Delonghi Steel Elite HVS3032 Handleiding

Delonghi Heater Steel Elite HVS3032

Lees hieronder de 📖 handleiding in het Nederlandse voor Delonghi Steel Elite HVS3032 (2 pagina's) in de categorie Heater. Deze handleiding was nuttig voor 40 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/2
6
ELECTRICAL CONNECTION
- Before plugging into the mains, make sure the voltage of your mains supply corresponds to
the value in Volts (V) indicated on the appliance and that the socket and power line are appro-
priate for the load required.
- THIS APPLIANCE COMPLIES WITH DIRECTIVE 2004/108/EC ON ELECTROMAGNETIC COMPATI-
BILITY.
INSTALLATION
The appliance must be used in the portable configuration only.
- If the appliance is used in the bathroom, respect the safety distances shown in fig. 1 and
always position it away from taps, basins, showers, etc.
The appliance must not be placed immediately under a fixed power socket.
FUNCTIONING AND USE
Make sure the appliance is off before plugging into the mains.
1. Plug the appliance into the mains. The light comes on.
2. Turn the thermostat lever to maximum.
3. turn the function selector to the position.Summer mode (fan only):
4. Low power operation: turn the function selector to position 1(in models with two fan
speeds, the fan operates at minimum).
5. Medium power operation: turn the function selector to position 2(in models with two fan
speeds, the fan operates at maximum).
6. High power operation: turn the function selector to position 3(the fan operates at maxi-
mum).
7. Switching off: turn the function selector to the "0" position.
Note: In models with two power levels, position 2 corresponds to maximum power.
Setting the thermostat
Position the thermostat on maximum. When the room has reached the required temperature,
turn the thermostat lever slowly clockwise until you hear a click and the fan goes off
The thermostat will then keep room temperature at the selected level automatically.
Frost prevention mode
With the function selector in position 3 and the thermostat lever in position , the appliance
maintains room temperature at about 5°C, preventing freezing with minimal energy consump-
tion.
MAINTENANCE
- Always unplug from the mains socket before cleaning.
- Clean the air intake and outlet grilles regularly.
- Do not use abrasive products or solvents to clean the appliance.
IMPORTANT
- The appliance is designed and produced for domestic use only.
- Do not use this appliance near showers, baths, swimming pools, etc.
- Always use the heater in an upright position.
- Do not cover the appliance when in operation to avoid the risk of fire.
- Do not use the heater to dry laundry. Never obstruct the intake and outlet grilles (danger of
overheating).
- The appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
Children must be supervised to ensure they do not play with the appliance.
- The heater must be positioned at least 50 cm from furniture, walls, curtains, or other objects.
EN
7
- The appliance must not be placed near walls, furniture, curtains etc.
- The use of extension leads is not recommended.
However if they cannot be avoided, follow the instructions accompanying the extension lead
and never exceed the power limit marked on the extension.
- If the supply cord is damaged, it must be replaced by the manufacturer, its service agent in
order to avoid a hazard.
- Do not use the appliance in rooms measuring less than 4 m2.
- When used for the first time, the appliance may give off an odour. This is caused by heating.
You are recommended to ventilate the room.
A tip over safety device turns the appliance off if it falls over or is positioned inappropriately
in such a way as to jeopardise safety. To restart the appliance, simply place it upright again.
The heater is fitted with a thermal cutout device which switches the heater off in case of
accidental overheating (eg. obstruction of air intake and outlet grilles, motor turning slowly or
not at all).
To reset, unplug the appliance from the mains socket for a few minutes, remove the cause of
overheating then plug in again.
CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cutout, this
appliance must not be powered through an external switching device such as a timer, or connec-
ted to a circuit that is regularly switched on and off by the power provider.
IMPORTANT: Never under any circumstances cover the appliance during operation as this
would lead to dangerous overheating of the appliance.
IMPORTANTImportant information for correct disposal of the product in accordance with
EC Directive 2002/96/EC.
At the end of its working life, the product must not be disposed of as urban waste. It
must be taken to a special local authority differentiated waste collection centre or to a
dealer providing this service. Disposing of a household appliance separately avoids
possible negative consequences for the environment and health deriving from inap-
propriate disposal and enables the constituent materials to be recovered to obtain
significant savings in energy and resources.As a reminder of the need to dispose of
household appliances separately, the product is marked with a crossed-out wheeled
dustbin.


Product specificaties

Merk: Delonghi
Categorie: Heater
Model: Steel Elite HVS3032

Heb je hulp nodig?

Als je hulp nodig hebt met Delonghi Steel Elite HVS3032 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Heater Delonghi

Handleiding Heater

Nieuwste handleidingen voor Heater