Bauknecht KSN 495/1 IO Handleiding

Bauknecht Koelkast KSN 495/1 IO

Lees hieronder de 📖 handleiding in het Nederlandse voor Bauknecht KSN 495/1 IO (6 pagina's) in de categorie Koelkast. Deze handleiding was nuttig voor 57 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/6

Clean the appliance regularly using a new cloth and a solution of lukewarm water and neutral detergent

specific for cleaning inside refrigerators. Never use abrasive detergents.

Do not use steam cleaners. Clean the condenser using a vacuum cleaner, after removing the front plinth

(see Installation manual).

The buttons and control panel display (in some models, located on the freezer door) must not be cleaned

with alcohol or alcohol-derived substances, but with a dry cloth.

Replacing the bulbs

Important:

• Always disconnect the refrigerator from the power supply before

replacing any light bulbs.

• Before replacing the bulb, remove the lamp cover (if present). After

the bulb has been replaced, refit the lamp cover.

• Internal lights are bayonet bulbs.

• The ice and water dispenser light, if present, is a normal screw bulb

although some models may have a LED light.

• LED lights last longer than normal bulbs, they illuminate the inside of

the appliance better and are more environmentally friendly.

Only use bulbs of the same type which can be requested from the after-sales service and authorized

dealers.

If the appliance has a LED light, contact the after-sales service when a replacement is required.

APPLIANCE MAINTENANCE

AND CLEANING

When the appliance is connected to the power supply, the display will show the factory preset

temperatures (-18°C and +5°C).

If the acoustic signal sounds and the temperature indicator blinks, press and hold the alarm mute button.

Note: After being switched on, the appliance needs approximately 2/3 hours to reach the correct

temperature to store a typical volume of food.

As applicable, insert the anti-bacterial and anti-odour filter as indicated on the filter package.

FIRST USE

Disconnect the appliance from the power supply. Empty the appliance and leave the doors open just

enough to allow air to circulate inside the compartments. This will prevent the formation of mould and

bad odours. If your appliance has an automatic ice maker:

1. Shut off the water supply to the product.

2. Empty the ice bucket.

DURING BLACKOUTS

For power failures lasting up to 12 hours, keep the doors of the appliance closed. In this way the stored

food will stay cold as long as possible.

Should the power failure last more than 12 hours, remove all food from the product and store it in a

suitable appliance.

WHEN THE APPLIANCE IS NOT USED

See the Installation Manual for instructions on how to connect to the mains water supply.

To dispense water:

Water delivery is always available. Press a glass against the water dispenser lever. Water delivery stops

when the lever is released. On models that don't have this lever, press the "Water" button . Water

delivery stops when the lever/button is released.

To dispense ice:

To obtain ice press against the ice dispenser lever. On models that don't have this lever, press the "Ice"

button . Water delivery stops when the lever/button is released.

Useful tips:

1. Keep the glass near the water/ice dispenser outlet.

2. To start dispensing, just press lightly against the lever or press and hold the "Water" / "Ice" buttons

(in models that don't have a water/ice lever). Pressing hard will not result in faster dispensing or greater

quantities.

3. To stop dispensing, remove the glass slowly so that ice does not fall outside the glass (in models with

water/ice levers.)

4. Do not use fragile or easily breakable glasses (in models with water/ice levers).

5. The water dispensed should be consumed within 6 hours.

6. If the water/ice dispenser is only used ccasionally or has been left unused for some time with the

appliance switched on, the circuit will need to be cleaned and the first 2 litres of water drawn off and

the first ice produced thrown away. Repeat this procedure when the product is reconnected to the

power supply after prolonged disuse.

The anti-condensation devices can be disabled by pressing the switch

shown in the figure on the right (switch in position OFF). This allows

you to optimise energy consumption.

If there is condensation in the ice/water dispenser area or on the door,

reactivate the anti-condensation devices (switch in position ON).

USING THE ICE AND WATER DISPENSER

(if installed)

Failure to follow the instructions regarding sanitizing can compromise the hygienic safety of the

water dispensed.

• When using the appliance for the first time and every time the filter is changed, discard the first 9-14

litres of water, equivalent to 6-7 minutes of dispensing (not necessarily consecutive, but before initial

consumption) and discard the ice produced in the first 24 hours.

• If the water dispenser has not been used for more than 4/5 days, it is advisable to clean the circuit and

run off the first litre of water.

• Reposition the removable water dispenser (if present), ensuring your hands are hygienically clean.

• Clean the ice bucket or drawer regularly but using only drinking water.

• The filter must be changed when indicated on the control panel or when the ice/water dispenser has

not been used for more than 30 days.

