Barco Graphics 6300 Handleiding
Lees hieronder de 📖 handleiding in het Nederlandse voor Barco Graphics 6300 (57 pagina's) in de categorie Beamer. Deze handleiding was nuttig voor 85 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/57
BARCO PROJECTION SYSTEMS
Date :
21112000
OWNER'S MANUAL
Rev. :
06
GRAPHICS
6300
R9001440
Art. No. :
R5975879
Due to constant research, the information in this manual is subject to change without notice.
Produced by BARCO NV, December 1998.
All rights reserved.
Trademarks are the rights of their respective owners.
BARCO n.v./Projection Systems
Noordlaan 5
B-8520 Kuurne
Belgium
Tel : +32/56/368211
Fax : +32/56/351651
E-mail : sales.bps@barco.com
Visite Barco at the web : http://www.barco.com
Printed in Belgium
Federal communication commission (FCC statement)
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
Instructions to the user :
if this equipment does cause interference to radio or television reception, the user may try to correct the interference by one or more of the
following measures :
- Re-orientation of the receiving antenna for the radio or television.
- Relocate the equipment with respect to the receiver.
- Plug the equipment into a different outlet so that the equipment and receiver are on different branch circuits.
 Fasten cables connectors to the equipment by mounting screws.
Note :
The use of shielded cables is required to comply within the limits of Part15 of FCC rules and EN55022.
i-1
Table of Contents
5975879 BARCOGRAPHICS 6300 21112000
UNPACKING AND DIMENSIONS ............................................. 1-1
Unpacking ................................................................................... 1-1
Projector dimensions .................................................................. 1-1
Battery installation in the RCU. .................................................. 1-2
INSTALLATION GUIDELINES .................................................. 2-1
Environment ................................................................................ 2-1
Environmental condition check .................................................. 2-1
What about ambient light ? ........................................................ 2-2
Which screen type? .................................................................... 2-2
What image size? How big should the image be?.................... 2-2
Where to install the projector? ................................................... 2-3
How to install a projection lens? ................................................ 2-4
LOCATION AND FUNCTIONS OF CONTROL ........................ 3-1
Front Panel Terminology ............................................................ 3-1
Source & Power Connections .................................................... 3-1
Communication Connections ..................................................... 3-2
Control Panel Terminology ......................................................... 3-2
a. Local keypad .......................................................................... 3-2
b. Remote control ....................................................................... 3-3
INSTALLATION SET UP ........................................................... 4-1
Configuration .............................................................................. 4-1
CONNECTIONS ......................................................................... 5-1
Power connection ....................................................................... 5-1
AC Power (mains) cord connection ........................................... 5-1
Fuses .......................................................................................... 5-1
Switching on ............................................................................... 5-1
Lamp Run Time .......................................................................... 5-2
Lamp Run Time Warning ........................................................... 5-2
Switching to Stand-by. ................................................................ 5-2
Switching Off .............................................................................. 5-2
Input Connections ...................................................................... 5-2
5-cable Input Slot (slot 1) ........................................................... 5-3
Computer input/Monitor output ................................................... 5-4
Video Input .................................................................................. 5-4
S-Video Input .............................................................................. 5-5
Serial Digital Input / Serial Digital Output ................................... 5-5
IEEE 1394 Input ......................................................................... 5-6
Communication Connections ..................................................... 5-6
RS232 in / RS232 out ................................................................. 5-6
Communication port for communication with
peripherals .................................................................................. 5-7
Audio Connections ..................................................................... 5-7
CONTROLLING ......................................................................... 6-1
How to use the RCU? ................................................................ 6-1
Projector address ....................................................................... 6-2
Common Address ....................................................................... 6-2
Displaying a Projector Address. ................................................. 6-2
How to Program an Address into the RCU? .............................. 6-2
Picture controls with direct access............................................. 6-2
Sound controls with direct access. ............................................ 6-3
The Pause key............................................................................ 6-3
The Selection key. ...................................................................... 6-4
START UP OF THE ADJUSTMENT MODE ............................. 7-1
Adjustment Mode........................................................................ 7-1
AUTO IMAGE ADJUSTMENT ................................................... 8-1
Auto Image Adjustment .............................................................. 8-1
Adjust .......................................................................................... 8-1
RANDOM ACCESS ADJUSTMENT MODE ............................. 9-1
Starting up the Random Access Adjustment Mode ................... 9-1
