Boss ATV25B Handleiding

Boss Speaker ATV25B

Lees hieronder de 📖 handleiding in het Nederlandse voor Boss ATV25B (3 pagina's) in de categorie Speaker. Deze handleiding was nuttig voor 8 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/3
ATV25B-UM-POSTER-STYLE-42cm X 58cm-DRAFT.indd 1 9/16/2014 6:36:47 PM
FCC COMPLIANCE STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause
undesired operation of this device.
This transmitter must not be co-located or operated in conjunction with any other
antenna or transmitter. The Bluetooth antenna cannot be removed (or replaced) by
user. This equipment complies with FCC/ IC radiation exposure limits set forth for
an uncontrolled environment and meets the FCC radio frequency (RF) Exposure
Guidelines and RSS-102 of the IC radio frequency (RF) Exposure rules. This
equipment has very low levels of RF energy that it deemed to comply without
maximum permissive exposure evaluation (MPE). But it is desirable that it should
be installed and operated keeping the radiator at least 20 cm or more away from
person’s body (excluding extremities: hands, wrists, feet and ankles). Alteration
or modications carried out without appropriate authorization may invalidate the
users right to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio fre-
quency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equip-
ment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
□ Relocate or reorient the receiving antenna.
□ Increase the separation between the equipment and receiver.
□ Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
□ Consult the dealer or an experienced radio/TV technician for help.
THIS PACKAGE CONTAINS
1- ATV25B All Terrain Speaker System
1- Bluetooth Multi-Function Controller
1- Handlebar Mounting Kit
1- Quick Connect Power Extension Adaptor
2- Nylon Mounting Straps and Nylon Zip Ties
1- User Manual Quick Start Guide / Poster
1- Warranty Card
USER MANUAL
QUICK STAR T GUIDE
Thank you for purchasing this
ATV25B All Terrain Sound System
Please read through these instructions carefully so you will know how to
operate your model properly.
After you have nished reading the instructions, keep this document in a
safe place for future reference.
INFORMATION TO THE USER
INFORMATION TO THE USER
The Bluetooth® word mark and logos are registered trademarks owned by
Bluetooth SIG, Inc. and any use of such marks is under license.
Other trademarks and trade names are those of their respective owners.
CAUTION!!
ADJUSTMENT OR ALTERATIONS OF THIS DEVICE MAY RESULT
IN HAZARDOUS RADIATION EXPOSURE.
GETTING TO KNOW YOUR
ATV25B MULTIFUNCTION CONTROLLER (MFC)
BEFORE YOU START
IMPORTANT SAFETY PRECAUTIONS
■ Do not operate mobile equipment while driving a motorized vehicle – safe driving and
safety consideration of others should always be your highest priority.
■ In the event you should notice smoke, strange noises or odor from this product, or any
other abnormal signs, immediately turn off the power and consult your dealer or the nearest
authorized BOSS AUDIO Service Center. Using this product in this condition may result in
permanent damage to the system.
■ Set your volume control at a low setting, then slowly increase the sound until you can
hear it comfortably without distortion, or ear discomfort.
BE SURE TO OBSERVE THE FOLLOWING GUIDELINES:
- Do not turn up the volume so high that you can’t hear what’s around you.
- Use caution or temporarily discontinue use in potentially hazardous situations.
INSTALLATION PRECAUTIONS
WARNING - Always consult a professional installer
■ Do not attempt to install or service this product by yourself. Installation or servicing of this
product by persons without professional training and experience in electronic equipment
and motorized vehicle accessories may be dangerous and could expose you to the risk of
electric shock, injury or other hazards
■ Refer any repairs to a qualied BOSS AUDIO SYSTEMS Service Center
■ The ATV25B can be powered from a vehicles cigarette lighter / auxiliary power port, or
hard wired directly to the battery through an optional relay / accessory switch
