Baumr-AG 550CX Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Baumr-AG 550CX (25 pagina's) in de categorie Grasmaaier. Deze handleiding was nuttig voor 61 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/25
THE BATTERY MAY A H VE SOME CHARGE ON ARRIVAL, IT IS IMPORTANT
HOWEVER THAT THE BATTERY T IS CHARGED PRIOR O USE.
User Manual
[ 6 ]Revision .0 May 2023
READ THIS MANUAL CAREFULLY BEFORE USE FAILURE TO DO SO MAY RESULT IN INJURY, PROPERTY DAMAGE AND MAY –
VOID WARRANTY. • KEEP THIS MANUAL FOR FUTURE REFERENCE. • Products covered by this manual may vary in appearance,
assembly, inclusions, specifications, description, and packaging.
550CX Electric Lawn Mower Kit
E&OE © -AG 2 2023 Baumr
Safety
Safety messages are designed to alert you to possible dangers or hazards that could cause death, injury or
equipment or property damage if not understood or followed. Safety messages have the following symbols:
You WILL be KILLED or
SERIOUSLY INJURED if you do
not follow instructions.
You CAN be KILLED or
SERIOUSLY INJURED if you do
not follow instructions.
You CAN be INJURED if you do
not follow instructions or equipment
damage may occur.
It is vital that you read and understand this
user manual before using the product,
including safety warnings, and any assembly
and operating instructions. Keep the manual
for future reference.
Safety precautions and recommendations
detailed here must be fully understood and
followed to reduce the risk of injury, fire,
explosion, electrical hazard, and/or property
damage.
Safety information presented here is generic
in nature – some advice may not be
applicable to every product. The term
"equipment" refers to the product, be it
electrical mains powered, battery powered or
combustion engine powered.
• - If you are not familiar with the Before Use
safe operation/handling of the equipment or
are in any way unsure of any aspect of
suitability or correct use for your
application, you should complete training
conducted by a person or organization
qualified in safe use and operation of this
equipment, including fuel/electrical handling
and safety.
• Do NOT operate the equipment in
flammable or explosive environments, such
as in the presence of flammable liquids,
gases, or dust. The equipment may create
sparks or heat that may ignite flammable
substances.
• Keep clear of moving parts.
• Equipment may be a potential source of
electric shock or injury if misused.
• Do NOT operate the equipment if it is
damaged, malfunctioning or is in an
excessively worn state.
• Do NOT allow others to use the equipment
unless they have read this manual and are
adequately trained.
• Keep packaging away from children - risk
of suffocation! Operators must use the
equipment correctly. When using the
equipment, consider conditions and pay
due care to persons and property.
General Work Area Safety
• Work areas should be clean and well it.
• Do not operate the equipment if
bystanders, animals etc are within
operating range of the equipment or the
general work area.
• If devices are provided for connecting dust
extraction / collection facilities, ensure
these are connected and used properly.
Dust collection can reduce dust-related
hazards.
General Personal Safety
• Wear appropriate protective equipment
when operating, servicing, or when in the
operating area of the equipment to help
protect from eye and ear injury, poisoning,
burns, cutting and crush injuries. Protective
equipment such as safety goggles,
respirators, non-slip safety footwear, hard
hat, hearing protection etc should be used
for appropriate equipment / conditions.
Other people nearby should also wear
appropriate personal protective equipment.
Do not wear loose clothing or jewellery,
which can be caught in moving parts. Keep
hair and clothing away from the equipment.
• Stay alert and use common sense when
operating the equipment. Do not over-
reach. Always maintain secure footing and
balance.
• Do not use the equipment if tired or under
the influence of drugs, alcohol, or
medication.
• This equipment is not intended for use by
persons with reduced physical, sensory, or
mental capabilities.
General Fuel Safety
• Petrol/fuel/gasoline is extremely flammable
– keep clear of naked flames or other
ignition sources.
• Do not spill fuel. If you spill fuel, wipe it off
the equipment immediately – if fuel gets on
your clothing, change clothing.
• Do NOT smoke near fuel or when
refuelling.
• Always shut off the engine before
