Crestron Aspire IC5-W-T Handleiding

Crestron Speaker Aspire IC5-W-T

Lees hieronder de đź“– handleiding in het Nederlandse voor Crestron Aspire IC5-W-T (2 pagina's) in de categorie Speaker. Deze handleiding was nuttig voor 38 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/2
QUICKSTART DOC. 7390B (2034590) 12.12
Aspire™ In-Ceiling Speakers
quickstart guide
IC5, IC6, IC8
www.crestron.com
Specifications subject to
change without notice.
IC5, IC6, IC8
Mount/Remove Speakers
The in-ceiling speakers include three toggle clamps that simplify the mounting process. If the
grilles are mounted on the speakers, remove them before proceeding. (Refer to “Install/Remove
Grilles”, below.)
1. Connect the speaker cable wires to the spring terminals by pressing the top of the terminals
down and inserting the exposed strands into the hole. Make sure that the wires go to the +
+ – – (red coded) terminals, and the wires go to the (black coded) terminals.
2. With the toggle clamps turned inward, insert the speaker into the opening. As the three
screws on the front of the speaker are tightened, the toggle clamps first rotate into clamping
position (refer to the figure to the right) and then begin holding the speaker to the ceiling.
Tighten the screws until the speaker is secured; do not overtighten.
3. Speaker removal is accomplished by reversing the procedures given in steps 1 and 2
above.
a. Loosen the front screws to unclamp the speaker. Continue to loosen the screws until
the toggle clamps rotate inward.
b. When the speaker is loose, carefully remove it from the opening.
c. Disconnect the wires from the terminals.
Install/Remove Grilles
The zero-bezel frameless grilles are held in place by powerful magnets. To remove the grilles,
grip the edges and pull away from the speaker.
Paint the Speaker Grilles
Speaker grille painting should be done prior to mounting.
1. Carefully remove the material on the underside of the grilles and set them aside for
reinstallation. It may be necessary to use a knife or other sharp instrument to free an
edge of the material so it can be peeled away. Use care to avoid cutting or tearing the
material.
2. Dry brush or lightly spray the surface to be painted. Use care to avoid clogging the
holes in the grilles.
3. Once the paint is dry, reinstall the material to the underside.
1
1
The product of expert Crestron® audio engineering,
Aspire™ speakers deliver high-end performance for
demanding residential installations. Select materials and
a refined appearance underscore the meticulous design
behind each model. The result is a complete line of
in-wall and in-ceiling speakers worthy of a place in every
room of the finest custom home.
The Aspire line strikes a perfect balance between
performance and price, delivering pristine, impactful
sound quality, with minimal impact on your décor thanks
to paintable zero-bezel grilles.
Rear View (Typical)
Front View (Typical)
Install Cables
Run the cables from the audio source to each speaker location following all appropriate
local codes. Strip the ends of the speaker cable wires 1/4” to 1/2” (6 mm to 12 mm) and
twist the exposed strands.
1Installation
Determine Placement In Room
90°
Prepare Mounting Holes
Speaker placement is largely a matter of personal preference. However, placing the speaker
near a corner or wall will extend its low frequency response.
Before finalizing the speaker location, check to make sure there are no fixtures, pipes, air
ducts, joists, or other possible obstructions. Use a good quality stud finder to locate joists.
If there is no access to the area above the ceiling, and it is uncertain that there are no
obstructions, carefully drill a small hole just through the ceiling near the middle of the proposed
speaker location(s) and use one of the commercially available inspection devices designed for
this purpose, or do one of the following:
● Use a piece of stiff wire, bent into an “L” shape, with one end long enough to explore an
area equal to the size of the speaker with the toggle clamps extended. Insert the wire into
the hole, make sure it rotates freely in a complete circle and that there is sufficient depth,
or
● Use a drywall saw to cut a small hole at a 45° angle toward the inside of the hole. An
angle cut simplifies repair since the removed piece can be reinserted to help plug the hole.
If there are no obstructions, use the supplied template to trace outlines of the mounting holes
on the ceiling. Cut the final mounting holes at a 90° angle to the ceiling.
Tighten
Screws
Spring
Terminals (2)
Toggle
Clamps (3)
45°
Aspire™ In-Ceiling Speakers
quickstart guide
IC5, IC6, IC8
www.crestron.com
Specifications subject to
