Bauknecht BSZ 4002 WS Handleiding

Bauknecht Oven BSZ 4002 WS

Lees hieronder de 📖 handleiding in het Nederlandse voor Bauknecht BSZ 4002 WS (9 pagina's) in de categorie Oven. Deze handleiding was nuttig voor 66 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/9
12
GB TABLE OF CONTENTS
INSTALLATION PAGE 13
ELECTRICAL CONNECTION PAGE 14
BEFORE USING THE OVEN PAGE 15
PROTECTING THE ENVIRONMENT PAGE 15
PRECAUTIONS AND GENERAL
RECOMMENDATIONS PAGE 15
OVEN ACCESSORIES PAGE 16
COOKING CHART PAGE 17
CLEANING THE OVEN AND ACCESSORIES PAGE 18
TROUBLESHOOTING GUIDE PAGE 19
AFTER-SALES SERVICE PAGE 20
DECLARATION OF CONFORMITY CE PAGE 20
13
Technical information for the installer
•After removing the oven from its packaging,
before making the connections place it on the
polystyrene foam base to protect it from
damage.
•Do not attempt to lift the oven by the handle.
Lift at the sides as shown in the figure (see
arrow).
•Check that the appliance has not been
damaged in transit.
•Oven dimensions and kitchen unit
dimensions are shown in the opposite figure.
•Kitchen units in contact with the oven must
be heat resistant (80° C min).
•Install the oven in the housing, lifting it at the
sides, taking care not to trap the wires of the
electrical supply cable.
•For correct ventilation, follow the ventilation
opening directions shown in the figure
(500 min x 80 mm and 500 min x 50 mm
inside the cabinet).
•Secure the oven to the kitchen unit with
screws (A) as shown.
•The oven has also been designed for
building-in under a cooktop.
NOTE: To allow for proper ventilation, we
recommend that you left an opening of at least
500 x 80 mm or an equivalent area in the lower
section of the housing.
An additional opening of 5 mm is required
between the oven top rim and the cooktop lower
rim: this opening must not be closed by strips or
housing crosspieces.
During oven installation, care must be taken to
ensure that the sides are not touching the front
edges of the housing or adjacent drawers and
doors (see picture).
INSTALLATION
No contacts
14
•Warning: Do not connect to the power
supply before you have finished
connecting the oven.
•Make sure the oven is installed and
connected to the electricity supply by a
qualified technician in accordance with
the manufacturer’s instructions and in
compliance with local regulations.
•The installer is responsible for the correct
electrical connection of the oven and the
observance of the relative safety
regulations.
•The oven must be connected to the
electricity supply by means of an all-pole
disconnect switch with minimum contact
gap of 3 mm.
•The oven must be earthed by-law.
•Do not use multiple plug adapters or
extension leads.
•After the oven has been installed, the
electrical components must be
inaccessible.
•Make sure that the voltage shown on the
rating plate is the same as the power
supply voltage in your home. The rating
plate is on the front edge of the oven
cavity (visible with oven door open).
ELECTRICAL CONNECTION


Product specificaties

Merk: Bauknecht
Categorie: Oven
Model: BSZ 4002 WS

Heb je hulp nodig?

Als je hulp nodig hebt met Bauknecht BSZ 4002 WS stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Oven Bauknecht

Handleiding Oven

Nieuwste handleidingen voor Oven

Smeg

Smeg SF6400TBA Handleiding

21 November 2024
Smeg

Smeg SO6400S2TR Handleiding

21 November 2024
Smeg

Smeg SF64M3PZB Handleiding

21 November 2024
Smeg

Smeg SF64M3VB2 Handleiding

21 November 2024
Smeg

Smeg CS9GMMNA Handleiding

21 November 2024
Smeg

Smeg SFT805PO Handleiding

21 November 2024
Smeg

Smeg SF6104STS Handleiding

21 November 2024
Smeg

Smeg SF4102MB Handleiding

21 November 2024
Smeg

Smeg C6GMXA8 Handleiding

21 November 2024