Definitive Technology CS-8060HD Handleiding

Definitive Technology Speaker CS-8060HD

Lees hieronder de 📖 handleiding in het Nederlandse voor Definitive Technology CS-8060HD (12 pagina's) in de categorie Speaker. Deze handleiding was nuttig voor 43 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/12
Definitive Technology
CS-8060HD & CS-8080HD OWNER’S MANUAL
CS-8000HD Series Center Channels:
CS-8060HD, CS-8080HD
Thank you for choosing the Definitive Technology CS Series Center Loudspeaker.
The CS Series is a compact high-definition loudspeaker system designed for use in
audio/video systems of the highest quality. Because of its wide range, high-power
handling and articulate clarity, it is ideal for use as a center channel in a high-
performing home theater system.
Our engineers have spent many years in developing this product. In order to ensure
that you experience the finest performance possible, we encourage you to take a
moment to fully read this owner’s manual and familiarize yourself with the proper
installation and setup procedures for your CS speaker.
CS-8060HD
CS-8080HD
Definitive Technology
2
CS-8060HD & CS-8080HD
OWNER’S MANUAL
Power Supply
1. The fuse and power disconnect device are located on the back of the speaker.
2. The disconnect device is the power cord, detachable at either the speaker or
the wall.
3. The power cord must be disconnected from the speaker before servicing.
Figure 2 – Wiring and Polarity
Receiver/Amplifier
+
-
Strip 1/4" (6mm) wire. Identify markings on wire and assign +/-.
Ensure that the speaker is always connected to
the receiver or amplifier + to + and – to –.
1. Unscrew binding post and insert wire.
2. Tighten until wire is secure.
1
2
Unpacking Your Model
Please Inspect For Shipping Damage
Each loudspeaker leaves our plant in perfect condition. Any visible or concealed
damage most likely occurred in handling after it left our plant and should be
reported at once to your Definitive dealer or the delivery company that
delivered your loudspeaker. Please unpack your system carefully. Save all cartons
and packing materials in case you move or need to ship your system. Record the
serial number found on the back of the Center Channel in the Notes section of
this owner's manual.
Safety Precautions
Safety Precautions
CAUTION! To reduce the risk of electric shock and fire, do not remove the
cover or back plate of this device. There are no user serviceable parts inside.
Please refer all servicing to licensed service technicians. Avis: Risque de choc
electricque, ne pas ouvrir.
CAUTION! The international symbol of a lightning bolt inside a triangle is
intended to alert the user to uninsulated “dangerous voltage” within the
device’s enclosure. The international symbol of an exclamation point inside
a triangle is intended to aler the user to the presence of important operat-t
ing, maintenance and servicing information in the manual accompanying
the device.
CAUTION! To prevent electrical shock, match wide blade of plug to wide
slot, fully insert. Attention: Pour eviter les chocs electriques, introduire la
lame la plus large de la fiche dans la borne correspondante de la prise et
pousser jusqu'au fond.
CAUTION! To reduce the risk of electrical shock, do not expose this equip-
ment to rain or moisture.
1. Read Instructions—All safety and operating instructions should be read
before operating the device.
2. Retain Instructions—The safety and operating instructions should be
retained for future reference.
3. Heed Warnings—All warnings on the device and in the operating
instructions should be adhered to.
4. Follow Instructions—All operating and safety instructions should be
followed.
5. Water & Moisture—The device should never be used in, on or near
water for risk of fatal shock.
6. Carts & Stands—The device should only be used on carts or stands rec-
ommended by the manufacturer.
7. Wall & Ceiling Mounting—The device should be mounted on a wall or
ceiling only as recommended by the manufacturer.
8. Ventilation—The device should always be located in such a way that it
maintains proper ventilation.
It should never be placed in a built-in installation or anywhere that
may impede the flow of air through its heat sink.
9. Heat—Never locate the device near heat sources such as radiators, floor
registers, stoves or other heat-generating devices.
10. Power Supply—The device should only be connected to a power supply
of the type described in the operating instructions or as marked on the
device.
11. Power Cord Protection—Power cables should be routed so they are not
likely to be stepped on or crushed by items placed on them or against
them. Special attention should be paid to areas where the plug enters a
socket or fused strip and where the cord exits the device.
12. Cleaning—The device should be cleaned in accordance with manufac-
turer’s instructions.
13. Periods Of Non-Use—The device should be unplugged when not being
used for extended periods.
14. Dangerous Entry—Care should be taken that no foreign objects or
liquids fall or are spilled inside the device.
15. Damage Requiring Service—The device should be serviced by licensed
technicians when:
• The plug or power supply cord has been damaged.
• Objects have fallen on or liquid has spilled inside the device.
• The device has been exposed to moisture.
• The device does not appear to be operating properly or exhibits a
marked change in performance.
• The device has been dropped or the cabinet becomes damaged.
16. Service—The device should always be serviced by licensed technicians.
Only replacement parts specified by the manufacturer should be used.
The use of unauthorized substitutions may result in fire, shock, or other
hazards.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Positioning Your Speakers
Your new CS Series speaker is designed to add clarity and focus to the vocal range
and extend the musical image of your home theater. To optimize its performance,
please follow these simple guidelines. Although the following recommendations
