Bauknecht WAT Uniq 610 FLD Handleiding

Bauknecht Wasmachine WAT Uniq 610 FLD

Lees hieronder de đź“– handleiding in het Nederlandse voor Bauknecht WAT Uniq 610 FLD (19 pagina's) in de categorie Wasmachine. Deze handleiding was nuttig voor 30 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/19
CONTENTS
DEFINITION OF USE
BEFORE USING THE WASHING MACHINE
PRECAUTIONS AND GENERAL
RECOMMENDATIONS
DESCRIPTION OF THE WASHING MACHINE
BEFORE THE FIRST WASH CYCLE
PREPARATION OF THE WASHING
DETERGENTS AND ADDITIVES
CLEANING THE FILTER/
DRAINING RESIDUAL WATER
CARE AND MAINTENANCE
TROUBLESHOOTING GUIDE
AFTER-SALES SERVICE
TRANSPORT AND HANDLING
INSTALLATION
ELECTRICAL CONNECTION
IFU-TL HR GB.fm Page 1 Friday, November 7, 2008 2:30 PM
Black process 45.0° 100.0 LPI
GB 2
DEFINITION OF USE
This washing machine is exclusively destined to wash
machine washable laundry in quantities which are usual
for private households.
•Observe the instructions given in these Instructions
for Use and the Programme Chart when using the
washing machine.
•Keep these Instructions for Use and the Programme
Chart; if you pass on the washing machine to
another person, also give him/her Instructions for
Use and Programme Chart.
BEFORE USING THE WASHING MACHINE
1. Remove the packaging and check
a. Cut and remove the shrink-wrap.
b.Remove the top protection and the protective
corners.
c. Remove the bottom protection by tilting and
turning the washing machine on one rear
bottom corner. Make sure that the black
plastic part of the bottom protection (if
available on the model) remains in the packing
and not in the machine bottom.
This is important, as otherwise the plastic part could
damage the washing machine during operation.
d.Open the lid by pressing it slightly down while
raising the handle. Remove the polystyrene cushion
(depending on model).
e. Remove the blue protective film from the panel
(depending on model).
•After unpacking, make sure that the washing machine is
undamaged. If in doubt, do not use the washing machine.
Contact After-Sales Service or your local retailer.
•Keep the packaging materials (plastic bags,
polystyrene parts, etc.) out of reach of children;
they are potentially dangerous.
•If the appliance was exposed to the cold prior to
delivery, keep it at room temperature for a few
hours before operating.
2. Remove the transport bracket
•The washing machine is fitted with transport screws
and a transport bracket to prevent damage during
transport. Before using the washing machine
you must remove the transport bracket (see
“Installation”/“Removal of transport bracket”).
3. Install the washing machine
•Place the washing machine on a flat and stable floor
surface.
• Adjust the feet to ensure that the machine is stable
and level (see “Installation”/“Adjust the feet”).
•In case of wooden or so-called “floating floors” (for
instance certain parquet or laminate floors), place
the appliance on a 40 x 60 cm sheet of plywood at
least 3 cm in thickness which is secured to the floor.
•Make sure that the ventilation openings in the base
of your washing machine (if available on your model)
are not obstructed by a carpet or other material.
4. Water supply
•Connect the water supply inlet hose in accordance
with the regulations of your local water company
(see “Installation”/“Connect the water inlet hose”).
•Water supply: Cold water only
•Tap: 3/4” threaded hose connection
•Pressure: 100-1000 kPa (1-10 bar).
•Only use new hoses for connecting the washing
machine to the water supply. Used hoses must not
be used anymore and should be discarded.
5. Drain hose
•Connect the drain hose to the siphon or hook it
over the edge of a sink with the “U” bend (see
“Installation”/“Connect the water drain hose”).
•If the washing machine is connected to a built-in
drainage system, ensure the latter is equipped with
a vent to avoid simultaneous loading and draining of
water (siphoning effect).
6. Electrical connection
•Electrical connections must be carried out by a
qualified technician in compliance with the
manufacturer’s instructions and the current
standard safety regulations.
•The technical data (voltage, power and fuses) are given
on the rating plate on the rear of the washing machine.
•The washing machine must be connected exclusively by
means of a socket with an earth connection in
accordance with current regulations. The washing
machine must be earthed by law. The manufacturer
declines all liability for injury to persons or animals or
damage to property deriving directly or indirectly from
failure to observe the directions.
•Do not use extension leads or multi sockets.
•Before any maintenance on the washing machine
disconnect it from the mains supply.
•Access to the mains plug or to disconnection from the
mains supply via a double-pole switch must be ensured
at all times following the installation.
