BeamZ ICE1200 MKII 160.515 Handleiding

BeamZ Effect machine ICE1200 MKII 160.515

Lees hieronder de 📖 handleiding in het Nederlandse voor BeamZ ICE1200 MKII 160.515 (11 pagina's) in de categorie Effect machine. Deze handleiding was nuttig voor 42 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/11

Ref. № 160.515

ICE FOGGER

ICE 1200 MKII

INSTRUCTION MANUAL

GEBRUIKSAANWIJZING

BEDIENUNGSANLEITUNG

- 2 -

- 3 -

Warning:

- The smokemachine must be placed at least 100 cm away from inflammable materials such as curtains,

books, etc. Make sure that the housing cannot be touched by accident.

- Use only Beamz water-based smoke uid recommended by your dealer.

- Poor smoke liquid caused permanent damage, bad eect, clogging, spitting of unevaporated liquid etc.

- Never add flammable fluids (oil, gas, perfume) to the fog liquid.

- Always keep enough smoke liquid in the tank.

Use of the device without liquid will cause damage to the pump and heater.

- Do not obstruct the openings on top of the case to guarantee a good ventilation.

- Don’t put any objects on the smoke machine.

- For indoor use only.

- During installation, nobody should stand beneath the mounting area.

- Prior to the first use, have the unit checked by a qualified person.

- The unit contains voltage carrying parts. DO NOT open the smokemachine

- Never plug or unplug the unit with wet hands.

- If the plug and/or mains lead are damaged, they need to be repaired by a qualied technician.

- If the unit is damaged to an extent that you can see internal parts, do not plug the unit into a mains outlet. It

needs to be repaired by a qualied technician.

- Only connect this unit to an earthed mains outlet of 220-240Vac/50Hz .

- Always unplug the unit during a thunderstorm or when it is not in use.

- If the unit has not been used for a longer period of time, condensation can occur inside the housing. Please

let the unit reach room temperature prior to use.

- When you unplug the unit from the mains always pull the plug, never the lead.

- In order to prevent dropping of the unit, a safety fastening needs to be installed. This can be a solid chain, a

steel cable, etc. which has to be fastened separately from the mounting bracket.

- The supplied bracket is the main xing and must be used to solidly mount the light effect.

- In order to avoid accidents in public premises, the local legal requirements and safety regulations/warnings

must be fulfilled.

- Keep out of the reach of children.

Location

Select a location where it is easy to ll the tank. It is also possible to hang the unit by means of the supplied

holder and xing screws.

Installation and Use

Unpack the fog machine. Do not connect yet the net cable. Connect the lead of the manual control with the 3-

pin plug at the rear of the smoke machine. Fill the fluid tank by means of a funnel. Fill the ice tray with ordinary

ice. Close the drain valve o. (Once ice has melted, you can drain the water here.) When the machine is lled

with ice, the lid can be closed.

Attention:Drain the water, melted ice regularly. (approximately every 45 minutes)

Plug the unit into a mains outlet. Thus the heating element is automatically switched on. Depending on the room

temperature, it takes about 5 minutes until the working temperature is reached. Then the thermostat is clicking

and the LED on the manual control lights up. Push the switch once and the smoke machine will produce a nice

thick fog. Once the smoke machine has reached its working temperature (the LED is lit) the smoke machine can

produce fog for a while. After this period of time, the fog generator is cooled so much down that the thermostat

switches o. Wait a while until the working temperature is reached again. It is recommended to produce smoke

with small pauses in between so that the temperature is maintained and the thermostat doesn’t switch o.

Make sure that there is always enough liquid smoke contained in the tank. Use of the smoke machine without

liquid can permanently damage the unit. Once the smoke machine generates little smoke or pump generate

another 'rattling' sound i turn o the unit direct. Check the uid level and fill the tank when it is empty, check the

hose and lter blockages and restore it. Plug in the unit and check if the problem is resolved. If problem persists,

switch unit direct o to prevent further damage and contact your dealer.

Switching the unit o

Switch the unit off by unplugging it from the mains. Otherwise the 1200W heating element will draw

unnecessarily current.

Product specificaties

Merk:	BeamZ
Categorie:	Effect machine
Model:	ICE1200 MKII 160.515
Kleur van het product:	Black,Grey
Gewicht:	7900 g
Snoerlengte:	3 m
Vermogen:	1200 W
Afstandsbediening:	Bedraad
Op afstand bedienbaar:	Ja
Opwarmtijd:	5 min
Productafmetingen (B x H x D):	435 x 335 x 255 mm
AC-ingangsspanning:	220-240 V
AC-ingangsfrequentie:	50 Hz
Vloeistoftank capaciteit:	0.9 l
Hoeveelheid rook uitstoot:	125 m³/min
Bedrijfsvloeistof:	Water