Candy PCP700/1SDXA Handleiding

Candy Fornuis PCP700/1SDXA

Lees hieronder de 📖 handleiding in het Nederlandse voor Candy PCP700/1SDXA (7 pagina's) in de categorie Fornuis. Deze handleiding was nuttig voor 36 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/7
HOBS 70 cm
USER INSTRUCTIONS
EN
1
TECHNICAL CHARACTERISTICS
* Some models only ** Manufacturer setting
Cooking hobs 70x50
Burners 5 gas 5 gas 5 gas 5 gas 5 gas 5 gas
– – – – – –
Reference type P751 P751 P751 P752 P752 P752
Supply Voltage (V/Hz) 230/50 230/50 230/50 230/50 230/50 230/50
Installed electric power (W) – – – – – –
Medium burner 1 1 1 1 1 1
Large burner 2 2 2 2 2 2
Small burner 1 1 1 1 1 1
Double ring burner 1 – – 1 – –
Maxi burner – 1 – – 1 –
Fish burner – – 1 – – 1
Power of gas installed:
- Natural gas 1,0 kPa (MJ/H)** 40,5 40,5 40,5 40,5 40,5 40,5
- LPG gas 2,75 kPa (MJ/H) 37,4 37,4 37,4 37,4 37,4 37,4
Electric ignition* yes yes yes yes yes yes
Gas safety device – – – yes yes yes
Product size mm. 695x510 695x510 695x510 695x510 695x510 695x510
Degree protection – – – – – –
Class 3 3 3 3 3 3
Fig. 1
2
INSTALLATION
The Purchaser is responsible for the installation of the hob. The Manufacturer does not
accept any responsibility for any damage or loss resulting from incorrect installation,
and as such this will not covered by the Manufacturer’s Guarantee.
The hob may be installed in any worktop which is heat resistant to a temperature of
100° C, and has a thickness of 25 - 40 mm. The dimensions of the insert to be cut out
of the worktop are in shown in Fig. 1.
If the Hob is fitted next to a cabinet on either side,
the distance between the Hob and the cabinet
must be at least 150 mm (see Fig. 2); while the
distance between the hob and the rear wall must
be at least 55 mm.
If below the hob there is an accessible space,
there must be a partition panel in insulating mate-
rial (wood or similar) providing a space of at least
10 mm below the Hob (see Fig. 2).
The Hob unit is fitted by attaching the Fixing
Clamps supplied, using the holes at the base of
the unit.
VERY IMPORTANT - APPLYING THE SEALANT
Important - The diagram below shows how the sealant should be applied.
This appliance has been designed for non-professional, i.e. domestic, use.
Appropriate checks and tests have ensured that, even in the most extreme conditions,
the temperatures reached are within acceptable limits. The Hob is thermally insula-
ted (in line with Regulation EN) and may be installed: next to panels higher than
the worktop, for type «Y», or next to panels not higher than the worktop for type
«X». See technical characteristics table «Degree of protection».
Fig. 2
Partition panel
150 mm
min.
30 mm
10 mm
3
Instructions for the installer
Suitable location
A gas-powered cooking appliance produces heat
and himidity in the area in which it is installed. For
this reason you should ensure good ventilation either
by keeping all natural air passages open or by in-
stalling an extractor hood with an ehaust flue (Fig.
3-4). Intensive and prolonged use of the appliance
may require extra ventilation, such the opening of
a window or an increase in speed of the electric fan,
if you have one.
If your appliance is not fitted with a thermocouple
(safety device) the ventilation hole shown in Fig. 3
should be at least 200 cm2.
Fig. 3
If a hood cannot be installed, an electric fan
should be fitted to an outside wall or window as
long there are air vents in the area.
The electric fan should be able to carry out a com-
plete change of air in the kitchen 3-5 times every
hour.
The installer should follow the relavant national
standards.
Fig. 4
Electrical connection
Check the data on the rating plate, located on the outside of the unit, to ensure that the
supply and input voltage are suitable.
Before connection, check the earthing system.
By Law, this appliance must be earthed. If this regulation is not complied with, the
Manufacturer will not be responsible for any damage caused to persons or property.
If a plug is not already attached, fit a plug appropriate to the load indicated on the rating
plate. The earth wire is coloured yellow/green.
Where the Hob is connected direct to the electricity supply, a circuit breaker must be
fitted with at least a 3 mm contact spacing when in the open position.
It if is necessary to replace the connecting cable, the earth wire (yellow/green) must,
by law, be approximately 10 mm longer than the live and neutral wires. Rubber insulat-
ed cable type H05RR-F must be used.
The cables should be 1,5 mm2section for products with electrically heated elements,
4
and 0,75 mm2for others products. Also, the maximum external diameter of the cable
should not be greater than 7 mm.
Declaration of compliance. The parts of this equipment which are designed to come
into contact with foodstuffs, comply with EEC directive 89/109.
Appliance complying with European directives 89/336/EEC, 90/396/EEC,
73/23/EEC and subsequent modifications.
The rating plate on the hob shows the type of gas with which it is designed to be used.
It is possible to use other types of gas after carrying out some simple modifications.
a) Connection to the gas supply
— connection to the mains gas supply or gas cylinder should be carried out according
to the relevant national standards, after having checked that it is regulated for the
type of gas with which it will be supplied. If it is not correctly regulated follow the
instructions in the paragraph entitlet «Adaption for different types of gas». For liquid
gas (cylinder gas) use pressure regulators which comply with the relevant national
standards.
N.B.: for safe operation, economic use of energy and to ensure greater durability
of the appliance, make sure that the supply pressure conforms with the values shown
in the table on page 6 .
— Connection to a rigid pipe (see instruction on page 10)
Connection to the gas supply should be done without putting any kind of stress on
the appliance.
— Connection to a flexible steel pipe (see instructions on page 10)
The junction of the gas pipe with the appliance is a 1/2” gas tapered thread connec-
tion. Use only pipes, washers and sealing washers which comply with the relevant
national standards.
The fitting of these pipes should be done to that their
maximum length, when fully extended, should not
exceed 2000 mm.
N.B.: carry out a final check for leaks on the
pipework using a soapy solution. Never use a
flame. Also, make sure that the flexible pipe
cannot come into contact with a movlng part of
the cabinet (eg, a drawer) and that it is not situa-
ted where it could be damaged.
Gas connection
LIVE L
EARTH
NEUTRAL N
MAINS
SUPPLY
BROWN WIRE
GREEN/YELLOW WIRE
BLUE WIRE
POWER
CABLE