change without notice.
IC5, IC6, IC8
Specifications
QUICKSTART DOC. 7390B (2034590) 12.12
2
2
Side and Rear Views (Typical)
The specific patents that cover Crestron products are listed at patents.crestron.com.
Crestron, the Crestron logo, and Aspire are either trademarks or registered trademarks of Crestron Electronics,
Inc. in the United States and/or other countries. Other trademarks, registered trademarks, and trade names may
be used in this document to refer to either the entities claiming the marks and names or their products. Crestron
disclaims proprietary interest in the marks and names of others.
©2012 Crestron Electronics, Inc.
Features & Performance
Woofer1
Tweeter2
Crossovers
Crossover Frequency
Environmental
Temperature
Humidity
Dimensions3
Diameter
Depth
Minimum Mounting Depth
Recommended Cutout
Diameter
IC5, IC6, IC8 Specifications
Impedence
Frequency Response
Frequency Range
Power Handling
Sensitivity
Construction
Baffle
Grille
Mounting
8 Ω nominal
55 Hz - 20 kHz (±3 dB)
45 Hz to 20 kHz (-10 dB)
100 watts program
88.0 dB @ (W/m)
IC5
8.30 in (211 mm)
3.98 in (101 mm)
3.79 in (97 mm)
7.40 in (188 mm)
ABS plastic, black
Steel with textured finish, paintable, magnetically held zero bezel frameless
Flush ceiling mount using three integral spring-loaded toggle clamps, 1.35 in (34 mm)
maximum surface thickness
41° to 104° F (5° to 40° C)
10% to 90% RH (non-condensing)
For indoor use only
Connections
Input
Maximum Wire Size
(2) spring terminals
10 AWG
IC6 IC8
5.25 in (134 mm)
0.98 in (25 mm)
4th order hybrid
2.5 kHz
1. Woven poly-glass composite with rubber surround, vented pole piece and steel basket
2. Advanced synthetic polymer dome, ferrofluid cooling, offset post mounted
3. Dimensions shown are per speaker
8 Ω nominal
53 Hz - 20 kHz (±3 dB)
45 Hz to 20 kHz (-10 dB)
125 watts program
89.5 dB @ (W/m)
6.50 in (165 mm)
0.98 in (25 mm)
4th order hybrid
2.5 kHz
8 Ω nominal
48 Hz - 20 kHz (±3 dB)
40 Hz to 20 kHz (-10 dB)
150 watts program
89.5 dB @ (W/m)
8.00 in (203 mm)
0.98 in (25 mm)
4th order hybrid
2.5 kHz
Weight33.72 lb (1.7 kg)
Available Models
Available Accessories
Aspire 5.25” 2-Way
In-Ceiling Speaker, Pair,
White Textured
ASPIRE IC5-W-T
SPKA-NCTP-IC500
New-Construction
Speaker Templates
9.28 in (236 mm)
4.40 in (112 mm)
4.21 in (107 mm)
8.40 in (214 mm)
3.44 lb (2.1 kg)
Aspire 6.5” 2-Way
In-Ceiling Speaker, Pair,
White Textured
ASPIRE IC6-W-T
SPKA-NCTP-IC600
New-Construction
Speaker Templates
11.64 in (296 mm)
4.66 in (119 mm)
4.47 in (114 mm)
10.80 in (275 mm)
6.05 lb (2.8 kg)
Aspire 8” 2-Way
In-Ceiling Speaker, Pair,
White Textured
ASPIRE IC8-W-T
SPKA-NCTP-IC800
New-Construction
Speaker Templates
SPECIFICATION Depth
Minimum
Mounting
Depth
Diameter
Recommended
Cutout
Diameter
The following table provides corrective action for possible trouble situations.
If further assistance is required, please contact a Crestron customer service
representative.
Further Inquiries
Future Updates
TROUBLE
POSSIBLE CAUSE(S)
No sound or
intermittent
sound from
speakers.
Cable connection
error.
Verify cable connections
between amplifier and speakers.
Amplifier not receiving
input signal or amplifier
malfunction.
Verify amplifier is functioning correctly,
that it is receiving an input signal and
that correct input source is selected.
Faulty device in system. Verify all devices in system are
functioning properly.
Constant
noise such as
buzz, hum, or
hiss from
speakers.
System grounding fault. Verify system grounding.
Poor low
frequency
output.
Incorrect polarity
connection at speaker.
Verify speaker connection polarity
(+ on speaker to + on amplifier).
3Problem Solving
Troubleshooting
To locate specific information or resolve questions after reviewing this guide,
contact Crestron's True Blue Support at 1-888-CRESTRON [1-888-273-7876]
or refer to the listing of Crestron worldwide offices on the Crestron Web site
(www.crestron.com/offices) for assistance within a particular geographic region.
To post a question about Crestron products, log onto the Online Help section of
the Crestron Web site (www.crestron.com/onlinehelp).
First-time users must
establish a user account to fully benefit from all available features.
As Crestron improves functions, adds new features and extends the
capabilities of the Aspire IC5, IC6, and IC8, additional information may
be made available as manual updates. These updates are solely electronic
and serve as intermediary supplements prior to the release of a complete
technical documentation revision.
Check the Crestron Web site periodically for manual update avail
ability and
its relevance. Updates are identified as an “Addendum” in the Download
column.
CORRECTIVE ACTION