will usually yield the best results, whatever sounds best to you is correct.
Figure 1 – Positioning CS Series Center Channel
Connecting Your Speakers
above
or
below
To receive the full benefit of the bass radiators built into your CS Speaker leave at
least 1–2" (2.5–5 cm) of space between the top of the speaker and any surface.
A center channel
Speaker should
be placed as
close to the
center of your
television as
possible without
obstructing
your view.
1–2"
(2.5–5 cm)
↔
↔
↔
↔
↔
www.DefinitiveTech.com
Technical Assistance
It is our pleasure to offer assistance if you have any questions regarding your
Center Channel or its setup, please contact your nearest Definitive Technology
dealer or call us directly at (800) 228-7148 (US & Canada), 01 (410) 363-7148
(all other countries) or e-mail info@definitivetech.com.
Technical support is
offered in English only.
Service
Service and warranty work on your Definitive loudspeakers will normally be
performed by your local Definitive Technology dealer. If, however, you wish to
return the speaker to us, please contact us first, describing the problem and
requesting authorization as well as the location of the nearest factory service
center. Please note that the address given in this booklet is the address
of our offices only. Under no circumstances should loudspeakers be
shipped to our offices or returned without contacting us first and
obtaining return authorization.
Definitive Technology Offices
11433 Cronridge Drive, Owings Mills, Maryland 21117
Phone: (800) 228-7148 (US & Canada),
01 (410) 363-7148 (all other countries)
Powering the Active Subwoofer
Your CS Speaker contains a built-in, powered woofer designed to extend the
frequency response and dynamic range of the center channel. Do not connect
the Low Level input to your receiver’s LFE output. The CS speakers are not
designed to be a dedicated subwoofer.
Your CS speaker must be plugged into an electrical socket of the appropriate
voltage (as indicated on the back of your unit) using the electrical cord which
you have attached to the back of the speaker. When powering up from being
unplugged, the LED on the amplifier panel will flash for 30 seconds while the
firmware is loading. The CS Speaker has a special circuit which automatically
turns the powered woofer section on when a signal is fed to the loudspeaker and
does not require an on-off switch. The LED on the back panel will light up when
a signal is sensed and the amplifier turns on. After the cessation of a signal, it
may take up to an hour for the amplifier to actually turn off. In some instances,
because of stray radio signals (RF) in your area, the LED may not turn off.
However, this is nothing to be concerned about as the amplifier draws little
power when at idle.
Setting Your Speakers’ Low-Frequency Level
Control
Your CS Speaker has a bass level control which
allows you to tune the output level of the
woofer to match your room and personal
listening preferences. Please note that there
are no controls to vary the crossover points
or phase because these have been
factory-calibrated and set to provide perfect
blending. We suggest beginning with the level
control set at approximately 12 o’clock.
Troubleshooting
If you experience any difficulties with your CS Center Channel loudspeaker, try
the suggestions below. If you still have problems, contact your Definitive
Technology Authorized Dealer for assistance.
1. Audible distortion when the speaker is playing at loud levels is caused
by turning up your receiver or amplifier louder than the receiver or the
speaker is capable of playing. Most receivers and amplifiers put out their
full-rated power well before the volume control is turned all the way up, so
the position of the volume control is a poor indicator of its power limit. If
your speakers distort when you play them loud, turn the volume down!
2. If you experience a lack of bass, it is likely that one speaker is out of phase
(polarity) with the other speakers in the system and needs to be rewired with
closer attention to connecting positive to positive and negative to negative
on both channels. Most speaker wire has some indicator (such as color-
coding, ribbing or writing) on one of the two conductors to help you main-
tain consistency. It is essential to connect both speakers to the amplifier in
the same way (in phase).
3. Make sure all your system interconnects and power cords are solidly in place.
4. Should you hear hum or noise coming from your speakers, try plugging
the speakers’ power cords into a different AC circuit than your amplifier.
5. The system has sophisticated inter cuitrnal protection cir y. If for some
reason the protection circuitry trips, turn off your system and wait five
minutes before trying the system again. If the speakers’ built-in amplifier
should over-heat, the system will turn off until the amplifier cools down
and resets.
6. Check to be sure that your power cord has not been damaged.
7. Check that no foreign objects or liquid has entered the speaker cabinet.
8. If you cannot get the subwoofer driver to turn on or if comes out no sound
and you are sure the system is set up properly, please bring the loudspeaker
to your Definitive Technology Authorized Dealer for assistance; call first.
L R C SL SR SC
Min Max Low
Level
L R C
SL LFE SR
Pre-Out
Speakers-Out
Optional
Receiver/Amplifier
Figure 3 – Connection Option 1 and Connection Option 2
Use the manual speaker setup functions in your receiver to set speaker
configuration, speaker distance and channel balance. Consult your receiver’s or
processor’s manual to learn how to access and use the setup menus. Set center
speaker as “Large.”
Speaker Setup:
Large
Min Max
VERY IMPORTANT:
Do not use your receiver’s auto set-up functions as they are
often ineffective in setting up and adjusting speakers with built-
in powered subwoofers!
All Dolby/DTS multi-channel receiver/amplifiers feature a dedicated channel for a center
speaker. Consult your receiver's owner's manual for the appropriate connection procedure.
3

