Black Box LPH008A-R2 Handleiding

Black Box Schakelaar LPH008A-R2

Lees hieronder de 📖 handleiding in het Nederlandse voor Black Box LPH008A-R2 (1 pagina's) in de categorie Schakelaar. Deze handleiding was nuttig voor 93 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/1

Link eight 10-/100-/1000-Mbps PoE+ devices to

this tough, industrial-grade switch’s RJ-45

ports.

Delivers PoE+ power to remote powered devices, including IP

cameras, Wi-Fi access points, and VoIP phones.

8-Port Hardened Gigabit PoE+ Switch Quick Start Guide

LPH008A

Order toll-free in the U.S.: Call 877-877-BBOX (outside U.S.

call 724-746-5500) FREE technical support 24 hours a day, 7 days a

week: Call 724-746-5500 or fax 724-746-0746 Mailing address:

Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018

Web site: www.blackbox.com • E-mail: info@blackbox.com

Customer

Support

Information

NOM Statement

724-746-5500 | blackbox.com

LPH008A

Chapter 3: Operation

724-746-5500 | blackbox.com

LPH008A

® and the Double Diamond

logo are registered trademarks of BB Technologies, Inc. UL is a registered trademark of

Underwriters Laboratories. Any third-party trademarks appearing in this manual are acknowledged

to be the property of their respective owners.

FREE! Live, 24/7 Tech Support is just 60 seconds away.

724-746-5500 | blackbox.com

LPH008A, version 1

FCC and IC RFI Statements; Trademarks

Chapter 1: Overview; Chapter 2: Hardware Installation

724-746-5500 | blackbox.com Page 2

LPH008A

1.3 Hardware Description

Figure 1-1 shows the Hardened Gigabit PoE+ Switch’s front panel. Table 1-1

describes its components.

Figure 1-1. Front panel.

Table 1-1. LPH008A components.

Component Description

(2) Power LEDs Link to 10-/100-/1000-Mbps Ethernet devices

(1) Power Fault LED s when power to the switch is onLight

(8) Link/Act. LEDs Lights when the port is operating

(8) Power Injected LEDs Lights when the port is using PoE+

(8) Gigabit LAN ports Link to PoE+ devices

Chapter 2: Hardware Installation

724-746-5500 | blackbox.com Page 3

LPH008A

Chapter 3: Operation

724-746-5500 | blackbox.com Page 4

LPH008A

Chapter 1: Overview

724-746-5500 | blackbox.com Page 1

LPH008A

1. Overview

1.1 Introduction

The Hardened Gigabit PoE+ Switch has eight 10/100/1000BASE-TX RJ-45

Ethernet ports and two Power LEDs. It supports Power over Ethernet, which

transmits electrical power, along with data, to remote devices over standard

twisted-pair cable in an Ethernet network. The switch uses a 5-pin terminal

block power connector.

NOTE: The switch should be mounted on a well-grounded place, such as a

metal panel.

1.2 What’s Included

Your package should include the following items. If anything is missing or dam-

aged, contact Black Box Technical Support at 724-746-5500 or info@blackbox.

com.

• (1) Hardened Gigabit PoE+ Switch

• (1) 5-pin terminal block for power input

• This user’s manual

Optional accessories:

• Wallmount kit (45.4" [2.3 cm] thick)

2. Hardware Installation

Step 1: Installing the Switch on a DIN Rail or Wall

Refer to the illustrations below to mount the switch on a DIN rail or wall.

DIN rail

installation

Wallmount

installation

Figure 2-1. DIN rail or wallmount installation.

Step 2: Connecting the Power

Refer to the illustration below to connect the power to the switch.

Step 3: Connecting the Network Devices

• Connect your devices using standard UTP/STP cable with RJ-45 connectors to the

switch. (For the cable wiring diagrams, refer to the pin assignment in Figure 3-2.)

• The corresponding RJ-45 LED will light if the Ethernet connection is linked

successfully.

• The LED will blink while the switch transfers data.

UL® Notice for Power Supply

Use a power supply marked with “LPS,” “Limited Power Source,” or “Class 2” with

output rate 24–36 VDC (5 A maximum at 24 VDC).

3. Operation

3.1 LED Indicators

LED indicators are located on the front panel of the switch. See Table 1-1.

3.2 Configuration and Setting Methods

No configuration and setting methods are needed.

3.3 Network Connector Pin Assignments

Table 3-2. RJ-45 connector pinout.

