Aga GC Handleiding

Aga Fornuis GC

Lees hieronder de 📖 handleiding in het Nederlandse voor Aga GC (8 pagina's) in de categorie Fornuis. Deze handleiding was nuttig voor 2 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/8
Is a heat storage cooker with an automatic gas control,
which will keep the temperature of the cooker constant
when not in use and return it to the constant temperature
after use.
Your AGA is also supplied with the following accessories:
1. Large roasting tin with grill rack.
1. Half-size roasting tin with grill rack.
2. Oven Grid Shelves.
1. Plain Shelf.
1. Toaster.
1. AGA Book.
1. Wire Brush.
In addition there is a guarantee registration card which
should be completed and returned to AGA.
A full description of cooking with your AGA is given in the
AGA Book.
For the most effective operation of the cooker the
following points should be carefully observed:
1. Close the insulating lids whenever the hotplates are
not in use.
2. Clean the hotplates regularly with the wire brush.
3. Utensils with ground flat bases must be used to make
perfect contact with the hotplates.
4. The hot water system must be thoroughly insulated
(Model GCB).
5. Have the cooker serviced at regular intervals by your
Authorised AGA Distributor.
6. Take care, when closing the oven doors, to lift them on
to the catch.
Operating Instructions for
AGA PF Gas Fired Cooker Models
GC, GCB, (2 Oven) 2=
GE (4 Oven) =4=
Consumer Protection
As responsible manufacturers we take care to make sure that our
products are designed and constructed to meet the required safety
standards when properly installed and used.
IMPORTANT NOTICE: PLEASE READ THE ACCOMPANYING
WARRANTY - Any alteration that is not approved by AGA could
invalidate the approval of the appliance, operation of the warranty
and could affect your statutory rights.
In the interests of safety and effective use, please read the
following before using your new AGA appliance.
Important
This appliance may contain some of the materials that are indicated.
It is the Users/Installers responsibility to ensure that the necessary
personal protective clothing is worn when handling, where
applicable, the pertinent parts that contain any of the listed materials
that could be interpreted as being injurious to health and safety, see
below for information.
Firebricks, Fuel beds, Artificial Fuels - when handling use
disposable gloves.
Fire Cement - when handling use disposable gloves.
Glues and Sealants - exercise caution - if these are still in liquid form
use face mask and disposable gloves.
Glass Yarn, Mineral Wool, Insulation Pads, Ceramic Fibre,
Kerosene Oil - may be harmful if inhaled, may be irritating to skin,
eyes, nose and throat. When handling avoid inhaling and contact
with skin or eyes. Use disposable gloves, face-masks and eye
protection. After handling wash hands and other exposed parts.
When disposing of the product, reduce dust with water spray, ensure
that parts are securely wrapped.
FOR USE IN GB & IE
Gas Fired Cookers
PLEASE READ THESE INSTRUCTIONS BEFORE USING YOUR AGA
1 09/10 EOPI 511113
YOUR AGA COOKER
DESN 511192
WARMING PLATE
(4 OVEN MODEL)
PLATE WARMING OVEN
(4 OVEN MODEL)
SIMMERING OVEN
(4 OVEN MODEL)
BOILING PLATE SIMMERING PLATE
HEAT INDICATOR
ROASTING OVEN
SIMMERING OVEN
(BAKING OVEN ON
4 OVEN MODELS)
THE HEAT INDICATOR
Fig. 1 DESN 515920
The heat indicator above the roasting oven door is a guide to the stored heat within the AGA, and does not directly relate
to the Roasting oven centre oven temperature.
It has 3 sections black, silver and red.
To obtain your preferred working temperature the control knob can be adjusted slightly. Once set it is not recommended
to adjust on a regular basis. An AGA is designed to work at an optimum heat setting.
The optimum performance is usually achieved when the indicator is showing a mid-way position in the silver area.
Since the purpose of the heat indicator is to show that the AGA contains the full amount of stored heat it is best to refer
to it first thing in the morning or after a period of several hours during which no cooking has been done.
NOTE: IT DOES NOT INDICATE THE OVEN TEMPERATURE.
2
AUTOMATIC CONTROL
When the cooker is in use the gas control knob should be in the mid section of the green band, with the indicator on or
about the centre of the silver section of heat indicator. It may be necessary to adjust the control knob slightly within the
green band to achieve this.
In the event of power failure your appliance will become
inoperative. When the power is restored it will
automatically restart.
NOTE: REMEMBER TO NOTE THE SETTING OF THE
GAS VALVE CONTROL KNOB 2 PRIOR TO
EXTINGUISHING THE BURNER.
Turn the gas valve control knob clockwise to the off
position (see fig. A).
Frost Precautions
In the event of the cooker being switched OFF for long
periods during very cold weather, the advice of the Local
Gas Region or Authorised Distributor should be obtained.
CAUTION: BEFORE LIGHTING: ENSURE THAT THE
GAS VALVE CONTROL KNOB 2 IS SET IN THE OFF
POSITION. (SEE FIG. A) AND THE ELECTRICAL
SUPPLY TO THE AGA IS SWITCHED ON.
1. Turn on gas supply to cooker and open gas cock 1 at
the base of the gas valve.
2. Turn the gas valve control knob 2 anti-clockwise to the
position ( ) (see fig. B). Press down firmly and hold
the knob in this position while depressing the piezo
ignitor 3 several times until the pilot has lit. This can be
observed through the viewing window. 4.
3. When the pilot has lit continue to hold the gas valve
control knob down for approx. 30 seconds. If it goes
out, wait three minutes and repeat the procedure
holding for a little longer.
4. With the pilot flame established, release the gas valve
control knob 2gradually and rotate anti-clockwise to its
low fire position. Where upon the main burner will
automatically light. Leave in the low fire position for at
least 30 minutes.
NOTE: ANY ATTEMPT TO ROTATE THE CONTROL
KNOB BEFORE RELEASE MAY RESULT IN
DAMAGE.
5. After 30 minutes rotate the control knob further anti-
clockwise to the mid position in the green band for
normal running. (see fig. D).
NOTE: AFTER SEVERAL HOURS THE HEAT
INDICATOR SHOULD BE ON OR ABOUT THE CENTRE
OF THE SILVER SECTION. IT MAY BE NECESSARY
TO ADJUST THE CONTROL KNOB SLIGHTLY IN THE
GREEN BAND TO ACHIEVE THIS.
When the cooker is lit from cold, moisture may form on the
enamel which should be wiped off to prevent staining.
IF THE FLAME HAS EXTINGUISHED FOR WHATEVER
REASON, WAIT THREE MINUTES (MINIMUM)
BEFORE RE-LIGHTING.
NOTE: IF MAIN BURNER EXTINGUISHES
For safety purposes a flue safety device is fitted.
This will only operate in adverse flue conditions, and
electrical power failures. If this problem persists contact
your local engineer to determine and rectify the cause.
TO LIGHT THE BURNER
3
Fig.2
POWER FAILURE
OFF ON
DESN 510252 ‘A’
TO EXTINGUISH THE BURNER