•Do not operate the washing machine if it has been
damaged during transport. Inform the After-Sales Service.
•Mains cable replacement is only to be carried out by
After-Sales Service.
•The washing machine must be connected to an effective
earthing installation, in compliance with the regulations
in force. In particular, washing machines installed in
premises containing a shower or a bath must be
protected by a differential residual current device of at
least 30 mA. Earthing the washing machine is obligatory
under the law. The manufacturer declines all liability for
injury to persons or animals or damage to property
deriving either directly or indirectly from failure to
observe the directions in these Instructions for Use.
•The washing machine may only be used in the
household for the prescribed uses.
Dimensions:
Width: 400 mm
Height: 900 mm
Depth: 600 mm
IFU-TL HR GB.fm Page 2 Friday, November 7, 2008 2:30 PM
Black process 45.0° 100.0 LPI
GB 3
PRECAUTIONS AND GENERAL
RECOMMENDATIONS
1.Safety instructions
•The washing machine is appropriate for indoor
use only.
•Do not store flammable fluids near the appliance.
•Do not place electrical appliances on the lid of
your washing machine.
•Children must be supervised to ensure that they
do not play with the appliance.
•This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.
•Do not attempt to force the lid open.
•If necessary, the power cable may be replaced
with an identical one obtained from our After-
Sales Service. The power cable must only be
replaced by a qualified technician.
2.Packing
•The packaging materials are 100% recyclable and
bear the recycling symbol . Adhere to local
regulations when disposing of packaging material.
3.Disposing of packaging and old washing
machines
•This appliance is marked according to the
European directive 2002/96/EC on Waste
Electrical and Electronic Equipment (WEEE).
By ensuring this product is disposed of correctly,
you will help prevent potential negative
consequences for the environment and human
health, which could otherwise be caused by
inappropriate waste handling of this product.
The symbol on the product, or on the
documents accompanying the product, indicates
that this appliance may not be treated as
household waste. Instead it shall be handed over
to the applicable collection point for the recycling
of electrical and electronic equipment.
Disposal must be carried out in accordance with
local environmental regulations for waste disposal.
For more detailed information about treatment,
recovery and recycling of this product, please
contact your local city office, your household
waste disposal service or the shop where you
purchased the product.
•The washing machine is built from reusable
materials. It must be disposed of in compliance
with current local waste disposal regulations.
•Before scrapping, cut off the power cable so that the
washing machine cannot be connected to the mains.
•Remove detergent from compartment if you
intend scrapping your washing machine.
4.Energy saving tips
•Achieve the best use of energy, water, detergent
and time by using the recommended maximum
load size.
•Do not exceed the detergent dosages indicated
in the manufacturer’s instructions.
•The Eco Ball - a special system in the outlet - will
prevent detergent loss from the drum to avoid
detergent loss into the environment.
•Use “Prewash” (if available on your model) for
heavily soiled laundry only! Save detergent, time,
water and energy consumption by not selecting
“Prewash” for slightly to normally soiled laundry.
•Pretreat stains with stain remover or soak dried
in stains in water before washing to reduce the
necessity of a hot wash program.
•Save energy by using a 60° C instead of a 95° C
wash programme or a 40° C instead of a 60° C
wash programme.
•Save energy and time by selecting a high spin
speed to reduce the water content in laundry
before using a tumble dryer (for machines with
adjustable spin speed).
5.General recommendations
•Do not leave the washing machine connected
when not in use. Turn off the tap.
•Before cleaning or carrying out maintenance
switch off the washing machine and disconnect it
from the mains supply.
6.EC Declaration of Conformity
•This washing machine has been designed,
constructed and distributed in compliance with
the safety requirements of EC Directives:
2006/95/EC Low Voltage Directive
2004/108/EC Electromagnetic Compatibility
Directive
IFU-TL HR GB.fm Page 3 Friday, November 7, 2008 2:30 PM
Black process 45.0° 100.0 LPI


Product specificaties

Merk: Bauknecht
Categorie: Wasmachine
Model: WAT Uniq 610 FLD

Heb je hulp nodig?

Als je hulp nodig hebt met Bauknecht WAT Uniq 610 FLD stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Wasmachine Bauknecht

Handleiding Wasmachine

Nieuwste handleidingen voor Wasmachine