Dell Latitude C610 Handleiding

Dell Laptop Latitude C610

Lees hieronder de 📖 handleiding in het Nederlandse voor Dell Latitude C610 (47 pagina's) in de categorie Laptop. Deze handleiding was nuttig voor 14 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/47
Dell Latitude C610/C510 Service Manual
le:///C|/Work%20Area%20-%20A/E%20DOC%20Posting/latc610/service%20manual/index.htm[2/1/2013 11:00:41 AM]
Dell™ Latitude™ C610/C510 Service Manual
Before You Begin
System Components
Hard Drive
Memory Modules, Mini PCI Card, and Modem
Keyboard
Display Assembly, Display Latch, and Hinge Covers
Palm Rest
Microprocessor Thermal Cooling Assembly
Microprocessor Module
Hybrid Cooling Fan
Reserve Battery
Flashing the BIOS
Speaker Assemblies
System Board
Battery and Module Bay Latches
Pin Assignments for I/O Connectors
Notes, Notices, and Cautions
NOTE: A NOTE indicates important information that helps you make better use of your computer.
NOTICE: A NOTICE indicates either potential damage to hardware or loss of data and tells you how to avoid the
problem.
CAUTION: A CAUTION indicates a potential for property damage, personal injury, or death.
Information in this document is subject to change without notice.
© 2002 Dell Computer Corporation. All rights reserved.
Reproduction in any manner whatsoever without the written permission of Dell Computer Corporation is strictly forbidden.
Trademarks used in this text: , the logo, and are trademarks of Dell Computer Corporation; is a registered trademark ofDell DELL Latitude Intel
Intel Corporation; and are registered trademarks of Microsoft Corporation.Microsoft Windows
Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their products.
Dell Computer Corporation disclaims any proprietary interest in trademarks and trade names other than its own.
January 2002 Rev. A01
Before You Begin: Dell Latitude C610/C510 Service Manual
le:///C|/Work%20Area%20-%20A/E%20DOC%20Posting/latc610/service%20manual/begin.htm[2/1/2013 11:00:42 AM]
Back to Contents Page
Before You Begin
Dell™ Latitude™ C610/C510 Service Manual
Preparing to Work Inside the Computer
Recommended Tools
Screw Identication
Preparing to Work Inside the Computer
CAUTION: Before working inside your computer, read "Safety and EMC Instructions: Portable Computers"
in your System Information Guide.
NOTICE: Only a certied service technician should perform repairs on your computer. Damage due to servicing that is
not authorized by Dell is not covered by your warranty.
NOTICE: To avoid damaging the computer, perform the following steps before you begin working inside the computer.
1. Make sure that the work surface is clean to prevent scratching the computer cover.
2. Save any work in progress and close all open programs.
3. Turn o the computer and all attached devices.
NOTE: Make sure the computer is turned o and not in suspend-to-disk or hibernate mode. If you cannot shut
down the computer using the computer operating system, press and hold the power button for 4 seconds.
4. Make sure the computer is undocked.
5. Disconnect the computer from the electrical outlet.
6. To avoid possible damage to the system board, wait 10 to 20 seconds and then disconnect any attached devices.
7. Disconnect all other external cables from the computer.
8. Remove any installed PC Cards or plastic blanks from the PC Card slot.
9. Close the display and turn the computer upside down on a at work surface.
NOTICE: To avoid damaging the system board, you must remove the main battery and secondary battery (if present)
before you service the computer.
10. Remove the primary battery from the battery bay and the secondary battery from the module bay, if a secondary
battery is in use.
11. Remove any installed device in the module bay.
12. To dissipate any static electricity while you work, use a wrist grounding strap or periodically touch an unpainted metal
surface.
13. Handle components and cards with care. Do not touch the components or contacts on a card. Hold a card by it edges
or by its metal mounting bracket. Hold a component such as a microprocessor by its edges, not by its pins.
Recommended Tools
Before You Begin: Dell Latitude C610/C510 Service Manual
le:///C|/Work%20Area%20-%20A/E%20DOC%20Posting/latc610/service%20manual/begin.htm[2/1/2013 11:00:42 AM]
The procedures in this manual require the following tools:
#1 magnetized Phillips screwdriver
¼-inch at-blade screwdriver
Small plastic scribe
Microprocessor extractor
Flash BIOS update program oppy disk or CD
Computer Orientation
1 back
2 right
3 front
4 left
Screw Identication
When you are removing and replacing components, photocopy the placemat as a tool to lay out and keep track of the screws.
The placemat provides the number of screws and their sizes.
Screw Identication


Product specificaties

Merk: Dell
Categorie: Laptop
Model: Latitude C610

Heb je hulp nodig?

Als je hulp nodig hebt met Dell Latitude C610 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Laptop Dell

Handleiding Laptop

Nieuwste handleidingen voor Laptop