Boss ATV80 Handleiding

Boss Speaker ATV80

Lees hieronder de 📖 handleiding in het Nederlandse voor Boss ATV80 (3 pagina's) in de categorie Speaker. Deze handleiding was nuttig voor 31 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/3
FCC COMPLIANCE STATEMENT
This device complies with part 15 of the FCC Rules. Operaon is subject to the
following two condions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause
undesired operaon of this device.
1- ATV80 All Terrain Speaker System
1- Quick Connect Power Extension Adaptor
2- Nylon Mounng Straps and Nylon Zip Ties
1- User Manual Quick Start Guide / Poster
1- Warranty Card
USER MANUAL
QUICK START GUIDE
Thank you for purchasing this
ATV80 All Terrain Sound System
Please read through these instrucons carefully so you will know
how to operate your model properly.
Aer you have nished reading the instrucons, keep this document
in a safe place for future reference.
BEFORE YOU START
INFORMATION TO THE USER
CAUTION!!
ADJUSTMENT OR ALTERATIONS OF THIS PRODUCT MAY RESULT
IN HAZARDOUS OPERATION.
IMPORTANT SAFETY PRECAUTIONS
● Do not operate mobile equipment while driving a motorized vehicle – safe driving
and safety consideraon of others should always be your highest priority.
● In the event you should noce smoke, strange noises or odor from this product, or
any other abnormal signs, immediately turn o the power and consult your dealer or
the nearest authorized BOSS AUDIO Service Center. Using this product in this
condion may result in permanent damage to the system.
● Set your volume control at a low seng, then slowly increase the sound unl you
can hear it comfortably without distoron, or ear discomfort.
● BE SURE TO OBSERVE THE FOLLOWING GUIDELINES:
- Do not turn up the volume so high that you can’t hear what’s around you.
- Use cauon or temporarily disconnue use in potenally hazardous situaons.
INSTALLATION PRECAUTIONS
WARNING - Always consult a professional installer
● Do not aempt to install or service this product by yourself. Installaon or servic-
ing of this product by persons without professional training and experience in
electronic equipment and motorized vehicle accessories may be dangerous and could
expose you to the risk of electric shock, injury or other hazards
● Refer any repairs to a qualied BOSS AUDIO SYSTEMS Service Center
● The ATV80 can be powered from a vehicles cigaree lighter / auxiliary power port,
or hard wired directly to the baery through an oponal relay / accessory switch
● When wiring directly to the vehicles baery, be sure to disconnect the baeries
negave terminal wire before starng any wiring procedures, it is suggested that an
oponal fuse and fuse holder (not included) with minimum rang of 20 Amps be in
line with the posive baery terminal
● The ground cable length should not exceed 18-inches (See wiring diagram)
● The ATV80 has a weather resistant design, it should not be submerged in or
under water under any circumstances
● Use only the installaon parts provided with the ATV80
BEFORE INSTALLING THIS PRODUCT
CAUTION!!
USING OTHER MOUNTING METHODS MAY VOID THIS WARRANTY
POWER ON AND AUX-IN OPERATION
1) Power on the ATV80 by plugging into a 12VDC power adaptor
2) Route the integrated 3.5mm AUX-IN cable located on front side of the ATV80
thorough the supplied so carry pouch
3) Connect your device headphone jack to the 3.5mm AUX-IN cable
4) Thread the strap through the pouch, secure the pouches top cover
5) Wrap and rmly fasten the pouch strap around the center of the ATV80
6) Secure any loose wiring before vehicle usage
VOLUME CONTROL
7) To raise or lower the volume use your media player master volume controller
Make sure your device headphone volume is set at comfortable
level before stowing in to the carry pouch
The ATV80 can play audio from any device that has a 3.5mm headphone audio jack.