Product specificaties

Merk: Definitive Technology
Categorie: Speaker
Model: CS-8060HD

Heb je hulp nodig?

Als je hulp nodig hebt met Definitive Technology CS-8060HD stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Speaker Definitive Technology

Definitive Technology

Definitive Technology Dymension Outdoor BL-650 Handleiding

7 December 2024
Definitive Technology

Definitive Technology Dymension Outdoor BL-550 Handleiding

7 December 2024
Definitive Technology

Definitive Technology UIW 64/A Handleiding

16 November 2024
Definitive Technology

Definitive Technology Dymension Outdoor AW-550 Handleiding

12 November 2024
Definitive Technology

Definitive Technology Dymension DW-45 MAX Handleiding

27 Augustus 2024
Definitive Technology

Definitive Technology Dymension DW-65 MAX Handleiding

27 Augustus 2024
Definitive Technology

Definitive Technology Dymension DW-65 PRO Handleiding

27 Augustus 2024
Definitive Technology

Definitive Technology Dymension DC-80 MAX SUR Handleiding

27 Augustus 2024
Definitive Technology

Definitive Technology Mythos LCR-75 Handleiding

30 Juli 2024
Definitive Technology

Definitive Technology Mythos LCR-85 Handleiding

30 Juli 2024

Handleiding Speaker

Nieuwste handleidingen voor Speaker

Kanto

Kanto REN Handleiding

11 December 2024
Phonic

Phonic JUBI 12A LITE Handleiding

11 December 2024
Phonic

Phonic aSK215 Handleiding

11 December 2024
Phonic

Phonic iSK 8 Deluxe Handleiding

11 December 2024
Phonic

Phonic SAFARI 1000 LITE Handleiding

11 December 2024
Phonic

Phonic SAFARI 2000P Handleiding

11 December 2024
Phonic

Phonic iSK 15 Handleiding

11 December 2024
Phonic

Phonic JUBI 12 Handleiding

11 December 2024
Pro-Ject

Pro-Ject Speaker Box 3E Carbon Handleiding

11 December 2024
MB

MB PESSPROVS32A Handleiding

11 December 2024