Casio MTD-130 Handleiding

Casio Horloge MTD-130

Lees hieronder de 📖 handleiding in het Nederlandse voor Casio MTD-130 (4 pagina's) in de categorie Horloge. Deze handleiding was nuttig voor 9 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/4

MA2204-A

User’s Guide

Watch

5704 EN

Congratulations upon your selection of this CASIO watch.

To ensure that this watch provides you with the years of service for which it is designed,

carefully read and follow the instructions in this manual, especially the information under

“Operating Precautions” and “User Maintenance”.

Crown Operations

Some water-resistant models (10BAR, 20BAR) have a screw-in

crown. When you need to perform a crown operation, rotate

it towards you to unscrew it. Then pull the crown out. Avoid

applying undue force when pulling. The watch loses its water

resistance while the crown is unscrewed. After performing a

crown operation, fully screw the crown back in.

Crown

Loosen

If your watch has a rotary bezel...

You can rotate the bezel to align its ▼ mark with the

minute hand. Then you will be able to tell how much

time has elapsed since aligning the ▼ mark.

Start

Elapsed time

Current

Specifications

Accuracy at normal temperature

(per month) Battery type Battery life

±20 seconds Approx. 3 yearsSR920SW

Other: Low battery alert

Specifications are subject to change without notice.

• Your watch may differ somewhat from the one shown in the illustration.

Minute Hand

Hour Hand

Second Hand

Day of the week indicator

Click 2

Click 1

Crown

Day Indicator

To adjust the time setting

When the second hand is at 12 o’clock, pull

the Crown out to Click 2.

Rotate the to change the time setting.

Crown

Push the back in on a time signal to

Crown

resume timekeeping.

Note

• Take care that you set the

correct AM or PM time.

• When changing the time,

move the minute hand

four or five minutes past

your final setting, and then

back it up to the setting

you want.

To change the day indicator setting

Pull the out to Click 1.

Crown

Rotate the towards you to set the Crown

day.

Push the back in.

Crown

Note

• The day indicator setting

uses a 31-day month.

Make adjustments for

months of shorter lengths.

• Avoid changing the day

indicator setting between

the hours of 9:00 p.m.

and 4:00 a.m. Otherwise,

the day indicator may

not change correctly at

midnight.

To change the day of the week indicator

Pull the Crown out to Click 1.

Rotate the Crown away from you to set the

day of the week.

Push the Crown back in.

Note

•

Avoid changing the day of

the week indicator setting

between the hours of 9:00

p.m. and 4:00 a.m.

Low Battery Alert

•

The second hand will jump at two-second intervals to alert you when battery power is low.

•

Have the battery replaced as soon as possible after low battery alert is indicated.

• Align the arrow with the day of the week you want.

Example: THU

Operating Precautions

Water Resistance

• The information below applies to watches with WATER RESIST or WATER RESISTANT

marked on the back cover.

Water

Resistance

Under Daily

Use

Enhanced Water Resistance Under Daily

Use

Atmospheres

20

Atmospheres

Marking On watch front or on

back cover

BAR mark 5BAR 10BAR 20BAR

Example of

Daily Use

Hand washing, rain Yes Yes Yes Yes

Water-related work,

swimming No Yes Yes Yes

Windsurfing No No Yes Yes

Skin diving No No Yes Yes

•

Do not use your watch for scuba diving or other types of diving that requires air tanks.

• Watches that do not have WATER RESIST or WATER RESISTANT marked on the back

cover are not protected against the effects of sweat. Avoid using such a watch under

conditions where it will be exposed to large amounts of sweat or moisture, or to direct

splashing with water.

• Even if a watch is water resistant, note the usage precautions described below. Such

types of use reduce water resistance performance and can cause fogging of the glass.

− Do not operate the crown or buttons while your watch is submersed in water or wet.

− Avoid wearing your watch while in the bath.

− Do not wear your watch while in a heated swimming pool, sauna, or any other high

temperature/high humidity environment.

− Do not wear your watch while washing your hands or face, while doing housework, or

while performing any other task that involves soaps or detergents.

• After submersion in seawater, use plain water to rinse all salt and dirt from your watch.

• To maintain water resistance, have the gaskets of your watch replaced periodically

(about once every two or three years).

• A trained technician will inspect your watch for proper water resistance whenever you

have its battery replaced. Battery replacement requires the use of special tools. Always

request battery replacement from your original retailer or from an authorized CASIO

service center.

• Some water-resistant watches come with fashionable leather bands. Avoid swimming,

washing, or any other activity that causes direct exposure of a leather band to water.

• The inside surface of the watch glass may fog when the watch is exposed to a sudden

drop in temperature. No problem is indicated if the fogging clears up relatively quickly.

Sudden and extreme temperature changes (such as coming into an air conditioned

room in the summer and standing close to an air conditioner outlet, or leaving a heated

room in the winter and allowing your watch to come into contact with snow) can cause

it to take longer for glass fogging to clear up. If glass fogging does not clear up or if you

notice moisture inside of the glass, immediately stop using your watch and take it to

your original retailer or to an authorized CASIO service center.

• Your water-resistant watch has been tested in accordance with International

Organization for Standardization regulations.

Band

• Tightening the band too tightly can cause you to sweat and make it difficult for air

to pass under the band, which can lead to skin irritation. Do not fasten the band too

tightly. There should be enough room between the band and your wrist so you can

insert your finger.

