BEKO WML 15080 DL Handleiding

BEKO Wasmachine WML 15080 DL

Lees hieronder de 📖 handleiding in het Nederlandse voor BEKO WML 15080 DL (48 pagina's) in de categorie Wasmachine. Deze handleiding was nuttig voor 44 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/48

WML 15040 KL

WML 15050 KL

WML 15060 KL

WML 15060 E

WML 15080 DL

WML 15080 DB

WML 15080 P

WML 15100 P

WML 15100 DB

Washing Machine

Lavadora

Perilica rublja

Пералня машина

2 - EN

1 Warnings

General Safety

• Never place your machine on a

carpet covered floor. Otherwise, lack

of airflow from below of your machine

may cause electrical parts to

overheat. This may cause problems

with your washing machine.

• If the power cable or mains plug is

damaged you must call Authorized

Service for repair.

• Fit the drain hose into the discharge

housing securely to prevent any

water leakage and to allow machine

to take in and discharge water as

required. It is very important that the

water intake and drain hoses are not

folded, squeezed, or broken when

the appliance is pushed into place

after it is installed or cleaned.

• Your washing machine is designed

to continue operating in the event of

a power interruption. Your machine

will not resume its program when

the power restores. Press the

“Start/Pause/Cancel” button for 3

seconds to cancel the program (See,

Canceling a Program)

• There may be some water in your

machine when you receive it. This is

from the quality control process and

is normal. It is not harmful to your

machine.

• Some problems you may encounter

may be caused by the infrastructure.

Press “Start/Pause/Cancel” button

for 3 seconds to cancel the program

set in your machine before calling the

authorized service.

First Use

• Carry out your first washing process

without loading your machine and

with detergent under “Cottons 90°C”

program.

• Ensure that the cold and hot water

connections are made correctly when

installing your machine.

• If the current fuse or circuit breaker is

less than 16 Amperes, please have

a qualified electrician install a 16

Ampere fuse or circuit breaker.

• While using with or without a

transformer, do not neglect to have

the grounding installation laid by a

qualified electrician. Our company

shall not be liable for any damages

that may arise when the machine is

used on a line without grounding.

• Keep the packaging materials out

of reach of children or dispose them

by classifying according to waste

directives.

Intended use

• This product has been designed for

home use.

• The appliance may only be used for

washing and rinsing of textiles that

are marked accordingly.

Safety instructions

• This appliance must be connected to

an earthed outlet protected by a fuse

of suitable capacity.

• The supply and draining hoses must

always be securely fastened and

remain in an undamaged state.

• Fit the draining hose to a washbasin

or bathtub securely before starting up

your machine. There may be a risk of

being scalded due to high washing

temperatures!

• Never open the loading door or

remove the filter while there is still

water in the drum.

• Unplug the machine when it is not in

use.

• Never wash down the appliance with

a water hose! There is the risk of

electric shock!

• Never touch the plug with wet hands.

Do not operate the machine if the

power cord or plug is damaged.

• For malfunctions that cannot be

solved by information in the operating

manual:

• Turn off the machine, unplug it,

turn off the water tap and contact

an authorized service agent. You

may refer to your local agent or

solid waste collection center in your

municipality to learn how to dispose

of your machine.

If there are children in your

house...

• Keep children away from the machine

when it is operating. Do not let them

tamper with the machine.

• Close the loading door when you

leave the area where the machine is

located.

3 - EN

2 Installation

Removing packaging

reinforcement

Tilt the machine to remove the packaging

reinforcement. Remove the packaging

reinforcement by pulling the ribbon.

Opening the transportation locks

A Transportation safety bolts must

be removed before operating the

washing machine! Otherwise, the

machine will be damaged!

1. Loosen all the bolts with a spanner

until they rotate freely (“C”)

2. Remove transportation safety bolts

by turning them gently.

3. Fit the covers (supplied in the bag

with the Operation Manual) into the

holes on the rear panel. (“P”)

C Keep the transportation safety bolts

in a safe place to reuse when the

washing machine needs to be moved

again in the future.

C Never move the appliance without

the transportation safety bolts

properly fixed in place!

Adjusting the feet

A Do not use any tools to loosen the

lock nuts. Otherwise, they can be

damaged.

1. Manually (by hand) loosen the lock

nuts on the feet.

2. Adjust them until the machine stands

level and firmly.

3. Important: Tighten all lock nuts up

again.

Connecting to the water supply.

Important:

• The water supply pressure required

to run the machine must be 1-10 bar

(0,1 – 1 MPa).

• Connect the special hoses supplied

with the machine to the water intake

valves on the machine.

• If you are going to use your double

water-inlet machine as a single (cold)

water-inlet unit, you must install the

stopper*, supplied with your machine

to the hot water valve.

• If you want to use both water inlets

of the product, you can connect the

hot water hose after removing the

stopper and gasket group from the

hot water valve.

* Applies for the products supplied with a

blind stopper group.

• Models with a single water inlet

should not be connected to the hot

water tap.

When returning the appliance to its place

after maintenance or cleaning, care should

be taken not to fold, squeeze or block the

hoses.

Connecting to the drain

The water discharge hose can be attached

to the edge of a washbasin or bathtub. The

drain hose should be firmly fitted into the

drain as to not get out of its housing.

Important:

• The end of the drain hose must be

directly connected to the wastewater

drain or to the washbasin.

• The hose should be attached to a

height of at least 40 cm, and 100 cm

at most.

• In case the hose is elevated after

laying it on the floor level or close

to the ground (less than 40 cm

above the ground), water discharge

becomes more difficult and the

laundry may come out wet.

• The hose should be pushed into the

drainage for more than 15 cm. If it is

Product specificaties

Merk:	BEKO
Categorie:	Wasmachine
Model:	WML 15080 DL

Heb je hulp nodig?

Als je hulp nodig hebt met BEKO WML 15080 DL stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Wasmachine BEKO

BEKO BM1WFU37225WPB Handleiding

18 November 2024

BEKO URBWU59AS Handleiding

18 November 2024

BEKO WRE 7512 XSS Handleiding

15 November 2024

BEKO BFLB1020W Handleiding

14 November 2024

BEKO B3WFU48415WB2 Handleiding

10 November 2024

BEKO B3WFU48415WBPB Handleiding

10 November 2024

BEKO HITY 854310F Handleiding

5 November 2024

BEKO WUE7746XW0 Handleiding

5 November 2024

BEKO WUE6512BWW Handleiding

5 November 2024

BEKO WUE6512XWST Handleiding

5 November 2024

Handleiding Wasmachine

Nieuwste handleidingen voor Wasmachine

Otsein LB LTO129A Handleiding

21 November 2024

Otsein LB LTO109A Handleiding

21 November 2024

Otsein-Hoover LB HV16ESALU Handleiding

21 November 2024

Sangiorgio ST6512EL Handleiding

21 November 2024

Sangiorgio FS614D9 Handleiding

21 November 2024

Sangiorgio PROGETTO F4 Handleiding

21 November 2024

Sangiorgio SG710 Handleiding

21 November 2024

Sangiorgio F814DIBC Handleiding

21 November 2024

Sangiorgio F812D Handleiding

21 November 2024

Sangiorgio F812L Handleiding

21 November 2024