De Dietrich DHG377XP1 Handleiding

De Dietrich Afzuigkap DHG377XP1

Lees hieronder de 📖 handleiding in het Nederlandse voor De Dietrich DHG377XP1 (9 pagina's) in de categorie Afzuigkap. Deze handleiding was nuttig voor 46 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/9

Guide d’utilisation

Instructions for installation and use

Montage- und gebrauchsanweisung

Istruzioni per l'installazione e l’uso

Instrucciones para instalación y uso

Instruções de instalação y utilização

Aanwijzing voor gebruik en installatie

DHG316XP - DHG356XP

DHG376XP - DHG377XP - DHG386XP

IMPORTANT; BEFORE ANY OPERATION OF INSTALLATION AND USE, TAKE NOTE OF THE

FOLLOWING INSTRUCTIONS:

The distance between the supporting surface for the cooking vessels on the hob and the lower part of the hood must be at least 65

cm. If the instructions for installation for the hob specify a greater distance, this has to be taken into account.

The air collected must not be conveyed into a duct used to blow off smokes from appliances fed with an energy other than electricity

(central heating systems, thermosiphons, water-heaters, etc.).

Comply with the official instructions provided by the competent authorities in merit when installing the disposal duct. In addition,

exhaust air should not be discharged into a wall cavity, unless the cavity is designed for that purpose.

The room must be well aerated in case a hood and some other heat equipment fed with an energy other than electricity (gas, oil,

coal heaters, etc) operate at the same time.

In fact the intake hood, disposing of air, could create a vacuum in the room. The vacuum should not exceed 0,04mbar. This prevents

the gas exhausted by the heat source from being intaken again. It is therefore advisable to ensure the room contains air taps able

to ensure a steady flow of fresh air.

Check the data label inside the appliance; if the symbol ( ) is printed, read the following: this appliance has such technical

particulars that it belongs to class II insulation, therefore it must not be earthed.

The following warning is valid in the United Kingdom only: in case your cable is not furnished with a plug, read the following

instructions; as the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying

the terminals in your plug, proceed as follows: – the wire which is coloured blue must be connected to the terminal which is marked

with the letter N or coloured black; – the wire which is coloured brown must be connected to the terminal which is marked with the

letter L or coloured red. – terminal of a three-pin plug.

Check the data label inside the appliance; if the symbol ( ) is NOT printed, read the following: ATTENTION: This appliance must

be earthed. When making the electrical connections, check that the current socket has a ground connection.

The following warning is valid in the United Kingdom only: in case your cable is not furnished with a plug, read the following

instructions; as the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying

the terminals in your plug, proceed as follows: – the wire which is coloured green and yellow must be connected to the terminal in

the plug which is marked with the letter E or by the earth symbol [ ], or coloured green or green and yellow; – the wire which is

coloured blue must be connected to the terminal which is marked with the letter N or coloured black; – the wire which is coloured

brown must be connected to the terminal which is marked with the letter L or coloured red.

When making the electrical connections, check that the voltage values correspond to those indicated on the data plate inside the

appliance itself. In case your appliance is not furnished with a non separating flexible cable and has no plug, or has not got any other

device ensuring omnipolar disconnection from the electricity main, with a contact opening distance of at least 3 mm, such separating

device ensuring disconnection from the main must be included in the fixed installation. If your unit features a power lead and plug,

position this so the plug is accessible.

Always switch off the electricity supply before carrying out any cleaning or servicing operations on the appliance.

ATTENTION: This appliance must be grounded.

USE

Avoid using materials which could cause spurts of flame (flambées) near the appliance.

When frying, take particular care to prevent oil and grease from catching fire. Already used oil is especially dangerous in this respect.

Do not use uncovered electric grates.

To avoid possible risks of fire always comply with the indicated instructions when cleaning anti-grease filters and when removing

grease deposits from the appliance.

MAINTENANCE

Thorough servicing guarantees correct and long-lasting operation.

Any fat deposits should be removed from the appliance periodically depending on amount of use (at least every 2 months). Avoid

using abrasive or corrosive products. To clean painted appliances on the outside, use a cloth dipped in lukewarm water and neutral

detergent. To clean steel, copper or brass appliances on the outside, it is always best to use specific products, following the

instructions on the products themselves. To clean the inside of the appliance, use a cloth (or brush) dipped in denatured ethyl

alcohol.

ENGLISH

DESCRIPTION OF THE APPLIANCE

The description and characteristics shown in this document are for information only and not obligatory. Indeed, we reserve the

right to carry out any modification or improvement of the quality of certain of our products without prior notice. .

As with all hoods, these apparatuses can be installed in either filtering version or duction version.

In the Filtering version (Fig. 1), the air and vapours conveyed by the appliance are depurated by charcoal filter and recirculated

around the room. ATTENTION: Using the hood as a filtering one it is necessary to use the charcoal filters that purifies the air sent

back into the room.

In the Ducting version (Fig. 2), cooking vapours and odours are conveyed straight outside by a disposal duct which passes

through the wall/ceiling. Use of charcoal filters is therefore unnecessary.

Decide at the beginning which type of installation to adopt.

Your apparatus is supplied in the filtering version so that if you want to install the apparatus in the duction version you must remove

the carbon filters.

This apparatus conforms to the 16.08.89 regulation relating to the limitation of radio-electric disturbances (EC Directive n./6.889

modified by the EC Directive 8/.308.).

INSTALLATION

It is advisable to entrust the installation operations to specialised personnel.

Installation in filtering version

To facilitate installation, before starting remove the grease filter/s: press inward on the clamp at the handle and pull the

filter downward (Fig. 3).

Cut a hole in the bottom of the pensile cupboard in order to settle the appliance (Fig. 4).

Install the wiring system.

Insert the appliance in the hole (Fig. 4)

Tighten the 2 screws inside the appliance (Fig. 5) until it fits snug on the bottom of the wall unit. Avoid tightening the two screws

with excessive force.

To the air venting flange of the apparatus connect a proper pipe that can convey the air to the upper part of the pensile cupboard.

Make the electrical connection of the hood by means of the power supply cable.

Fig. 1 Fig. 2

Fig. 3a

Fig. 4

Fig. 3b

MODELS A

DHG386XP

DHG316XP

DHG356XP

DHG376XP

DHG377XP 677.5mm

497mm

Product specificaties

Merk:	De Dietrich
Categorie:	Afzuigkap
Model:	DHG377XP1
Soort bediening:	Knoppen
Kleur van het product:	Roestvrijstaal
Gewicht:	10000 g
Breedte:	700 mm
Diepte:	285 mm
Hoogte:	304 mm
Geluidsniveau:	39 dB
Gewicht verpakking:	11600 g
Soort:	Inbouw
Maximale afzuigcapaciteit:	900 m³/uur
Afzuigmethode:	Afvoerend/recirculerend
Aantal lampen:	2 gloeilamp(en)
Type lamp:	Halogeen
Soort vetfilter:	Metaal
Vermogen lamp:	20 W
Stroomvoorziening:	220 - 240 V, 50 Hz, 13 A
Aantal snelheden:	4
Afmetingen verpakking (BxDxH):	795 x 325 x 325 mm