Product specificaties

Merk: Crestron
Categorie: Speaker
Model: Aspire IC5-W-T

Heb je hulp nodig?

Als je hulp nodig hebt met Crestron Aspire IC5-W-T stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Speaker Crestron

Crestron

Crestron ULTIMATE IC3-SA-WOOFER Handleiding

27 December 2023
Crestron

Crestron ULTIMATE IC3-AW-SA-BOX-WOOFER Handleiding

27 December 2023
Crestron

Crestron ULTIMATE IC3-AW-SA-TWEETER Handleiding

27 December 2023
Crestron

Crestron ULTIMATE IWS82-AW-W-T-EACH Handleiding

6 September 2023
Crestron

Crestron ULTIMATE IWLCR62-W-T-EACH Handleiding

6 September 2023
Crestron

Crestron SAROS IC8T-W-T-EACH Handleiding

30 Augustus 2023
Crestron

Crestron ULTIMATE ICS8-AW-W-T-EACH Handleiding

30 Augustus 2023
Crestron

Crestron ULTIMATE IC8-DT-AW-W-T-EACH Handleiding

30 Augustus 2023
Crestron

Crestron SAROS ICT5T-22 Handleiding

30 Augustus 2023
Crestron

Crestron ULTIMATE IC6-AW-W-T-EACH Handleiding

30 Augustus 2023

Handleiding Speaker

Nieuwste handleidingen voor Speaker

Sven

Sven MC-5 Handleiding

20 December 2024
Sven

Sven SPS-535 Handleiding

20 December 2024
Devialet

Devialet Mania Deep Handleiding

19 December 2024
Kicker

Kicker Premium 51MSC65 Handleiding

18 December 2024
Kicker

Kicker Premium 51MSC8 Handleiding

18 December 2024
Monitor Audio

Monitor Audio Apex A10AV12 Handleiding

17 December 2024
Audac

Audac ATEO6M Handleiding

17 December 2024
Audac

Audac CIRA724I Handleiding

17 December 2024
NGS

NGS WILD Space 3 Handleiding

16 December 2024
HK Audio

HK Audio LINEAR 3 112 XA Handleiding

16 December 2024