Axton ATB20P Handleiding

Axton Subwoofer ATB20P

Lees hieronder de 📖 handleiding in het Nederlandse voor Axton ATB20P (11 pagina's) in de categorie Subwoofer. Deze handleiding was nuttig voor 43 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/11

INSTALLATION & OPERATION MANUAL

EINBAU & BEDIENUNGSANLEITUNG

8" / 20 CM ACTIVE SUBWOOFER

ATB20P

– 2 –

Dear Customer

Thank you and congratulations on your purchase of the AXTON ATB20P. This active

subwoofer system exclusively uses very high quality parts and components. As with all

high-quality car audio components, professional installation is highly recommended. If you

plan on installing this active subwoofer by yourself, please read the following installation

guide carefully, before you attempt the installation. You should retain this manual, the

packing and the purchasing receipt for future reference. For any further information about

mounting, connecting or adjusting this subwoofer system, please contact your AXTON

dealer.

UNPACKING THE SYSTEM

Carefully remove all parts from the giftbox and check whether they are in good undam-

aged condition, and match with the set contents listed below:

n ATB20P active subwoofer

n Bass Boost remote control

n 4-wire high level input plug

n Mounting clamps

n Set of mounting screws

n Installation guide

Please contact your authorized AXTON dealer, if the content of this set is incomplete,

or parts of it show signs of transport damage.

SPECIFICATIONS

n 8” active subwoofer

n Frequency response: 20 Hz – 150 Hz

n 150 W rms x 1 @ 2 ohms (< 0.4% THD / 14.4V)

n Class-A/Bamplier

n Supply voltage: 11 – 15 V DC

n Fuse: 25 A

n Variable lter:  –   lowpass 50 Hz 150Hz with 12 dB/oct.

n Subsoniclter: 20 Hz

n Selectable phase: 0 / 180°

n Variable Bass-Boost: 0 – 18 dB @ 45 Hz

n RCA, variable input sensitivity: 100 mV – 6 V

n High-Level, variable input sensitivity: 330 mV – 9 V

n External bass level remote control

n Signal to noise ratio: > 90 dB

n Dimensions W x H x D: 345 x 70 x 245 mm

n Net Weight: 5.3 kg

– 4 –

SAFETY INSTRUCTIONS

1. This unit is designed to be used in a vehicle with a 12 V battery and negative ground.

2. Before any wiring, always remove the negative terminal of the battery to prevent short-

circuiting. This is also the last lead to be (re-)connected.

3. Do not disassemble or alter the unit in any way, because that will also void your

warranty. Do not attempt to repair or to service the unit yourself, but contact an

authorized AXTON dealer instead.

4. Use only original accessories which are designed and manufactured for the unit,

otherwise you will risk to damage it. Install the unit according to the mounting manual

and use only the supplied mounting accessories. The forces of acceleration for

accidents are sometimes huge. Incorrect mounted units are a big risk for the driver

and the passengers of the car, during an accident.

5. Protect the unit from water and other liquids, which can enter the casing. A short

circuit or even fire could be the result.

6. Before you replace a defective fuse, try to find the cause for the short circuit. Please

pay attention to the cables of the power supply! If the short circuit doesn‘t result from

a failure of the power supply or wiring, you can replace the defective fuse with a new

one of identical value. If the short-circuit still exists, please contact an authorized

AXTON dealer.

7. Be careful not to drain the car battery while using the unit when the car engine is

turned off. Because the unit uses a considerable amount of energy and the battery

will be charged only while the engine is running, it might happen that the battery will

discharge to a point where it‘s not longer possible to start the engine.

8. If your car is parked in direct sunlight and there is a considerable rise in temperature

inside the car, allow the unit to cool off before operation.

9. The amplifier module employs a protection circuit to protect the transistors and the

woofer if the amplifier malfunctions. The amplifier’s protection circuitry will shut-off

the amplifier in case of short-circuit, overload or DC offset at the speaker outputs or

in case of overheat. In case the cause for protection shut-off has been eliminated, the

amplifier will operate normally again (green LED ON/ Red LED OFF). Otherwise the

amplifier will continue to switch on and off!

10. Do not use the unit with a weak or old battery as its optimum performance depends on

a normal battery supply voltage.

11. Please pay attention to the volume inside your vehicle, because you are obliged to

notice exterior sounds like a police siren or you might face penalties in case of an

accident or even loose your insurance cover.

12. Do not operate the unit in any other way than described in this manual. Failure to

follow the instructions within this manual will void your warranty.

Product specificaties

Merk:	Axton
Categorie:	Subwoofer
Model:	ATB20P

Heb je hulp nodig?

Als je hulp nodig hebt met Axton ATB20P stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Subwoofer Axton

Axton ATB120 Handleiding

17 November 2024

Axton ATB220 Handleiding

3 September 2024

Axton ATB20A Handleiding

4 December 2023

Axton ATB216 Handleiding

2 Juli 2023

Axton ATB20STP Handleiding

29 Juni 2023

Axton AXB20A Handleiding

25 Juni 2023

Axton ATW20 Handleiding

25 Juni 2023

Axton AXB25A Handleiding

3 November 2022

Axton ATB20RXF Handleiding

3 November 2022

Axton ATB120QBA Handleiding

3 November 2022

Handleiding Subwoofer

Nieuwste handleidingen voor Subwoofer

Vonyx SMW18 Handleiding

4 December 2024

Vonyx SMW15 Handleiding

4 December 2024

Peavey Versarray 118 Handleiding

4 December 2024

Kenwood KFC-W3013PS Handleiding

3 December 2024

Kenwood KFC-W2513PS Handleiding

3 December 2024

Teufel T 4000 Handleiding

2 December 2024

Yamaha A15W Handleiding

2 December 2024

Yamaha CXS18XLFW Handleiding

2 December 2024

Yamaha SW10 Studio Handleiding

2 December 2024

Boston Acoustics Classic CS Sub10 II Handleiding

1 December 2024