• Every time the filter is changed, it is a good idea to always sanitise the water dispensing system with

food-grade disinfectant solutions (sodium hypochlorite based) which do not alter the characteristics of

the materials. Rinse with at least 2 litres of water before use.

• Only original spare parts supplied by the manufacturer should be used when replacing components in

the ice and water dispenser.

• Any work on the appliance must be carried out by a qualified technician or the After-sales Service.

CLEANING, SANITIZATION AND

MAINTENANCE OF THE ICE AND/OR

WATER DISPENSER (if present)

After switching on the refrigerator, it usually takes a full night for the first ice cubes to form. When

selecting crushed ice (on some models only - see the Quick Start Guide), the cubes are crushed just

before being dispensed, therefore the crushed ice may come out with a slight delay. Noise from the ice

crusher is normal, and pieces of ice may vary in size. When changing from crushed ice to ice cubes, a small

amount of crushed ice may come out together with the first cubes.

The quantity and size of the ice cubes depend on the mains water pressure. Ice cubes production can be

increased by decreasing the freezer compartment temperature setting.

VERSION WITH ICE TRAY

Normal ice production is 7 to 8 batches of ice cubes over a 24 hour period.

Large amounts of ice cubes should be taken directly from the bucket, and not

from the dispenser. It is recommended that the drawer is closed after completing

the operation.

VERSION WITH ICE MAKER IN THE FREEZER COMPARTMENT AND

ICE BUCKET ON THE DOOR

Normal ice production is 12 to 14 batches of ice cubes over a 24 hour period.

To remove and refit the ice bucket

Insert your fingers in the opening at the

bottom of the container, pull the lever and

lift and extract the container (see figure 1).

On some models, you need to insert your

fingers into the opening at the bottom of the

container and place your thumb on the

release button (see figure 2) to remove the

container. Hold the base of the bucket with

both hands, press the release button and lift

the bucket up and out.

To re-insert the ice bucket, place it onto its

support attached to the inner door and

lower into position.

Note: If you need a large amount of ice cubes, take them directly from the bucket and not from the

dispenser.

VERSION WITH ICE MAKER AND BUCKET ON THE FREEZER DOOR

With the door closed, normal ice production is 6 to 7 batches of ice cubes over a 24 hour period.

Ice cube production depends to a large extent on how often the door is opened, the amount of fresh food

placed in the freezer compartment, the ambient temperature and the temperature set. If the ice maker

has not been used for a long time, it will take a full night for the first ice cubes to form.

Removing and refitting the ice bucket

Insert your fingers into the opening at the bottom of the ice bucket, pull the

lever then lift and extract the bucket (see figure 3).

To re-insert the ice bucket, place it onto its support attached to the inner

door and lower into position.

Note: For large amounts of ice, enable the "Fast Freezing" function (see the

Quick Start guide). If you need a large amount of ice cubes, take them

directly from the bucket and not from the dispenser.

Important: Turn the ice maker off before removing the ice bucket to

stop ice cubes being dispensed accidentally.

Use only drinking water for the regular cleaning of the ice maker cover.

USING THE AUTOMATIC ICE MAKER

(if installed)

figure 1 figure 2

figure 3

Product specificaties

Merk:	Bauknecht
Categorie:	Koelkast
Model:	KSN 495/1 IO
Apparaatplaatsing:	Vrijstaand
Kleur van het product:	Roestvrijstaal
Ingebouwd display:	LED
Gewicht:	95500 g
Breedte:	902 mm
Diepte:	740 mm
Hoogte:	1770 mm
Netbelasting:	- W
Ijsmaker:	Nee
Snoerlengte:	2.45 m
Geluidsniveau:	45 dB
Jaarlijks energieverbruik:	486 kWu
Energie-efficiëntieklasse (oud):	A+
Brutocapaciteit vriezer:	- l
Nettocapaciteit vriezer:	207 l
Vriescapaciteit:	12 kg/24u
Verlichting binnenin:	Ja
Ontdooifunctie:	Ja
Nettocapaciteit koelkast:	335 l
Brutocapaciteit koelkast:	- l
Aantal planken koelkast:	4
Bewaartijd bij stroomuitval:	5 uur
Snelvriesfunctie:	Ja
Aantal sterren:	4*
Totale nettocapaciteit:	542 l
Eierenrekje:	Ja
Flessenrek:	Ja
No Frost system:	Ja
Totale brutocapaciteit:	- l
Vers zone compartiment:	Nee
Klimaatklasse:	T
Multi-luchtwegsysteem:	Ja
IJsblokjes-lade:	Ja
Diepte wanneer de deur open is:	1280 mm
Luchtfilter:	Ja
Antibacteriële functie:	Ja
AC-ingangsspanning:	220 - 240 V
Ijsblokjeshouder:	Ja