■ When wiring directly to the vehicles battery, be sure to disconnect the batteries negative
terminal wire before starting any wiring procedures, it is suggested that an
optional fuse and fuse holder (not included) with minimum rating of be in line with 20 Amps
the positive battery terminal
■ The ground cable length should not exceed 18-inches (See wiring diagram)
■ The ATV25B has a weather resistant design, it should not be submerged in or
under water under any circumstances
■ Use only the installation parts provided with the ATV25B
GETTING STARTED
1
2
3
4
5
6
7
8
567
4
23
1
MFC - MULTIFUNCTION CONTROLLER
BLUETOOTH INDICATOR LED - BLUE COLOR
POWER INDICATOR LED - RED COLOR
3.5mm AUX-INPUT
PREVIOUS TRACK / Press and hold for VOL -
PLAY/PAUSE / Press and hold for POWER ON
NEXT TRACK / Press and hold for VOL +
NFC SIMPLE PAIR LOCATION
CAUTION!! Using other mounting methods may void this warranty
PAIRING & DISCOVERING A NEW BLUETOOTH CONNECTION
1) Power on the ATV25B Play/Pauseby pressing and holding down the multifunction
button for 3 seconds, the 2blue and 3red LEDs will start to alternately ash, signalling
that the ATV25B is now ready for Bluetooth pairing.
NOTE: You have 2 minutes before you must restart this procedure over again.
2) Now that the ATV25B is in pairing mode:
ANDROID users:
a. Go into the Settings Menu of your device
b. Enter the Bluetooth Menu
TURN ON Bluetooth SCANc. and press
d. “BOSS AUDIO” will now be displayed under AVAILABLE DEVICES
e. If prompted, enter passcode: “ 0000
iOS users:
a. Go into the of your deviceSettings Menu iOS
b. Enter the Bluetooth Menu
c. TURN ON Bluetooth
d. “BOSS AUDIO” will now be displayed
e. If prompted, enter passcode: “ 0000
3) If the ATV25B Device List”is not seen, repeat the above steps to refresh the “
4) When the connection is successful, you are now ready to stream music from your favorite
media player to the ATV25B
To avoid battery exhaustion, be sure to occasionally run the vehicles
engine while using this product. Using this product without running the
engine can drain the battery.
BLUETOOTH OPERATION BLUETOOTH / NFC OPERATION
RECONNECTION
1) Power on the ATV25B and your last paired device Bluetooth.
2) The unit will now automatically reconnect
3) If your device was previously paired with the ATV25B, but it wasn’t the last paired
device:
a. Ensure no other devices are currently paired
b. Enter the Bluetooth Menu on your device being paired
c. BOSS AUDIO” will display under AVAILABLE DEVICES
d. Choose the “BOSS AUDIO” to reconnect
4) If the device is out of range from the ATV25B, it will disconnect automatically:
a. To reconnect once device is back in range, press the Play/Pause
button once
b. The A TV25B will now reconnect to the device
NFC SIMPLE PAIR
NFC BOSS enabled devices tap within 1/2” of the logo, you will hear a conrmation tone,
your device will now automatically be paired without any further procedures, some NFC
devices will require several attempts to successfully pair
6
23
Tips:
MULTIFUNCTION CONTROLLER BLUETOOTH OPERATION
1) Press the PLAY/PAUSE PLAYonce to start playing music or press the button from
your device touch screen
2) To skip songs or advance, press the buttonNEXT TRACK
3) To select the previous song, press the buttonPREVIOUS TRACK
VOLUME CONTROL
4) To raise the volume the button 2 ~ 3 secondsPress and Hold VOL +
5) To lower the volume the Press and Hold button 2 ~ 3 secondsVOL -
MULTIFUNCTION CONTROLLER AUX-IN OPERATION
1) Power on the ATV25B PLAY/PAUSE by pressing and holding down the
multifunction button for 3 seconds
2) Disconnect any paired Bluetooth Bluetooth device by turning off in your devices
Settings Menu
3) Connect the integrated 3.5mm cable located on right side of the MFC to your AUX-IN
devices headphone jack
4) Route the wire back to ATV25B, strap and secure your device in the supplied soft carry
pouch
VOLUME CONTROL
5) To raise the volume the button 2 ~ 3 secondsPress and Hold VOL +
6) To lower the volume the Press and Hold button 2 ~ 3 secondsVOL -
STREAMING MUSIC
Make sure your device Bluetooth volume is set at 75% level before
stowing in to the carry pouch
AUX-INPUT
Make sure your device headphone volume is set at 75% level before
