Apc AP7768 Handleiding

Apc Niet gecategoriseerd AP7768

Lees hieronder de 📖 handleiding in het Nederlandse voor Apc AP7768 (2 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 48 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/2

Rack Automatic Transfer Switch Front

and Rear Rail Kit(AP7768)—Installation

Inventory

Note: These instructions apply to both 1U and 2U Rack Automatic Transfer Switches.

Attach the mounting brackets

Attach the left and right mounting brackets to

the unit, using two Phillips flat-head screws

(provided) for each bracket. Place the brackets

flush with the front of the rack to leave room

for routing cables.

Disassemble the adjustable brackets

The adjustable brackets are necessary only if you are using a four-post enclosure or rack. If you are using a

two-post rack, the Automatic Transfer Switch is supported by the mounting brackets alone.

1. Disassemble each adjustable bracket by removing

the slide screw and nut.

2. Set the screws, nuts, and adjustable bracket

segments aside.

Front and rear rail segments (2 each)

Hex nuts (2) Washers (4) Phillips pan-head

screws (2)

Phillips flat-head

screws (4)

Phillips flat-head

mounting screws (4)

pdu0400a

pdu0403a

Customer support and warranty information is available at the APC Web site, www.apc.com.

Conversion. Other trademarks are property of their respective owners.

990-3169

06/2007

*990-3169*

Attach rear segments to the rack

1. Insert cage nuts (provided with

your enclosure) on the rear

vertical mounting rails of the

enclosure at your chosen

location.

2. Align the rear segments of the

adjustable bracket with the cage

nuts you inserted in step 1.

3. Insert and tighten the Phillips

flat-head mounting screws

(provided).

Attach front segments to the switch

1. Align the front segments of the

adjustable bracket with the four

corresponding holes on the

sides of the Automatic Transfer

Switch (ATS).

2. Attach both front segments to

the ATS using two Phillips

pan-head screws (provided) for

each bracket segment.

Install the Automatic Transfer Switch in the enclosure

Heavy: Two people should perform this procedure.

1. Position the Automatic

Transfer Switch in front of

the mounted rear adjustable

bracket segments.

2. Align the front and rear

adjustable bracket segments,

and slide the front segments

onto the rear segments.

3. Align the mounting brackets

on the switch with the front

vertical mounting rails of the

enclosure and insert cage

nuts (provided with your enclosure) in the appropriate holes on the front vertical mounting rails.

4. Insert and tighten the Phillips flat-head mounting screws (provided).

5. Insert slide screws and nuts (see “Disassemble the adjustable brackets”) into each adjustable

bracket, and tighten them to secure the positions of the adjustable brackets.

pdu0402a

pdu0404a

Product specificaties

Merk:	Apc
Categorie:	Niet gecategoriseerd
Model:	AP7768
Kleur van het product:	Zwart
Gewicht:	1000 g
Gewicht verpakking:	1140 g
Breedte verpakking:	565 mm
Diepte verpakking:	99 mm
Hoogte verpakking:	54 mm
Afmetingen (B x D x H):	519 x 24 x 43 mm
Code geharmoniseerd systeem (HS):	85389099