TacTic DroneView TACZ1000 Handleiding

TacTic Camcorder DroneView TACZ1000

Lees hieronder de 📖 handleiding in het Nederlandse voor TacTic DroneView TACZ1000 (20 pagina's) in de categorie Camcorder. Deze handleiding was nuttig voor 34 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/20

The Tactic Droneview Camera is powered by an included

1S 3.7V 350mAh lithium-polymer battery (LiPo).

IMPORTANT: It will be necessary to fully charge the

battery with the included USB charge cable before

use! Follow all safety precautions below before

proceeding. Failure to do so may cause the camera

to lose power prematurely, resulting in a loss of data.

●

NEVER LEAVE BATTERY UNATTENDED WHILE CHARGING.

●

Never allow battery temperature to exceed 140°F (60°C).

● Never place the battery on combustible materials while

charging.

● Never attempt to disassemble or modify the battery.

● Never attempt to charge or to use the battery if it’s

swollen, punctured, or deformed in any way.

● Never attempt to charge the battery with an

incompatible battery charger.

● Follow appropriate disposal instructions when the

battery has reached the end of its useful life.

CHARGE THE CAMERA BATTERY

1. Connect the included USB charge cable to a computer’s

USB Port or to an AC to USB adapter.

2. Connect the LiPo battery to the jack on the opposite

end of the charger.

3. The Battery Charge Meter LEDs will start  ashing to

indicate that the charge cycle has started.

4. When the battery is charged, the Battery Charge Meter

LEDs will stop  ashing and remain on.

5 The battery will recharge in about 50 minutes if the

camera is turned off and will operate the camera

for about the same time. The USB charge cable can

be used while the camera is operating to extend the

camera’s run time.

QUICK START

When the camera is turned on, it needs 30 seconds to

setup before it can be used.

LED will ash when camera is in use.

Must be steady for 30 seconds before

the camera is turned off.

Insert or remove the

memory card only when

the camera is off.

Tap to turn the

camera on or off.

Tap to take a picture. Hold

for 2 seconds to start video.

Tap to stop video.

Turn the camera

off when just one

LED has been on

for 10 minutes.

If the camera loses Wi-Fi connection and there is

another network that the device can connect to, iOS

users must go into the Wi-Fi settings and select the

Droneview network. Android devices will usually re-

connect automatically and the user should wait about

a minute before going to the Wi-Fi settings page.

If the battery dies while recording a video or the

camera is turned off before the  le is saved to the

memory card, the current  le may be lost or corrupted.

Always wait 30 seconds before turning the camera

off after recording a video or taking a picture.

Always use a class 10 card in the Droneview camera.

Always insert and remove the memory card when the

camera is turned off.

Product specificaties

Merk:	TacTic
Categorie:	Camcorder
Model:	DroneView TACZ1000
Kleur van het product:	Zwart
Ingebouwd display:	Nee
Gewicht:	27.5 g
Breedte:	80 mm
Diepte:	34 mm
Hoogte:	34 mm
Ondersteunde mobiele besturingssystemen:	Android, iOS
GPS:	Nee
USB-connectortype:	Micro-USB
Frequentieband:	2.4 GHz
Ondersteunde video-modi:	720p
Totaal aantal megapixels:	- MP
Meegeleverde kabels:	USB
Compatibele geheugenkaarten:	MicroSD (TransFlash)
Maximale beeldsnelheid:	- fps
Maximale videoresolutie:	1280 x 720 Pixels
HD type:	HD-Ready
Foto-modi:	Ja
Ondersteund beeldformaat:	JPG
Opslagmedia:	Geheugenkaart
Levensduur accu/batterij:	1 uur
Grootte meegeleverde geheugenkaart:	4 GB
Inclusief geheugenkaart:	MicroSD
HD-Ready:	Ja
Wifi:	Ja
Universele bevestiging:	Ja