File Service ................................................................................. 9-2
Load File ..................................................................................... 9-2
Edit File ....................................................................................... 9-3
Delete ......................................................................................... 9-5
Rename ...................................................................................... 9-5
Copy ........................................................................................... 9-5
File Options ................................................................................. 9-6
Picture Tuning ............................................................................ 9-6
CTI ON/OFF ............................................................................... 9-6
Color Temperature ..................................................................... 9-7
Gamma ....................................................................................... 9-7
Decoding EBU/IRE ..................................................................... 9-7
Input Balance .............................................................................. 9-8
Dynamic Color Depth ................................................................. 9-8
Noise Reduction ......................................................................... 9-8
Audio Tuning............................................................................... 9-9
Volume, Balance, Bass and Treble ............................................ 9-9
Mute ............................................................................................ 9-9
Fade ............................................................................................ 9-9
Mode [stereo]/[mono] ............................................................... 9-10
Video - Audio lock ..................................................................... 9-10
Geometry .................................................................................. 9-10
Shift ........................................................................................... 9-11
Side Keystone .......................................................................... 9-11
Blanking .................................................................................... 9-12
Aspect Ratio [4:3]/[16:9] ........................................................... 9-13
Options ..................................................................................... 9-13
INSTALLATION MODE ........................................................... 10-1
Starting up the Installation Mode.............................................. 10-1
Input Slots ................................................................................. 10-1
No Signal .................................................................................. 10-2
Lens Adjustments ..................................................................... 10-2
Zoom/Focus/Shift ..................................................................... 10-2
Text Box Position ..................................................................... 10-3
Quick Access Keys................................................................... 10-3
Start Up Mode .......................................................................... 10-3
800 Peripheral .......................................................................... 10-4
Output module selection. .......................................................... 10-4
Infrared Communication. .......................................................... 10-4
Configuration ............................................................................ 10-4
OSD color (On-Screen Display) ............................................... 10-4
Internal Patterns ....................................................................... 10-5
Switching Mode ........................................................................ 10-5
SERVICE MODE ...................................................................... 11-1
Starting up the Service Mode ................................................... 11-1
Identification ............................................................................. 11-2
Change Password .................................................................... 11-3
How to enable or disable the password function ? .................. 11-3
How to change the password ? ................................................ 11-3
Change Language .................................................................... 11-3
Change Projector Address ....................................................... 11-3
Projector Address ..................................................................... 11-3
Common Address ..................................................................... 11-4
Change Baudrate PC ............................................................... 11-4
Reset Lamp Runtime................................................................ 11-4
Lamp Run Time History ........................................................... 11-4
Dimming.................................................................................... 11-5
BARCO logo ............................................................................. 11-5
Panel Adjustments.................................................................... 11-5
Uniformity.................................................................................. 11-6
Preset Input Balance ................................................................ 11-6
I2C diagnosis. ........................................................................... 11-6
STANDARD SOURCE SET UP FILES ..................................... A-1
LENSES ..................................................................................... B-1
Lens Cleaning Procedure ........................................................... B-1
Lenses ........................................................................................ B-2
SOURCE NUMBERS 81 - 86 AND 91 - 96 ............................... C-1
Projector without any 800 peripheral connected........................ C-1
Projector with a 800 peripheral connected.................................C-1
Source numbers 91 - 99. ............................................................ C-1
Source numbers 81 - 86 .............................................................C-2
Product specificaties
| Merk: | Barco |
| Categorie: | Beamer |
| Model: | Graphics 6300 |
Heb je hulp nodig?