Product specificaties

Merk: Aga
Categorie: Fornuis
Model: GC

Heb je hulp nodig?

Als je hulp nodig hebt met Aga GC stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Fornuis Aga

Aga

Aga Rayburn 799K Handleiding

25 Augustus 2022
Aga

Aga Masterchef Deluxe Handleiding

25 Augustus 2022
Aga

Aga R3 Series 100 Handleiding

25 Augustus 2022
Aga

Aga Heatranger 440 Handleiding

26 Augustus 2022
Aga

Aga six four Handleiding

25 Augustus 2022
Aga

Aga Heatranger 460 Handleiding

26 Augustus 2022
Aga

Aga GE Handleiding

25 Augustus 2022
Aga

Aga Rayburn 308K Handleiding

25 Augustus 2022
Aga

Aga GC Handleiding

25 Augustus 2022

Handleiding Fornuis

Nieuwste handleidingen voor Fornuis

Asko

Asko HIHD854GF Handleiding

4 December 2024
Asko

Asko HG1935 Handleiding

4 December 2024
Teka

Teka TC 6400 Handleiding

4 December 2024
Teka

Teka IRC 9430 KS Handleiding

4 December 2024
Teka

Teka EW 90 5G AI AL TR Handleiding

4 December 2024
Teka

Teka EH 60 4G AI AL TR Handleiding

4 December 2024
Bauknecht

Bauknecht CHR 6642 IN Handleiding

3 December 2024
Orbegozo

Orbegozo FO 6200 Handleiding

3 December 2024
Whirlpool

Whirlpool TGML 660 NB Handleiding

3 December 2024
Whirlpool

Whirlpool WB S0060 NE Handleiding

3 December 2024