FUNCTIONAL OF CONTROL BOARD
[1]Functional control of O.S.D(On Screen Display)
[2]Functional of VIDEO OUT(2ND)
1 2
When a roomcontainingbrightlights is imaged,autoexposurecalculationsusually
result in imagesthataremostlyunderexposedexceptforthelights.WithHighlight
MaskingExposure,verybrightlightsaremaskedfromtheexposurecalculation
producingresultsthathave a higherdynamicrangeofintensities.
CCTVlensesproduce a nonuniformintensityacrossthefield of view  of the camera.
Withtheautomaticnonuniformitycorrectionfeatureturnedon,thecameranormalizes
forthe the the theradiometricfallouttowards edgeof image.As a result, imageryhas
auniformilluminationovertheentirefield of view.
Thecamera'sintegratedDSPextendsthedynamic   range of the image by automatically
adjustingthedarkerareas areas.ofscenesthatalsohavebright UnliketraditionalBLC
thatadjusts andthe theimageas a whole, DSPselects processesmanysmallregions
foroptimumdynamicrangescaling.


Product specificaties

Merk: Digital Watchdog
Categorie: Bewakingscamera
Model: DWC-B1362TIR650

Heb je hulp nodig?

Als je hulp nodig hebt met Digital Watchdog DWC-B1362TIR650 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Bewakingscamera Digital Watchdog

Handleiding Bewakingscamera

Nieuwste handleidingen voor Bewakingscamera