Als je hulp nodig hebt met Barco Graphics 6300 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Beamer Barco
23 Juli 2024
23 Juli 2024
23 Juli 2024
5 Maart 2024
5 Maart 2024
5 Maart 2024
9 Januari 2024
19 Augustus 2023
17 Augustus 2023
17 Augustus 2023
Handleiding Beamer
- Beamer Philips
- Beamer HP
- Beamer Sony
- Beamer Samsung
- Beamer Xiaomi
- Beamer Casio
- Beamer Panasonic
- Beamer Epson
- Beamer LG
- Beamer Asus
- Beamer Canon
- Beamer JVC
- Beamer Medion
- Beamer Toshiba
- Beamer Yamaha
- Beamer Acco
- Beamer Acer
- Beamer Aiptek
- Beamer Anker
- Beamer AOpen
- Beamer ASK Proxima
- Beamer Auna
- Beamer Bauer
- Beamer BenQ
- Beamer Blaupunkt
- Beamer D-Link
- Beamer Dell
- Beamer Easymaxx
- Beamer Eiki
- Beamer Elmo
- Beamer Emtec
- Beamer GPX
- Beamer Hama
- Beamer Hisense
- Beamer Hitachi
- Beamer Ibm
- Beamer InFocus
- Beamer Ion
- Beamer Klarstein
- Beamer Kodak
- Beamer Kogan
- Beamer La Vague
- Beamer Leica
- Beamer Lenco
- Beamer Lenovo
- Beamer Livoo
- Beamer Marantz
- Beamer Maxell
- Beamer Mitsubishi
- Beamer Nebula
- Beamer Nec
- Beamer PLUS
- Beamer Polaroid
- Beamer Pyle
- Beamer RCA
- Beamer Reflecta
- Beamer Renkforce
- Beamer Ricoh
- Beamer Salora
- Beamer Sanyo
- Beamer Sharp
- Beamer Showtec
- Beamer Smart
- Beamer Smartwares
- Beamer Speaka
- Beamer Steinel
- Beamer Technaxx
- Beamer Viewsonic
- Beamer Vivitek
- Beamer Vogels
- Beamer XGIMI
- Beamer ZTE
- Beamer Odys
- Beamer OK
- Beamer Oki
- Beamer Optoma
- Beamer Overmax
- Beamer 3M
- Beamer Krüger And Matz
- Beamer Naxa
- Beamer Steren
- Beamer Eurolite
- Beamer Prixton
- Beamer Planar
- Beamer Dukane
- Beamer Yaber
- Beamer Mimio
- Beamer Da-Lite
- Beamer Adj
- Beamer Dahua Technology
- Beamer Derksen
- Beamer Celly
- Beamer Promethean
- Beamer Stairville
- Beamer Laserworld
- Beamer Beghelli
- Beamer Cameo
- Beamer Tzumi
- Beamer EKO
- Beamer MicroVision
- Beamer Elite Screens
- Beamer Celexon
- Beamer Fun Generation
- Beamer Christie
- Beamer Futurelight
- Beamer Varytec
- Beamer Ultimea
- Beamer Dracast
- Beamer Dream Vision
- Beamer Knoll
- Beamer DTS
- Beamer Touchjet
- Beamer Boxlight
- Beamer AAXA Technologies
- Beamer Miroir
- Beamer Vankyo
- Beamer AWOL Vision
- Beamer Smart Tech
- Beamer Atlantis Land
- Beamer KickAss
- Beamer Microtek
- Beamer VAVA
- Beamer Panamorph
- Beamer Mirabella Genio
Nieuwste handleidingen voor Beamer
18 December 2024
18 December 2024
18 December 2024
17 December 2024
16 December 2024
16 December 2024
16 December 2024
16 December 2024
14 December 2024
14 December 2024