Audac WS500 Handleiding

Audac Speaker WS500

Lees hieronder de 📖 handleiding in het Nederlandse voor Audac WS500 (4 pagina's) in de categorie Speaker. Deze handleiding was nuttig voor 18 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/4

PROFESSIONAL AUDIO EQUIPMENT

Design Wall Loudspeaker WS500

Installation Guide

Design Wall Loudspeaker

WS500

AUDAC

Installation procedure

1) Before mounting the loudspeaker, the front grill should be removed

to make the mounting holes accessible. The best method for

removing the front grill is to push the lower side of the front grill up

with your thumbs. The grill should easily slide up, without

performing large forces.

2) When the lower side of the grill is pushed upwards, the attachment

tabs on the bottom of the front grill should slide out of the

mounting slots. The lower side of the front grill can be popped

out. After this, the upper side can also be detached easily and the grill

can be removed.

3) After the grill is removed, the two mounting holes are visible. One

mounting hole is provided on the upper side, while the second mounting

hole is provided on the lower side of the loudspeaker.

4) Before mounting the loudspeaker, make sure that the speaker can be mounted on a safe location and

the mounting location is solid enough to support the weight of the loudspeaker.

5) Connect the terminals of the loudspeaker. More information about the connections can be found in

the “Connections” section of this manual.

6) After the connections are made, a screw should be provided on the desired mounting location of the

upper mounting hole. Once this screw is provided, the upper mounting hole should glide over the

mounting screw. The loudspeaker is now hanging on one single screw.

7) Now the second mounting hole can be drawn. It is located 25.5 cm lower than the first mounting hole.

8) When both mounting points are provided, both screws can be inserted and tightened.

9) When the loudspeaker is suspended with both mounting points and the connections are made, the

front grill can be placed again. This can be done by sliding the upper mounting tabs of the front grill

into the provided slots, and afterwards sliding the lower mounting tabs into the provided slots.

Connections

To avoid electric shocks during installation, always switch of the amplifier power when connecting

loudspeakers.

On the rear side of the loudspeaker three connection terminals are provided.

By means of selecting the appropriate connection terminals, the desired line transformer power tapping

can be set, to be used in 100V public address applications.

COM 10 Watt 5 Watt

Those connection terminals should be connected to the amplifier output. The COM connection

terminal should always be connected with the COM output terminal of the Amplifier. When the

loudspeaker should play at full power, the positive terminal of the amplifier output should be connected

to the 10 Watt terminal (Red). When only half the power is needed, the positive terminal of the

amplifier output should be connected to the 5 Watt terminal (White)

Connections for 100 Volt use:

COM Black

10 Watt / 1000 Ohm Red

5 Watt / 500 Ohm White

When the loudspeaker is connected to 70.7V facilities, the power indicated in the table above will be

reduced to half the power, and when connected to 50V facilities, the power will be reduced to a quarter.

When the desired power tap is selected and connected, the loudspeaker is ready to be used.

Product specificaties

Merk:	Audac
Categorie:	Speaker
Model:	WS500
Kleur van het product:	Wit
Gewicht:	1620 g
Breedte:	240 mm
Diepte:	100 mm
Hoogte:	340 mm
Materiaal behuizing:	Acrylonitrielbutadieenstyreen (ABS)
Connectiviteitstechnologie:	Bedraad
Gemiddeld vermogen:	10 W
Aanbevolen gebruik:	Universeel
Impedantie:	8 Ohm
Audio-uitgangskanalen:	1.0 kanalen
Speaker plaatsing:	Ceiling-mountable,Wall-mountable
Aantal drivers:	1
Frequentiebereik:	150 - 15000 Hz
Gevoeligheid:	92 dB
Versterkeraansluiting (binding post):	Ja
AirPlay:	Nee
Multi-Room Streaming (MRS)-ondersteuning:	Nee