MDI

(1000BASE-T)

MDI

(10/100BASE-T)

1 TP1+ TX+

2 TP1- TX-

3 TP2+ RX+

4 —TP3+

5 —TP3-

6 TP2- RX-

7 —TP4+

8 —TP4-

RJ-45 8-pin straight-through wiring RJ-45 8-pin crossover wiring

Switch PC (NIC) Switch Switch

3 1 ---------------------------- 3 3 ----------------------------

6 2 ---------------------------- 6 6 ----------------------------

1 3 ---------------------------- 1 1 ----------------------------

2 6 ---------------------------- 2 2 ----------------------------

4 7 ---------------------------- 4 4 ----------------------------

5 8 ---------------------------- 5 5 ----------------------------

7 4 ---------------------------- 7 7 ----------------------------

8 5 ---------------------------- 8 8 ----------------------------

Table 3-2. PoE pin definition.

Pin Pin10/100BASE-T(X) PSE RJ-45 port 1000BASE-T PSE RJ-45 port

1 1TD+ with PoE power input + BI_DA+ with PoE power input +

2 2TD- with PoE power input + BI_DA- with PoE power input +

3 3RD+ with PoE power input - BI_DB+ with PoE power input -

6 4RD- with PoE power input - BI_DC+

4 5Not used BI_DC-

5 6Not used BI_DB- with PoE power input

7 7Not used BI_DD+

8 8Not used BI_DD-

FEDERAL COMMUNICATIONS COMMISSION AND

INDUSTRY CANADA RADIO FREQUENCY INTERFERENCE STATEMENTS

This equipment generates, uses, and can radiate radio-frequency energy, and if not installed and used

properly, that is, in strict accordance with the manufacturer’s instructions, may cause inter ference to radio

communication. It has been tested and found to comply with the limits for a Class A computing device in

accordance with the specifications in Subpart B of Part 15 of FCC rules, which are designed to provide reasonable

protection against such interference when the equipment is operated in a commercial environment. Operation of

this equipment in a residential area is likely to cause interference, in which case the user at his own expense will

be required to take whatever measures may be necessary to correct the interference.

Changes or modifications not expressly approved by the party responsible for compliance could void the

user’s authority to operate the equipment.

This digital apparatus does not exceed the Class A limits for radio noise emis sion from digital apparatus set

out in the Radio Interference Regulation of Industry Canada.

Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux

appareils numériques de la classe A prescrites dans le Règlement sur le brouillage radioélectrique publié par

Industrie Canada.

Warranty and Return Information

If you determine that your LPH008A is malfunctioning, do not attempt to alter or

repair the unit. It contains no user-serviceable parts. Contact Black Box Technical

Support at 724-746-5500 or info@blackbox.com.

Before you do, make a record of the history of the problem. We will be able to

provide more efficient and accurate assistance if you have a complete description,

including the nature and duration of the problem, when the problem occurs, and

any particular application that, when used, appears to create the problem or make

it worse.

RJ-45

connector

Figure 3-1. RJ-45 connector.

Figure 3-2. RJ-45 straight-through and

crossover wiring diagrams.

24–36 VDC 24–36 VDC

Product specificaties

Merk:	Black Box
Categorie:	Schakelaar
Model:	LPH008A-R2
Kleur van het product:	Zwart
Breedte:	41 mm
Diepte:	95 mm
Hoogte:	144 mm
Gewicht verpakking:	450 g
Internationale veiligheidscode (IP):	IP30
LED-indicatoren:	Activity, Fault, Link, PoE, Power
Snelstartgids:	Ja
DC voltage input:	12 - 57 V
Netwerkstandaard:	IEEE 802.3, IEEE 802.3ab, IEEE 802.3at, IEEE 802.3u, IEEE 802.3x
Temperatuur bij opslag:	-40 - 85 °C
Stroomspanning bescherming:	Overbelasting
Power over Ethernet (PoE):	Ja
Switchingcapaciteit:	- Gbit/s
MAC-adrestabel:	8000 entries
Datastroombeheer:	Ja
Switch type:	Unmanaged
Aantal basis-switching RJ-45 Ethernet-poorten:	8
Inclusief schroeven:	Ja
Type basis-switching RJ-45 Ethernet-poorten:	Gigabit Ethernet (10/100/1000)
Jumbo Frames ondersteuning:	Ja
Wand montagekit:	Ja
Stroomverbruik (typisch):	6 W
Bedrijfstemperatuur (T-T):	-40 - 75 °C
Relatieve vochtigheid in bedrijf (V-V):	10 - 90 procent
Totaal Power over Ethernet (PoE)-budget:	120 W
Aantal Power over Ethernet plus (PoE +)-poorten:	8
Jumbo frames:	9000
Store-and-forward:	Ja
Klemmenblok inclusief:	Ja
Vermogen per poort Power over Ethernet (PoE):	30 W
Klemmenblokpoort:	Ja
Voltagebereik Power over Ethernet (PoE):	24 - 57 V
DIN-rail inbegrepen:	Ja
Stofkap inbegrepen:	Ja