Product specificaties

Merk: Candy
Categorie: Fornuis
Model: PCP700/1SDXA

Heb je hulp nodig?

Als je hulp nodig hebt met Candy PCP700/1SDXA stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Fornuis Candy

Candy

Candy CHG93WPX MAR Handleiding

24 November 2024
Candy

Candy KRCDJ642 Handleiding

24 November 2024
Candy

Candy CI642C/E14U Handleiding

24 November 2024
Candy

Candy CSG64SWGB Handleiding

23 November 2024
Candy

Candy CSVG64SGN Handleiding

23 November 2024
Candy

Candy CSG64SWGN Handleiding

23 November 2024
Candy

Candy CSVG64SGB Handleiding

23 November 2024
Candy

Candy CMCJ644TPWIFI Handleiding

23 November 2024
Candy

Candy CSG64SWGX Handleiding

22 November 2024
Candy

Candy CVG3PX Handleiding

25 Oktober 2024

Handleiding Fornuis

Nieuwste handleidingen voor Fornuis

Teka

Teka IBF 63210 SSM Handleiding

17 December 2024
Bröhn

Bröhn BRGC-AGCP9053-D Handleiding

17 December 2024
BEKO

BEKO BBIH12100BC Handleiding

16 December 2024
BEKO

BEKO FBM62330GWDTN Handleiding

15 December 2024
BEKO

BEKO FBG62010DW Handleiding

15 December 2024
BEKO

BEKO FBM6230TXDSN Handleiding

15 December 2024
BEKO

BEKO FBM62330GXTN Handleiding

15 December 2024
Tower

Tower T14045 Handleiding

14 December 2024
Tower

Tower T14044 Handleiding

14 December 2024
Bertazzoni

Bertazzoni PRO105I3EBIT Handleiding

14 December 2024