Bertazzoni CB36600XLP Handleiding

Bertazzoni Fornuis CB36600XLP

Lees hieronder de đź“– handleiding in het Nederlandse voor Bertazzoni CB36600XLP (12 pagina's) in de categorie Fornuis. Deze handleiding was nuttig voor 20 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/12
Installation, Service and User Instructions
Built-in gas cooktops
BERTAZZONI
DIMENSIONS: 36’’ (915 mm)(W) x 253/16’’ (640 mm)(D)
Models CB36500X [C3W0..U7X (2 or 5)A]
Models CB36600X [C3Y0..U7X(2 or 5)A]
IMPORTANT - PLEASE READ AND FOLLOW
-Before beginning installation, please read these instructions completely and carefully.
-Do not remove permanently affixed labels, wa may void the warranty. -Please observe alrnings, or plates from the product. This l local
and national codes and ordinances.
-Please ensure that this product is properly grounded.
-The installer should leave these instructions with the consumer who should retain for local inspector's use and for
future reference.
-The electrical plug should always be accessible.
Installation must conform with local codes or in the absence of codes, the National Fuel Gas Code ANSIZ223.1-latest edition. Electrical
installation must be in accordance with the National Electrical Code, ANIS/NFPA70
- latest edition and/or local codes. IN CANADA:
Installation must be in accordance with the current CAN/CGA-B149.1 National Gas Installation Code or CAN/CGA-B
149.2, Propane
Installation Code and/or local codes. Electrical installation must be in accordance with the current CSA C22.1 Canadian Electrical
Codes Part 1 and/or local codes.
Installation of any gas-fired equipment should be made by a licensed plumber. A manual gas shut-off valve must be installed in the gas
supply line ahead of the ov
In Massachusetts: All g "T" handle type manual
gas valve must be installed
IMPORTANT: R’S USE.
READ AND SA EFERENCE.
OBSERVE ALL
WARNING: If wed exactly, a
fire or explosi ersonal injury
or death.
Do not store or use gasoline or other flammable vapors and liquids in
the vicinity of this or any other appliance.
WHAT TO DO IF YOU SMELL GAS
- Do not light any appliance.
- Do not touch any electrical switch.
- Do not use any phone in your building.
- Immediately call your gas supplier from a neighbor’s phone. Follow
the gas supplier’s instructions.
- If you cannot reach your gas suppliers, call the fire department.
Installation and service must be performed by a qualified installer,
service agency or the gas supplier.
310496
2
WARNING
Read this instruction booklet before installing and using the appliance.
The manufacturer will not be responsible for any damage to property or to persons caused by incorrect
installation or improper use of the appliance.
The manufacturer reserves the right to make changes to its products when considered necessary and useful, without
affecting the essential safety and operating characteristics.
This appliance has been designed for non-professional, domestic use only.
Warning: do not use this appliance to heat a room.
Installation instructions
This appliance shall only be installed by an authorized person. This appliance shall be installed in accordance
with the manufacturer’s installation instructions, IMPORTANT: this appliance must be installed in accordance
with the norms & standards of the country where it will be installed.
The installation of this appliance must conform to local codes and ordinances. In the absence of local codes,
Installations must conforms to American National Standards, National Fuel Gas Code ANSI Z223.1 – latest
edition** or B149.1.
If local codes permit, rtified design, max. 5
feet (1,5 m) long, ½” y line. Do not bend or
damage the flexible c ½” female pipe thread.
The appropriate fittin ne, the flexible metal
connector and the shu
The appliance, when i , in the absence des or
of local codes, with th
The appliance and its ly piping system any
pressure testing of th
The appliance must b manual shutoff valve
during any pressure or less than ½ psi (3.5
kPa).
For use with a pressu e; it shall be properly
installed in order to be accessible when appliance is installed in its final location.
The gas appliance pressure regulator must be set for the gas with which the appliance is used.
This appliance can be used with Natural Gas and LP Gas. It is shipped from the factory adjusted for use with
Natural Gas: CONVERSION FIXED ORIFICES ARE LOCATED IN THE LITERATURE PACK SUPPLIED WITH THE
UNIT.
A gas nozzle kit for the change of type of gas are contained inside the package tigether with the gas
appliance installation kit and instruction booklet.
The maximum inlet gas supply pressure incoming to the gas appliance pressure regulator is 20’’ water column
(5 kPa) .
The minimum gas supply pressure for checking the regulator setting shall be at least 1“ w.c. (249 Pa) above the
inlet specified manifold pressure to the appliance (this operating pressure is 4” w.c. (1.00 kPa) for Natural Gas
and 11” w.c. (2.75 kPa) for LP Gas.
ATTENTION: A manual valve shall be installed in an accessible location in the gas line external to the appliance
for the purpose of turning on or shutting off gas to the appliance
WARNING: Do not use aerosol sprays in the vicinity of this appliance while it is in operation
Requirements
Room ventilation – Location and venting.
ATTENTION: An exhaust fan may be used with the appliance; in each case it shall be installed in conformity with
the national standards in force.
ATTENTION: Exhaust hood operation may affect other vented appliances; in each case it shall be installed in
conformity with the national standards in force.
3
INSTALLATION MANUAL
BACKGUARD INSTALLATION INSTRUCTION
Please follow the following installation instructions afther installing the cooktop:
1) Remove n°2 screws fixing worktop as shown in fig.1
2) Place front part of the backguard and attach it from bottom side with the two removed screws (point 2) as shown
in fig .2
3) Fix the front part of the backguard with the screws supplied with the backguard kit (fig.3)
4) Assemble back part with front part of backguard and fix them with a screw supplied with the backguard kit
(fig.4)
2
3 4
WORKTOP FRONTGUARD INSTALLATION INSTRUCTIONS
In order to increase the clearance between front edge of the worktop and the burners for your safety it is
recomended to install the worktop frontguard supplied with the appliance. For installation instructions follow
the instructions indicated in the following figures