refuelling.
• Do NOT refuel a hot engine.
• Open the fuel cap carefully to allow any
pressure build-up in the tank to release
slowly.
• Always refuel in well ventilated areas.
• Always check for fuel leakage. If fuel
leakage is found, do not start, or run the
engine until all leaks are fixed.
General Carbon-Monoxide Safety
• Using a combustion engine indoors CAN
KILL IN MINUTES. Engine exhaust
contains carbon-monoxide – a poison you
cannot smell or see.
• Use combustion engines OUTSIDE only,
and far away from windows, doors, and
vents.
General Equipment Use and Care
• The equipment is designed for domestic
use only.
• Handle the equipment safely and carefully.
• Before use, inspect the equipment for
misalignment or binding of moving parts,
loose components, damage, or any other
condition that may affect its operation. If
damaged, have the equipment repaired by
an authorised service centre or technician
before use.
• Prevent unintentional starting of the
equipment - ensure equipment and power
switches are in the OFF position before
connecting or moving equipment. Do not
carry equipment with hands or fingers
touching any controls. Remove any tools or
other items that are not a part of the
equipment from it before starting or
switching on.
• Do not force the equipment. Use the
correct equipment for your application.
Equipment will perform better and be safer
when used within its design and usage
parameters.
• Use the equipment and accessories etc. in
accordance with these instructions,
considering working conditions and the
work to be performed. Using the equipment
for operations different from those intended
could result in hazardous situations.
• Always keep equipment components
(engines, hoses, handles, controls, frames,
housings, guards etc) and accessories
(cutting tools, nozzles, bits etc) properly
maintained. Keep the equipment clean and,
where applicable, properly lubricated.
• Store the equipment out of reach of
children or untrained persons. To avoid
burns or fire hazards, let the equipment
cool completely before transporting or
storing. Never place or store the equipment
near flammable materials, combustible
gases, or liquids etc.
• The equipment is not weather-proof, and
should not be stored in direct sunlight, at
high ambient temperatures or locations that
are damp or humid.
• Do not clean equipment with solvents,
flammable or harsh abrasives. liquids,
• For specific equipment safety use and care,
see Equipment Safety.
550CX Electric Lawn Mower Kit
E&OE © -AG 3 2023 Baumr
General Electrical Safety
• Inspect electrical equipment, extension
cords, power bars, and electrical fittings for
damage or wear before each use. Repair or
replace damaged equipment immediately.
• Ensure all power sources conform to
equipment voltage requirements and are
disconnected before connecting or
disconnecting equipment.
• When wiring electrically powered
equipment, follow all electrical and safety
codes.
• Wherever possible, use a residual current
device (RCD).
• High voltage / high current power lines may
be present. Use extreme caution to avoid
contact or interference with power lines.
Electrical shock can be fatal.
General Electrical Safety
• Electrically grounded equipment must have
an approved cord and plug and be
connected to a grounded electrical outlet.
• Do NOT bypass the ON/OFF switch and
operate equipment by connecting and
disconnecting the electrical cord.
• Do NOT use equipment that has exposed
wiring, damaged switches, covers or
guards.
• Do NOT use electrical equipment in wet
conditions or in damp locations.
• Do NOT use electrical cords to lift, move or
carry equipment.
• Do NOT coil or knot electrical cords, and
ensure electrical cords are not trip hazards.
General Service Information
• The equipment must be serviced or
repaired at authorised service centres by
qualified personnel only.
• Replacement parts must be original
equipment manufacturer (OEM) to ensure
equipment safety is maintained.
• Do NOT attempt any maintenance or repair
work not described in this manual.
• After use, the equipment and components
may still be hot – allow the equipment to
cool and disconnect spark plugs and/or
electrical power sources and/or batteries
from it before adjusting, changing
accessories, or performing repair or
maintenance.
• Do NOT adjust while the equipment is
running.
• Perform -related service activities in suitable
conditions, such as a workshop.
• Replace worn, damaged or missing
