Bosch SPV2HKX42G Handleiding

Bosch Vaatwasser SPV2HKX42G

Lees hieronder de 📖 handleiding in het Nederlandse voor Bosch SPV2HKX42G (4 pagina's) in de categorie Vaatwasser. Deze handleiding was nuttig voor 69 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/4

9001909334 (040109) SPV2HKX42G

*9001909334* Quick reference guide Dishwasher

en Before using for the first time, read the instruction manual and the safety information it contains.

Setting up Home Connect

Tip:Connect your appliance to a mobile device. You can con-

veniently change all settings using the HomeConnect app.

1. Install the HomeConnect app on your mobile device and fol-

low the instructions.

2. Scan the QR code with the HomeConnect

app.

Overview of water hardness settings

You can find an overview of the water hardness values that can be

selected here.

A table of country-specific units can be found in the instruction

manual.

Hardness

range

mmol/l Setting LED A LED B LED C

Soft 0 - 1.1 0

Medium 1.2 - 2.9 1

Hard 3.0 - 3.7 2

Hard 3.8 - 8.9 3

Setting the water softening sys-

tem

1. Press .

2. To open the appliance settings,

press for 3 seconds.

a flashes.

3. Press repeatedly until the right

water hardness has been set.

0, 1, 2 or 3 LEDs will light up ac-

cordingly.

4. To save the settings, press

for 3 seconds.

Adding special salt

To avoid damage to the appliance, only add special

salt to the dispenser for special salt just before the

programme starts.

1. Unscrew the lid of the dispenser for special salt

and remove.

2. On initial start-up: Fill the dispenser right up with

water.

3. Add the special salt to the

dispenser. The water in the

dispenser is displaced and

forced out. Never add de-

tergent.

4. Place the lid back on the dispenser and turn to

close.

Adding rinse aid

1. Press the catch on the lid

of the dispenser for rinse

aid and lift .

2. Add rinse aid up to the

max mark.

max

3. Close the lid of the dispenser for rinse aid.

aThe lid clicks into position.

How to use your appliance

1. Load the tableware.

Only clean tableware that is suitable for dish-

washers. Remove large remnants of food from

the tableware. Check that the spray arms can ro-

tate freely.

2. Add detergent.

3. Switch on the appliance .

4. Select the programme.

5. Start the programme .

6. Remove the tableware at the end of the pro-

gramme.

7. To cancel the programme, press for

approx. 4seconds.

The programme is cancelled and ends after ap-

prox. 1minute.

Programmes

The programme data has been meas-

ured in the laboratory according to

European standard EN60436.

The consumption figures depend on

the programme and additional func-

tion selected.

The running time will change if the

rinse aid system is switched off or

rinse aid needs to be added.

Programme 1) Duration [h:min]

2) Energy consump-

tion [kWh]

3) Water [l]

Intensive 70°

1) 1:55 -2:05

2) 1.090 -1.200

3) 10.5 -13.0

Auto 45-65°

1) 1:35-2:40

2) 0.650-1.100

3) 7.0-14.5

Eco 50°

1) 3:40

2) 0.755

3) 8.9

Express 65° - 1h

1) 1:00

2) 1.050

3) 10.0

Machine Care

1) 2:10

2) 1.130

3) 15.0

Favourite

1) 0:15-0:15

2) 0.050-0.050

3) 4.0-4.0

Adding detergent

1. Add the detergent to the

dry detergent dispenser.

15 ml

25 ml

50 ml

2. Close the lid of the deter-

gent dispenser.

aThe lid clicks into position.

Cleaning filters

1. After each wash check the filters for

residue.

2. Turn the coarse

filter anticlock-

wise and re-

move the filter

system .

3. Pull down the mi-

cro filter to re-

move.

4. Press the locking

catches to-

gether and lift

the coarse filter

out .

5. Clean the filter elements under running

water.

6. Re-assemble the filter system.

7. Insert the filter system into the appliance

and turn the coarse filter clockwise.

Make sure that the arrow markings

match up.

Cleaning spray arms

1. Unscrew the upper spray arms and

pull down to remove .

2. Pull up the lower spray arm to remove.

3. Check the outlet nozzles on the spray arms for blockages un-

der running water and remove any foreign bodies.

4. Insert the lower spray arm.

aThe spray arm clicks into position.