Product specificaties

Merk: Bertazzoni
Categorie: Fornuis
Model: CB36600XLP

Heb je hulp nodig?

Als je hulp nodig hebt met Bertazzoni CB36600XLP stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Fornuis Bertazzoni

Bertazzoni

Bertazzoni PRO105I2EGIT Handleiding

14 November 2024
Bertazzoni

Bertazzoni PRO116L3EROT Handleiding

14 November 2024
Bertazzoni

Bertazzoni PRO64L1EROT Handleiding

14 November 2024
Bertazzoni

Bertazzoni MAS106L2ENET Handleiding

14 November 2024
Bertazzoni

Bertazzoni PRO106L2EBIT Handleiding

14 November 2024
Bertazzoni

Bertazzoni PRO106L3EBIT Handleiding

14 November 2024
Bertazzoni

Bertazzoni PRO115I3EART Handleiding

14 November 2024
Bertazzoni

Bertazzoni PRO106L2ENET Handleiding

14 November 2024
Bertazzoni

Bertazzoni PRO105I3ENET Handleiding

14 November 2024
Bertazzoni

Bertazzoni MAS64I1ENEC Handleiding

14 November 2024

Handleiding Fornuis

Nieuwste handleidingen voor Fornuis

Smeg

Smeg SR764BS Handleiding

21 November 2024
Panasonic

Panasonic KY-W648CLJPQ Handleiding

21 November 2024
Panasonic

Panasonic KY-R64ARLJPQ Handleiding

21 November 2024
AEG

AEG CCX1530ACW Handleiding

21 November 2024
AEG

AEG CCX1530ACM Handleiding

21 November 2024
AEG

AEG CCX1530ACB Handleiding

21 November 2024
Freggia

Freggia HCI32B Handleiding

21 November 2024
Freggia

Freggia HCI32W Handleiding

21 November 2024
Freggia

Freggia HCI64B Handleiding

21 November 2024
Freggia

Freggia HCI64W Handleiding

21 November 2024