INSERT
WIRE
INSERT
QUICK RELEASE
POWER ADAPTOR
(INCLUDED)
POWER ADAPTOR
MEDIA
PLAYER
SOFT
POUCH
YOUR
MEDIA
DEVICE
INSERT
DEVICE
SECURE
POUCH
STRAP
POUCH
Tips:
GETTING TO KNOW YOUR ATV80
When replacing the fuse, be sure to only use a fuse of the rang specied on this
product. To avoid short-circuing, cover any disconnected leads with insulang tape.
It is especially important to insulate any unused wires, which if le uncovered may
cause a short circuit. When connecng other devices to this product, refer to the
manual for the product to be connected. The black cable is ground, make sure to
connect the ground wire rst. Ensure that the ground wire is properly connected to
metal parts of the vehicles body frame or direct to the baery if your vehicle does
not have a grounded chassis frame The ground wire of this units power amp and a
second powered system must be connected to the frame separately with dierent
screws. If the screw for the ground wire loosens or falls out, it could result in re or
malfuncon.
To avoid potenal shorts in the electrical system, be
sure to disconnect the (–) baery cable before
installaon. Use this unit with a 12-Volt baery and
negave grounding only.
Failure to do so may result in a re or malfuncon.
SPEAKER MOUNTING SUGGESTIONS
CAUTION!!
Mounng strap buckles should be double checked to ensure they are ght and
secure before each use of the vehicle.
ALL-TERRAIN SOUND SYSTEM
ATV80
USER MANUAL
FEATURING 8” MARINE GRADE SPEAKERS
AND SWIVEL 1” SOFT DOME TWEETERS
with BUILT-IN HIGH POWERED INTERNAL AMPLIFIER
QUICK START GUIDE
ATV80
USER MANUAL
AUX-IN | ALL-TERRAIN SOUND SYSTEM
PRINTED IN CHINA
VER:1.02 EN
iPod / iPhone are trademarks of Apple Inc. registered in the U.S. and other countries.
BOSS Audio Systems is not aliated with Apple Inc.
715
BOSS Audio Systems
3451 Lunar Court • Oxnard, CA 93030
www.bossaudio.com | 1.805.751.4853
Tech Support: www.bossaudio.com/support
AUX-IN
• 3.5mm
• Cable length: 5 / 1.5m
SPEAKERS
• Dimensions: 8” /219.8mm
• Impedance: 2Ω + 2Ω
• Cone Type: PP CARBON + RUBBER SURROUND
• Tweeter Size: 1” PEI SOFT DOME
AMPLIFIER
• Maximum Output Power: 700 Was
• Input impedance: 10kΩ
• Frequency Response: 45Hz-25kHz
SPECIFICATIONS
WIRE DIAGRAM
15A
Fuse and fuse holder
(not included)
Chassis
ground
point
BATTERY
Fuse is located inside the power adaptor
Turn counter clockwise to open
Replace with 15A AGC Fuse type only
Normally open switch
(not included)
OPTIONAL DIRECT BATTERY WIRING CIRCUIT
RED
BLACK
Chassis
ground
point
QUICK RELEASE
POWER ADAPTOR
(INCLUDED)
Ground wire
Metal frame
Recommended 12 ~ 14ga Wire
(not included)
POWER ADAPTOR
3.5mm AUX INPUT
Normally open switch
(not included)
GENERAL
• Operaonal Power: 12VDC (10-16V allowable)
• MAX Current Draw: 13.7A
• Replacement Fuse: 15A AGC TYPE
• Color: Black
• Weight: 20.8lbs / 9.43Kg
• Dimensions cm WxHxD: 80.3 x 22.9 x 33.4
• Dimensions Inches WxHxD: 31.63 x 9.00 x 13.15
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
All rights reserved. No part of this publication may be reproduced, distributed, or transmitted in any form or by any means, including
photocopying, recording, or other electronic or mechanical methods, without the prior written permission of AVA Enterprises Inc.
Copyright © 2015 BOSS AUDIO SYSTEMS Inc.
THIS PACKAGE CONTAINS
OPERATION
NOTE: The carry so pouch is designed to keep your device safe from debris, make
sure to close the pouch cover securely before each vehicle use.
1) Route 2 mounng straps securely around your vehicles metal rack bar system
2) To ghten, pull excess slack through strap buckles
2
1
3
2
4
6
1
5


Product specificaties

Merk: Boss
Categorie: Speaker
Model: ATV80

Heb je hulp nodig?

Als je hulp nodig hebt met Boss ATV80 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Speaker Boss

Handleiding Speaker

Nieuwste handleidingen voor Speaker