BeamZ S500 Handleiding

BeamZ Verlichting S500

Lees hieronder de 📖 handleiding in het Nederlandse voor BeamZ S500 (11 pagina's) in de categorie Verlichting. Deze handleiding was nuttig voor 35 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/11

Ref. Nr. 160.436

S500

INSTRUCTION MANUAL

GEBRUIKSAANWIJZING

BEDIENUNGSANLEITUNG

NOTICE D’UTILISATION

V1.1

- 2 -

Warning:

- The smokemachine must be placed at least 100 cm away from inﬂammable materials such as curtains,

books, etc. Make sure that the housing cannot be touched by accident.

- For indoor use only.

- During installation, nobody should stand beneath the mounting area.

- Prior to the ﬁrst use, have the unit checked by a qualiﬁed person.

- The unit contains voltage carrying parts. DO NOT open the smokemachine

- Never plug or unplug the unit with wet hands.

- If the plug and/or mains lead are damaged, they need to be repaired by a qualiﬁed technician.

- If the unit is damaged to an extent that you can see internal parts, do not plug the unit into a mains

outlet. It needs to be repaired by a qualiﬁed technician.

- Only connect this unit to an earthed mains outlet of 220- Vac/50Hz . 240

- Always unplug the unit during a thunderstorm or when it is not in use.

- If the unit has not been used for a longer period of time, condensation can occur inside the housing.

Please let the unit reach room temperature prior to use.

- When you unplug the unit from the mains always pull the plug, never the lead.

- In order to prevent dropping of the unit, a safety fastening needs to be installed. This can be a solid

chain, a steel cable, etc. which has to be fastened separately from the mounting bracket.

- The supplied bracket is the main ﬁxing and must be used to solidly mount the light eﬀect.

- In order to avoid accidents in public premises, the local legal requirements and safety

regulations/warnings must be fulﬁlled.

- Keep out of the reach of children.

Safety

Plug the smoke machine only in an earthed mains outlet or extension cord! ATTENTION: the power cord can

only be replaced by an original replacement, supplied by Tronios.

Be careful when ﬁlling the ﬂuid tank. First of all, unplug the mains lead! Then unscrew the cap on the tank and

ﬁll it by means of a funnel.

Only use the original Beamz smoke ﬂuid which is environmental friendly and, if used correctly, leaves no

residues.

Do not obstruct the openings on top of the case to guarantee a good ventilation. The heating element of the

smoke machine generates heat which needs to be removed. Don’t put any objects on the smoke machine.

Installation and Use

Unpack the fog machine. Fill the ﬂuid tank by means of a funnel. Plug the unit into a mains outlet. Thus the

heating element is automatically switched on. Depending on the room temperature, it takes about 3 minutes

until the working temperature is reached. Then the thermostat is clicking and the LED on the manual control

lights up.

Push the switch once and the smoke machine will produce a nice thick fog. Once the smoke machine has

reached its working temperature (the LED is lit) the smoke machine can produce continuously fog during about

1 minute.

After this period of time, the fog generator is cooled so much down that the thermostat switches oﬀ. Wait a few

minutes until the working temperature is reached again. It is recommended to produce smoke with small pauses

in between so that the temperature is maintained and the thermostat doesn’t switch off.

Location

Select a location where it is easy to ﬁll the tank. It is also possible to hang the unit by means of the supplied

holder and ﬁxing screws.

Switching the unit oﬀ

Switch the unit off by unplugging it from the mains. Otherwise the 500W heating element will draw unnecessarily

current.

- 3 -

Speciﬁcations

Power supply: ........................................................... 230V~/50Hz

Heating element: ........................................................... 500 watts

Heat up time: 3 minutes ................................................................

Continuous use: ................................................... Max. 2 minutes

Smoke production: ............................................ ca. 50 m3/minute

Tank capacity: ............................................................. 250 mliters

Dims: ................................................................ 140X160X250mm

Weight ................................................................................. 1.8 kg

Accessories

Smoke ﬂuid, high quality ﬂuid on water basis, specially designed for Beamz smoke machines. Guarantees a

trouble-free use.

5 liter packaging, ref. no. 160.582 160.583 160.586

1 liter packaging, ref. no. 160.643 160.644

Flavor, adds a pleasant fragrance to the air. One bottle is suﬃcient for 5 liter smoke ﬂuid.

coconut 160.650 tropical 160.653

mint strawberry 160.654 160.651

vanilla 160.652 energizer 160.655

Electric products must not be put into household waste. Please bring them to a recycling centre. Ask your local

authorities or your dealer about the way to proceed.

Do not attempt to make any repairs yourself. This would invalid your warranty.Do not make any changes to the unit. This would also

invalid your warranty.The warranty is not applicable in case of accidents or damages caused by inappropriate use or disrespect of the

warnings contained in this manual.Tronios BV cannot be held responsible for personal injuries caused by a disrespect of the safety

recommendations and warnings. This is also applicable to all damages in whatever form.

Product specificaties

Merk:	BeamZ
Categorie:	Verlichting
Model:	S500
Kleur van het product:	Zwart
Gewicht:	1850 g
Snoerlengte:	3 m
Vermogen:	500 W
Afstandsbediening:	Bedraad
Op afstand bedienbaar:	Ja
Opwarmtijd:	4 min
Productafmetingen (B x H x D):	245 x 130 x 135 mm
AC-ingangsspanning:	230 V
AC-ingangsfrequentie:	50 Hz
Vloeistoftank capaciteit:	0.25 l
Hoeveelheid rook uitstoot:	50 m³/min
Bedrijfsvloeistof:	Water