stowing in to the carry pouch
ATV25B can play audio from any device
that has a 3.5mm headphone audio jack.
YOUR DEVICE
57
6
Tips:
Tips:
MULTI-FUNCTION CONTROLLER MOUNTING
LEFT or RIGHT
FOR ILLUSTRATION PURPOSES
YOUR VEHICLE MAY VARY
FOR ILLUSTRATION PURPOSES
YOUR VEHICLE MAY VARY
RUBBER
SHIM
INSERT
WASHER
LOCK NUT
ALLEN HEAD
BOLT
LOCK NUT
ALLEN HEAD
BOLT
MULTI-FUNCTION
CONTROLLER
UNIT
SNAP
BRACKET
Z-BRACKET
HANDLEBAR
CLAMP
TOOLS NEEDED:
- 12mm Socket, Wrench or Pliers
- 6mm Allen Wrench
BEFORE INSTALLING THIS PRODUCT
When replacing the fuse, be sure to only use a fuse of the rating specied on
this product. To avoid short-circuiting, cover any disconnected leads with insulating
tape. It is especially important to insulate any unused wires, which if left uncovered
may cause a short circuit. When connecting other devices to this product, refer to
the manual for the product to be connected. The black cable is ground, make sure
to connect the ground wire rst. Ensure that the ground wire is properly connected
to metal parts of the vehicles body frame or direct to the battery if your vehicle
does not have a grounded chassis frame The ground wire of this units power amp
and a second powered system must be connected to the frame separately with
different screws. If the screw for the ground wire loosens or falls out, it could result
in re or malfunction.
To avoid potential shorts in the electrical
system, be sure to disconnect the (–) bat-
tery cable before installation. Use this unit
with a 12-Volt battery and negative
grounding only. Failure to do so may result
in a re or malfunction.
SPEAKER MOUNTING SUGGESTIONS
CAUTION!! Mounting straps should be
double checked to be sure they are tight
and secure before each use of the
vehicle. The carry pouch is designed to
keep your device safe from debris, make
sure to close the pouch cover securely
before using vehicle.
BLUETOOTH® ENABLED
ALL-TERRAIN SOUND SYSTEM
ATV25B
USER MANUAL
FEATURING 6.5” MARINE GRADE SPEAKERS
AND 1” SOFT DOME TWEETERS
with BUILT-IN HIGH POWERED INTERNAL AMPLIFIER
QUICK START GUIDE
ATV25B
USER MANUAL
BLUETOOTH® ENABLED | ALL-TERRAIN SOUND SYSTEM
PRINTED IN CHINA
VER:1.02 EN
iPod / iPhone are trademarks of Apple Inc. registered in the U.S. and other
countries.
BOSS Audio Systems is not affiliated with Apple Inc.
1014
BOSS Audio Systems
3451 Lunar Court • Oxnard, CA 93030
www.bossaudio.com | 800.999.1236
Tech Support: www.bossaudio.com/support
BLUETOOTH
• Version: 3.0 w/ EDR
A2DP
Range: 33ft (10m)
SPEAKERS
Dimensions: 6.5” / 165.1mm
• Impedance: 4Ω
Magnet: 11oz
Cone Type: PP CARBON
Tweeter Size: 1” PEI SOFT DOME
AMPLIFIER
• Maximum Output Power: 450 Watts
Input impedance: 10kΩ
Frequency Response: 45Hz-25kHz
SPECIFICATIONS
WIRE DIAGRAM
15A
Fuse and fuse holder
(not included)
Chassis
ground
point
BATTERY
Mini-DIN
Connector
Fuse is located inside the power adaptor
Turn counter clockwise to open
Replace with 10A AGC Fuse type only
INSERT
Normally open switch
(not included)
INSERT
OPTIONAL DIRECT BATTERY WIRING CIRCUIT
RED
BLACK
Chassis
ground
point
QUICK RELEASE
POWER ADAPTOR
(INCLUDED)
MFC
POWER ADAPTOR
10A
Ground wire
Metal frame
Recommended 12 ~ 14ga Wire
(not included)
Align arrows
GENERAL
• Operational Power: 12VDC
(10-16V allowable)
MAX Current Draw: 8.7A
Replacement Fuse: 10A AGC TYPE
Color: Black
Weight: 15lbs / 6.8Kg
Dimensions cm WxHxD: 68.0 x 19.8 x 27.5
Dimensions Inches WxHxD: 26.77 x 7.95 x 10.83
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
6
57
All rights reserved. No part of this publication may be reproduced, distributed, or transmitted in any form or by
any means, including photocopying, recording, or other electronic or mechanical methods, without the prior writ-
ten permission of AVA Enterprises Inc.
Copyright © 2014 AVA Enterprises Inc.
NOW WITH
SIMPLE PAIR
2 cm
8
ATV25B-UM-POSTER-STYLE-42cm X 58cm-DRAFT.indd 2 9/16/2014 6:36:56 PM


Product specificaties

Merk: Boss
Categorie: Speaker
Model: ATV25B

Heb je hulp nodig?

Als je hulp nodig hebt met Boss ATV25B stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Speaker Boss

Handleiding Speaker

Nieuwste handleidingen voor Speaker