Apc Line R 600VA Handleiding

Apc Niet gecategoriseerd Line R 600VA

Lees hieronder de 📖 handleiding in het Nederlandse voor Apc Line R 600VA (1 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 20 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/1

Safety Messages

Safety Information

Adhere to all national and local electrical codes.

All wiring must be performed by a qualified electrician.

Changes and modifications to this unit not expressly approved by APC by Schneider Electric

could void the warranty.

Product Decription

The Line-R automatically corrects brownouts (by boosting low voltage) and overvoltages (by stepping

down high voltage) from the power utility service to levels that are for computers, as well as otheracceptable

sensitive equipment. APC by Schneider Electric Line-R provides a high degree of protection from line

voltage sags and swells, and has been designed for reliable, maintenance-free service.

Applications

Features

Installation

Specifications

Limited Warranty

CAUTION

NOTICE

Line-R

Automatic Voltage Regulator

Models LS595-RS, LS1000-RS, and

LS1500-RS

EN 990-9731A

03/2018

CAUTION indi cates a h azardous situation which, i f not a vo ided, minor could result in

or moderate injury.

NOTICE is used to address practices not rela ted to physical injury.

Top Panel

Pow er LED Illumin ates when in put voltage is

within normal range

AV R LE D

AC Ou tl ets

Illumin ates when in put voltage is

below or higher the rat ed Inpu t

Voltage Range

These out lets supply po wer to

connected equipment when the Line-R

is conn ected to AC power

Rear Panel

Pow er Switch

AC Po wer

Cor d

Use this as the master power switch to

turn the Line-R and all connected

equipment on ( ) or off ( ).

Use this cable to connect the Line-R to

AC power.

Plug the Line-R into a Wall Outlet - Plug the Line-R into a wall socket. Connect your computer or

other electronic equipment to any of the three outlets on the top panel of the Line-R. The Line-R

should only be used in buildings that have proper grounding on a branch circuit protected by a fuse

or circuit breaker.

Connect Your Equipment - Plug equipment into the Line-R top-panel outlets and switch the

equipment ON. The equipment will not be powered until the Line-R is switched on.

Note: The total power consumption of all equipment plugged into the Line-R must not exceed the

ratings listed in the Specifications table below.

Switch ON the Line-R - Press the back panel power switch to the on ( ) position. This switch

may be used as the master switch for the device and all equipment connected to it.

Characteristics LS1000-RSLS595-RS LS1500-RS

Maximum Output Power Capacity

Nominal Output Voltage

Nominal Input Current

Acceptable Voltage Range Tolerance

500 W or 1000 VA300 W or 595 VA 750 W or 1500 VA

230V

1.65 A 2.71 A 4.07 A

Rated Input Voltage

Maximum Acceptable Input Voltage

Output Regulation

Response Time

Efficiency

Nominal Frequency

Number of Outlets

Operating Temperature

Relative Humidity

Weight

Dimensions

1.36 kg (2.9 lb) 1.6 kg (3.5 lb) 1.96 kg (4.3 lb)

184-284 VAC

230 Vac

284 Vac

10%

>95%

50 Hz

32 - 104 F (0 - 40 C)

0-90% Non-condensing

7 0 x 3.7 x 4.5 inches (180 x 95 x 119 mm).

6 ms

Surge Energy 148 Joules

Electric Industries S A S . . . or their affiliated companies . All other trademarks are property of

their respective owners .

Note: The total power consumption of all equipment plugged into the Line-R must not exceed the

“Maximum Output Power Capacity” rating listed in the Specifications table.

The Line-R is designed for use with voltage sensitive equipment such as computers, monitors,

printers, scanners, televisions, stereos or other AV equipment.

Do not use with life sustaining equipment and any device with a power requirement exceeding the

“Acceptable Voltage Range” rating listed in the Specifications table.

Read the instructions carefully to become familiar with the equipment before attempting to install,

operate, service or maintain the AVR (Automatic Voltage Regulator). The following special messages

may appear throughout this manual or on the equipment to warn of potential hazards or to call

attention to information that clarifies or simplifies a procedure.

The addition of this symbol to a “Danger” or “Warning” safety label indicates that an

electrical hazard exists which will result in personal injury if the instructions are not

followed.

This is the safety alert symbol. It is used to alert you to potential personal injury

hazards. Obey all safety messages that follow this symbol to avoid possible

injury or death.

APC by Schneider Electric IT Customer Support Worldwide

For country specific customer support, go to the APC by Schneider Electric Web site, www.apc.com.

Schneider Electric IT (SEIT) warrants its products to be free from defects in materials and

workmanship for a period of two years from the date of purchase. SE IT obligation under this

warranty is limited to repairing or replacing, at its sole discretion, any such defective

products. This warranty does not apply to battery wear from use, equipment that has been

damaged by accident, negligence or misapplication or has been altered or modified in any

way. SEIT standard procedure is to replace the original unit with a factory reconditioned

unit. Customers who must have the original unit back due to the assignment of asset tags and

set depreciation schedules must declare such a need at first contact with an SEIT Technical

Support representative. SEIT will ship the replacement unit once the defective unit has been

received by the repair department, or cross ship upon the receipt of a valid credit card

number. The customer pays for shipping the unit to SEIT. SEIT pays ground freight

transportation costs to ship the replacement unit to the customer. For full warranty

information refer to www.apc.com.

This product is intended for indoor use only.

Do not block the air vents on the AVR. Allow adequate space for proper ventilation.

Allow 1 inch (2.5 cm) minimum vent clearance.

Do not operate this product in direct sunlight, in contact with fluids, or where there

is excessive dust or humidity.

Product specificaties

Merk:	Apc
Categorie:	Niet gecategoriseerd
Model:	Line R 600VA
Kleur van het product:	Zwart
Breedte:	95 mm
Diepte:	180 mm
Hoogte:	119 mm
Snoerlengte:	1 m
Breedte verpakking:	98 mm
Diepte verpakking:	125 mm
Hoogte verpakking:	228 mm
LED-indicatoren:	Ja
Certificering:	RoHS
Uitgangsvermogen:	300 W
Temperatuur bij opslag:	-20 - 50 °C
Frequentie:	50 Hz
Spanning:	230 V
Hoogte, in bedrijf:	0 - 1015.9 m
Stekker:	Type F
Efficientie:	90 procent
Bedrijfstemperatuur (T-T):	0 - 40 °C
Relatieve vochtigheid in bedrijf (V-V):	0 - 90 procent
Surge energy rating:	148 J
Aantal AC uitgangen:	3 AC-uitgang(en)
Nominale input voltage:	230 V
Stopcontacttypes:	Type F
Output power capacity:	0.595 kVA
Voltage correctie bereik:	184 - 284 V