5. Insert the upper spray arms and screw firmly in place.

Clean wastewater pump

1. Disconnect the appliance from the power supply.

2. Remove the filter system.

3. Scoop out any water.

4. Prise off the pump cover using a

spoon and grip it by the crosspiece.

5. Lift the pump cover inwards at an angle and remove.

6. Remove any remnants of food and foreign bodies in the area

of the impeller.

7. Insert the pump cover and press

down .

aThe pump cover clicks into position.

8. Install the filter system.

Troubleshooting

Fault Cause and troubleshooting

Remnants of food on

tableware.

Tableware is placed too close together or basket is overfilled.

1. Arrange tableware with sufficient space in between.

The spray jets must reach the surfaces of the tableware.

2. Avoid points of contact.

Spray arm rotation is blocked.

▶Arrange tableware so that it does not obstruct spray arm ro-

tation.

Spray arm nozzles are blocked.

▶Clean the Spray arms.

Filters are soiled.

▶Clean the filters.

Fault Cause and troubleshooting

Remnants of food on

tableware.

Filters are inserted incorrectly and/or not engaged.

1. Insert the filters properly.

2. Engage the filters.

Washing programme selected too weak.

▶Select a more intensive washing programme.

Removable streaks are

present on glasses, glass-

ware with a metallic ap-

pearance and cutlery.

Amount of rinse aid to be dispensed is set too high.

▶Set the rinse aid system to a lower setting.

No rinse aid has been added.

▶Add rinse aid.

Rust spots on cutlery. Cutlery is not sufficiently rust-resistant. Knife blades are often

more severely affected.

▶Use rust-resistant tableware.

Fault Cause and troubleshooting

Rust spots on cutlery. Cutlery may also rust if washed together with rusting items.

▶Do not wash rusting items.

Detergent residue is

present in the detergent

dispenser or the tablet

collecting tray.

Spray arms were blocked by tableware so detergent was not

rinsed out.

▶Check that the spray arms are not blocked and can rotate

freely.

All LEDs light up or flash

or the rinse programme

does not continue run-

ning.

Electronics have detected a fault.

▶Press the main switch button for approx. 4seconds.

The appliance is reset and restarted.

Product specificaties

Merk:	Bosch
Categorie:	Vaatwasser
Model:	SPV2HKX42G
Apparaatplaatsing:	Volledig ingebouwd
Soort bediening:	Knoppen
Gewicht:	27100 g
Breedte:	448 mm
Diepte:	550 mm
Hoogte:	815 mm
Netbelasting:	2400 W
Aantal couverts:	10 couverts
Droogsysteem:	Warmtewisselaar
Deurkleur:	Niet van toepassing
Snoerlengte:	1.75 m
Uitgestelde start timer:	Ja
Startvertraging:	9 uur
Wi-Fi-besturing:	Ja
Duur cyclus:	220 min
Geluidsniveau:	46 dB
Energie-efficiëntieklasse:	E
Geschikt voor paneelaanpassing:	Ja
Installatie compartiment breedte:	450 mm
Installatie compartiment diepte:	550 mm
Waterconsumptie per cyclus:	8.9 l
Stroom:	10 A
Installatie compartiment hoogte (min):	815 mm
Geluidsemissieklasse:	C
Energieverbruik per 100 cycli:	76 kWu
Diepte wanneer de deur open is:	1150 mm
Productafmeting:	Slimline (45 cm)
Kleur bedieningspaneel:	Black, Stainless steel
Bestek compartiment type:	Mand
Kuip materiaal:	Roestvrijstaal
Vloerindicatielampje:	Ja
Automatisch wasmiddel detectie:	Ja
AquaStop-functie:	Ja
Extra droog:	Ja
Afwasprogramma's:	Auto 45-65°C, Intensive, Quick, Quick 65°C
Energieverbruik per cyclus:	0.755 kWu
Lengte afvoerslang:	2.05 m
Lengte watertoevoerslang:	1.65 m
Bovenste mand verstelbare hoogte:	Ja
Installatie compartiment hoogte (max):	875 mm
Temperatuur (max):	70 °C
Stroomverbruik (indien uit):	0.5 W
Bedieningsapps ondersteund:	Bosch Home Connect
Bestekmand type:	Bosch Vario Basket
AC-ingangsspanning:	220-240 V
AC-ingangsfrequentie:	50 - 60 Hz
Energie-efficiëntieschaal:	A tot G
Aangepast paneel gewicht (max):	7500 g
Aangepast paneel gewicht (min):	2500 g
Reparatie-index:	9.2