Bushnell H2O Handleiding

Bushnell Verrekijker H2O

Lees hieronder de 📖 handleiding in het Nederlandse voor Bushnell H2O (22 pagina's) in de categorie Verrekijker. Deze handleiding was nuttig voor 90 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/22

USER MANUAL

H2O™

Model #: 157050R, 138005R, 158042R, 134218R, 134211R, 150142R, 130105R, 134212R, 132105R 03-22

WATERPROOF BINOCULAR

Thank yo noculars.

This manual will help you optimize your viewing experience by explaining how you can adjust the binocular to your eyes,

and how to care for this instrument. Read the instructions carefully before using your binocular.

NEVER LOOK DIRECTLY AT THE SUN WITH YOUR BINOCULAR, AS IT MAY CAUSE SERIOUS

DAMAGE TO YOUR EYES

EYECUP ADJUSTMENT

Your Bushnell H2O binocular is fitted with eyecups that provide a comfortable view of the full image and help to exclude

extraneous light. If you need to wear glasses when using binoculars, leave the eyecup in the “down” position (Fig. 1, next

page). For use without eyeglasses or sunglasses, twist up the eyecups . This will place your eyes farther from the (Fig. 2)

binocular’s ocular lenses, at the correct eye relief distance, allowing you to see the full field of view.

IPD (INTERPUPILLARY DISTANCE) ADJUSTMENT

The spacing between the pupils of your eyes, called “interpupillary distance,” varies from person to person. To match your

binoculars to your IPD or “eye to eye” width:

1. Point them at a white wall or blank area of the sky. Hold the binoculars and view through them as you normally would.

Don’t worry about focus yet.

2. Grasp each side of the binocular firmly. Move the left and right sides closer together or farther apart (Fig. 3, next

page) until you see a single image with no shaded areas.

PARTS GUIDE

* under cap (not available on FRP models)

Ocular Lens A

Diopter Adjustment Ring B

Eyecups C

Tripod Adapter Socket* D

Center Focus Knob E

Objective Lens F

Porro Design

Sku’s:157050R,

158042R,134218R,

134211R,134212R

Roof Design

Sku’s: 150142R, 130105R

Folding Roof Prism (FRP) Design

Sku’s:138005R, 132105R

FOCUS AND DIOPTER ADJUSTMENT

1. Adjust the eyecups and IPD as described in the previous sections.

2. Using a lens cap or your hand, cover the objective lens on the right side of the

binocular.

3. Using the center focus knob, focus on a distant object with fine detail (e.g., brick wall,

tree branches, etc) until it appears as sharp as possible when viewed through the left

side of the binocular.

4. Uncover the objective lens on the right side, and cover the left objective lens while

continuing to view the same object.

5. Rotate the diopter adjustment ring ( located directly below the right eyecup to NOT the center focus knob) (Fig. 4)

bring the object into focus in the right side of the binocular. Avoid over-turning or forcing the diopter mechanism. If

you are unable to bring the object into focus for your right eye by adjusting the diopter ring/eyecup, make sure the

left side is still in focus (repeat steps #2-4 if necessary). The diopter adjustment essentially provides “fine focus” on one

side of the binocular (right only) to allow for slight differences in the vision of your left and right eyes.

6. Your binocular should now be adjusted for your eyes. Focusing for any distance can now be done simply by turning

the center focus knob. Make a note of your diopter setting (position of plus and minus marks on diopter ring relative

to index mark on binocular near the ring) for future reference in case the ring is moved accidentally or by another

person using your binocular.

NECKSTRAP ATTACHMENT

To attach the neckstrap, thread the ends of the neckstrap through the strap lug

(Fig. 5) on each side of the binocular, then back through the plastic buckle on the

strap (Fig. 6). Adjust the position of the binoculars on your chest as they hang around

your neck to your preference, by changing the length of the strap section which

passes through the strap channel and buckle by an equal amount on each side. If you

prefer to use an aftermarket strap that has metal O-rings, attach them to a plastic zip

tie placed on the strap lugs rather than installing them directly on the lug, to avoid

damaging the finish on the binocular via contact with the rings.

TRIPOD MOUNTING

To attach the binocular to a tripod or monopod, unscrew the cap which covers the

threaded (1/4-20UNC) socket at the far end of the center hinge , and set it aside (Fig. 7)

in a safe place. Use a compatible binocular tripod adapter accessory (90o angle bracket),

such as the Bushnell #161002CM, to attach your binocular on any standard tripod in a

horizontal position, to provide a stable image during prolonged viewing, especially with

high power optics. Tripod mounting not available on FRP models.

Fig. 7 Tripod Socket Cap

Fig. 1 Eyecup in “Down” Position

(for use with glasses)

Fig. 2 Eyecup in “Up” Position

(for use without glasses)

Fig. 3 Interpupillary Distance (IPD) Adjustment

Wide IPD

Narrow IPD

Fig. 5 Strap Lug Fig. 6 Strap & Buckle

Fig. 4 Diopter Adjustment Ring

Product specificaties

Merk:	Bushnell
Categorie:	Verrekijker
Model:	H2O
Kleur van het product:	Zwart
Gewicht:	385.5 g
Waterdicht:	Ja
Focus:	Centrum
Dichtstbijzijnde focus afstand:	2.6 m
Prisma type:	BaK-4
Vergroting:	10 x
Objective diameter:	26 mm
Exit pupil:	2.6 mm
Oogafstand:	13.5 mm