Apart CMRQ108 Handleiding

Apart Speaker CMRQ108

Lees hieronder de 📖 handleiding in het Nederlandse voor Apart CMRQ108 (4 pagina's) in de categorie Speaker. Deze handleiding was nuttig voor 38 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/4

INFO@APART-AUDIO.COM

Elegant and very natural sounding in-wall/in-ceiling speaker.

l/in ceiling speaker

WWW.APART-AUDIO.COM

The APart CMRQ108 is an elegant and very natural sounding in-wall/in-ceiling speaker.

It easily outperforms most standard cabinet speakers, both in sound quality and appearance.

Easy to integrate in high-end audio chains, cinema surround systems or even high quality BGM

systems, this speaker offers a soundstage, unheard in this price range.

Due to the narrow visible mounting ﬂ ange and paintable detachable steel grilles, the speakers

can be integrated very discretely in even the most demanding environments, in your living room,

connected to your multiroom system, hiﬁ or cinema surround audio system…side by side to your

ﬂ atscreen TV.

Turn your living room walls into a wall of sound, at the highest possible hiﬁ standards, exactly

there where you feel at home.

CMRQ108 has a 6.5’ bass-mid speaker with a DuPont® Kevlar cone and a low loss rubber

surround. This guarantees highest possible deﬁ nition and lowest sound coloration. High

frequencies are covered by a tiltable 1 inch silk dome tweeter, carefully matched and tuned to

deliver an amazing and detailed sound, without the harshness commonly found in cheap metal

alloy domes. The treble contour can be adjusted in 3 steps to suit your personal preferences.

CMRQ108 is 8 ohms standard, and can easily be switched to 12 ohms. This way you can use two

speakers in parallel on one ampliﬁ er channel, giving a total load impedance of 6 ohms. This load

impedance is standard for most surround receivers.

Mounting is easy and straightforward. The speaker clamps accept wall thickness of 0 to 28 mm.

By using our optional in-wall mounting frame, you can install the speaker even in solid brick walls.

Speaker cables are securely clamped in the gold plated cable connectors, accepting thick speaker

cables up to 6 mm².

The CMRQ speakers are not magnetically shielded, this is not necessary unless you install them

close to a CRT screen. Flatscreens, the ideal partners for the CMRQ speakers, are insensitive to

magnetic ﬁ elds. Instead we have invested in solid gold plated speaker wire terminals, a carefully

tuned crossover with high quality components, solid steel speaker grille and of course top notch

quality drivers. You will hear the difference !

• Multi Room audio systems.

• Home Theatre systems.

• Lounges, Bars, Boutiques.

• Board rooms & Ofﬁ ces.

• Convention Centres, Hotels, sports facilities.

INFO@APART-AUDIO.COM

Recommended minimum installation volume: 7 liters. By using our optional in wall speaker

frame/cabinet, the optimum cabinet volume is guaranteed, however, there is no upper volume

limit. When the speaker is installed in a space with hard materials, such as bricks or concrete,

additional cavity damping may be required. Suitable materials are mineral insulation materials,

such as rockwool, or BAF (bonded acetate ﬁ bre). Hard foam materials such as polystyrene and

other polyfoams are not suitable. Make sure the damping materials used meet all ﬁ re and building

requirements. Check that there are no obstacles such as electrical tubes, wires or other pipes

behind the speaker. Make sure the area behind the speaker is free of dust and small particles,

such as small stones because these particles can damage the vented magnet system of the

speaker. In cases of doubt, protect the rear of the speaker with a small amount of BAF wadding.

Impedance selection jumper located at

the rear of the speaker. Position the

jumper according to the required

impedance, 8 or 12 ohms.

The treble contour can be adjusted

in 3 steps to suit your personal

preferences

To make grille removal easier, a special grille removal tool is supplied with the speakers. Insert the

tool end in a grille hole located at the corner of the speaker and gently pull the grille out. Repeat

this step on all corners until the grille is entirely free. Do not attempt to pull out the grille by pulling

one side of the grille only, this may cause damage to the grille or the frame. Keep the tool at hand

in case you need to remove the grille.

Be extra careful when positioning the tweeter: do not touch the tweeters membrane.

Ideally, you should position the speakers on ear level or above, never below, with the tweeter

on top. When the speakers are positioned far above the listening position (more than 60 cm),

pivot the tweeter and aim it towards the listening position.

Avoid the presence of wall corners, because these will augment reﬂ ections and low frequencies,

causing an unstable stereo image and boomy bass.

If possible, mount the speakers close to the sides of your ﬂ atscreen TV, about 1.5 meters or more

apart from each other, depending on screen size and listening distance. In general, the listening

position and the left and right speaker should form an equilateral triangle and the speaker should

be positioned halfway the screen or slightly higher.

For hiﬁ setups, mount the speakers between ½ and 2/3 of total wall height, for

walls up to 3 meters height, and stay at least 50 cm clear of adjacent walls and the ceiling.

If necessary, the speakers can also be positioned ‘lying on their side’, with the tweeters pointing

outwards, however, stereo image is more precise when mounting the speakers with the tweeters

pointing upwards. You can also mount the speakers in a ceiling if necessary.

Product specificaties

Merk:	Apart
Categorie:	Speaker
Model:	CMRQ108
Kleur van het product:	Wit
Gewicht:	1650 g
Soort:	Inbouwluidsprekers
Gemiddeld vermogen:	120 W
Impedantie:	8 Ohm
Audio-uitgangskanalen:	2.0 kanalen
Frequentiebereik:	45 - 25000 Hz
Gevoeligheid:	87 dB
Afmetingen (B x D x H):	172 x 78 x 272 mm
Diameter woofer:	165.1 mm
Diameter hogetonenluidspreker:	25.4 mm
Tweeter:	Ja
Crossover frequentie:	3000 Hz