warning/safety labels immediately.
VIBRATION WARNINGS
• ! The specified sound level values are emission values and do not indicate safe working environment values. Although there is a link CAUTION
between emission and noise levels, the ratio is not reliable as an indicator of whether additional safety measures are necessary or not. Factors
that are specific to a workplace can affect the noise level, such as the length of the activity, the characteristics of the workplace, other sound
sources, etc., such as the number of machines and other related activities. This information should nevertheless provide a better estimate of
possible hazards and risks.
• Measurement method: EN 60335-2-77
• .5 m/ Handle vibrations: ≤ 2 s2
• Uncertainty K: 1.5m/s2
• Declared vibration level has been measured in accordance with a standardized measurement method and can be used for comparison between
different machines. The total value can be used in a preliminary assessment of the exposure.
• ! The vibration value during actual use may differ from the declared total value, depending on how the machine is used. The need to CAUTION
identify your safety measures to protect the operator is based on an estimate of the exposure under actual working conditions with regard to the
time when the machine is operating or switched off.
AREA OF USE
• The electric lawn mower is brushless and battery-powered, intended for one or two parallel-connected battery packs. It is designed for regular
mowing of small, medium, and even grass surfaces. It is equipped with a steel deck, collector, and protective devices such as key locks and dead
man's grips.
• The electric lawn mower may only be used together with battery packs and battery chargers from the supplier.
• The lawnmower must not be rebuilt, must be used for work other than that for which it is designed. It is not intended for professional use.
SAFETY INSTRUCTIONS FOR ELECTRIC LAWN MOWERS
• Read all safety instructions, instructions, illustrations, and specifications provided with this power tool. Failure to follow all instructions WARNING
below may result in electric shock, fire and / or serious injury.
• Save all safety instructions and instructions for future reference.
• The term "power tools" in the safety regulations refers to your / your mains-powered / battery- -held and transportable power tools powered hand
or garden machine.
• Keep the workplace clean and well lit. Messy or dark workplaces invite accidents.
• Never use power tools in an explosive environment, such as near flammable liquids, gases, or dust. Power tools can create sparks that can ignite
dust and fumes.
• Keep children and spectators at a distance when using power tools. Disorders and lack of concentration can cause you to lose control.
PERSONAL SAFETY
• Pay attention, concentrate on what you are doing and use common sense when working with a power tool. Do not use the power tool when you
are tired or under the influence of drugs, alcohol, or medication. One moment of inattention when using power tools can result in serious personal
injury.
• Use personal protective equipment. Always wear safety goggles. Protective equipment such as a dust mask, non-slip safety shoes, helmet or
hearing protection used in certain circumstances reduces the risk of personal injury.
• Prevent accidental start. Make sure that the switch is in the OFF position before connecting the plug to the power source and / or the battery
pack, when lifting or when carrying the power tool. Carrying a power tool with the finger on the switch or supplying the power tool with power
when the switch is in the ON position invites an accident.


Product specificaties

Merk: Baumr-AG
Categorie: Grasmaaier
Model: 550CX

Heb je hulp nodig?

Als je hulp nodig hebt met Baumr-AG 550CX stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Grasmaaier Baumr-AG

Handleiding Grasmaaier

Nieuwste handleidingen voor Grasmaaier

Anova

Anova MTC620 Handleiding

22 December 2024
Anova

Anova MC100 Handleiding

22 December 2024
Anova

Anova CC146T Handleiding

20 December 2024
Anova

Anova E60BC Handleiding

20 December 2024
Anova

Anova CC151T Handleiding

20 December 2024
Gude

Gude 320/20-4 Handleiding

19 December 2024
Zipper

Zipper ZI-MOS4T Handleiding

19 December 2024
Ozito

Ozito CPM-300C Handleiding

10 December 2024
Powerblade

Powerblade 350CX Handleiding

10 December 2024
Powerblade

Powerblade V475 Handleiding

10 December 2024