• Deterioration, rust, and other conditions can cause the band to break or come off

of your watch, which in turn can cause band pins to fly out of position or to fall out.

This creates the risk of your watch falling from your wrist and becoming lost, and also

creates the risk of personal injury. Always take good care of your band and keep it

clean.

• Immediately stop using a band if you even notice any of the following: loss of band

flexibility, band cracks, band discoloration, band looseness, band connecting pin flying

or falling out, or any other abnormality. Take your watch to your original retailer or to

a CASIO service center for inspection and repair (for which you will be charged) or to

have the band replaced (for which you will be charged).

Temperature

• Never leave your watch on the dashboard of a car, near a heater, or in any other

location that is subject to very high temperatures. Do not leave your watch where it will

be exposed to very low temperatures. Temperature extremes can cause your watch to

lose or gain time, to stop, or otherwise malfunction.

Impact

• Your watch is designed to withstand impact incurred during normal daily use and

during light activity such as playing catch, tennis, etc. Dropping your watch or

otherwise subjecting it to strong impact, however, can lead to malfunction. Note that

watches with shock-resistant designs (G-SHOCK, BABY-G, G-MS) can be worn while

operating a chain saw or engaging in other activities that generate strong vibration, or

while engaging in strenuous sports activities (motocross, etc.)

Magnetism

• The hands of analog and combination (analog-digital) watches are moved by a motor

that uses magnetic force. When such a watch is close to a device (audio speakers,

magnetic necklace, cell phone, etc.) that emits strong magnetism, the magnetism can

cause timekeeping to slow down, speed up, or stop, resulting in the incorrect time

being displayed.

• Very strong magnetism (from medical equipment, etc.) should be avoided because it

can cause malfunction of your watch and damage to electronic components.

Electrostatic Charge

• Exposure to very strong electrostatic charge can cause your watch to display the wrong

time. Very strong electrostatic charge even can damage electronic components.

Chemicals

• Do not allow your watch to come into contact with thinner, gasoline, solvents, oils, or

fats, or with any cleaners, adhesives, paints, medicines, or cosmetics that contain such

ingredients. Doing so can cause discoloration of or damage to the resin case, resin

band, leather, and other parts.

Storage

• If you do not plan to use your watch for a long time, thoroughly wipe it free of all dirt,

sweat, and moisture, and store it in a cool, dry place.

Resin Components

• Allowing your watch to remain in contact with other items or storing it together with

other items for long periods while it is wet can cause color on resin components

to transfer to the other items, or the color of the other items to transfer to the resin

components of your watch. Be sure to dry off your watch thoroughly before storing it

and make sure it is not in contact with other items.

• Leaving your watch where it is exposed to direct sunlight (ultraviolet rays) for long

periods or failure to clean dirt from your watch for long periods can cause it to become

discolored.

• Friction caused by certain conditions (strong external force, sustained rubbing, impact,

etc.) can cause discoloration of painted components.

• If there are printed figures on the band, strong rubbing of the printed area can cause

discoloration.

• Leaving your watch wet for long periods can cause fluorescent color to fade. Wipe the

watch dry as soon as possible after it becomes wet.

• Semi-transparent resin parts can become discolored due to sweat and dirt, and if

exposed to high temperatures and humidity for long periods.

• Daily use and long-term storage of your watch can lead to deterioration, breaking,

or bending of resin components. The extent of such damage depends on usage

conditions and storage conditions.

Leather Band

• Allowing your watch to remain in contact with other items or storing it together with

other items for long periods while it is wet can cause the color of the leather band to

transfer to the other items or the color of the other items to transfer to the leather band.

Be sure to dry off your watch thoroughly with a soft cloth before storing it and make

sure it is not in contact with other items.

Product specificaties

Merk:	Casio
Categorie:	Horloge
Model:	MTD-130

Heb je hulp nodig?

Als je hulp nodig hebt met Casio MTD-130 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Horloge Casio

Casio Baby-G BGA-320 Handleiding

28 Oktober 2024

Casio G-Shock GMA-B800 Handleiding

20 September 2024

Casio G-Shock GW-9500 Handleiding

20 Augustus 2024

Casio Edifice ECB 950 Handleiding

6 Augustus 2024

Casio G-Shock GBD-800 Handleiding

21 Juli 2024

Casio G-Shock GR-B100 Handleiding

21 Juli 2024

Casio Baby-G MSG-S500 Handleiding

21 Juli 2024

Casio Edifice EFB-108 Handleiding

20 Juni 2024

Casio G-Shock GST-B600 Handleiding

24 Mei 2024

Casio G-Shock GD-B500 Handleiding

23 Mei 2024

Handleiding Horloge

Nieuwste handleidingen voor Horloge

Diesel Overflow DZ4480 Handleiding

16 November 2024

Skagen Falster Gen 4 Connected SKT5104 Handleiding

15 November 2024

Skagen Falster Gen 4 Connected SKT5103 Handleiding

15 November 2024

Skagen Falster Gen 4 Connected SKT5102 Handleiding

15 November 2024

Emporio Armani Connected Hybrid ART3023 Handleiding

15 November 2024

Emporio Armani Connected Hybrid ART3024 Handleiding

15 November 2024

Emporio Armani Connected Hybrid ART3019 Handleiding

15 November 2024

Emporio Armani Connected Handleiding

15 November 2024

Mitsubishi BN 0024 Handleiding

14 November 2024

ICE Watch Cocorico Handleiding

14 November 2024