Russell Hobbs Steamglide 14033 Handleiding

Russell Hobbs Strijkijzer Steamglide 14033

Lees hieronder de 📖 handleiding in het Nederlandse voor Russell Hobbs Steamglide 14033 (8 pagina's) in de categorie Strijkijzer. Deze handleiding was nuttig voor 12 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/8

instructions

Read the instructions and keep them safe. If you pass the iron on, pass on the

instructions too. Remove all packaging, but keep it till you know the iron works.

important safeguards

Follow basic safety precautions, including:

1 This appliance must only be used by or under the supervision of a responsible adult.

2 Don’t put the appliance in liquid, don’t use it in a bathroom, near water, or

outdoors.

3 Route the cable so it doesn’t overhang, and can’t be tripped over or caught.

4 Don’t iron clothing while it’s being worn – you’ll burn or scald the wearer (this is not

a joke – I’ve seen it happen).

5 Don’t touch the soleplate, and keep away from the steam coming from it.

6 Don’t use the iron in the vicinity of children.

7 Use the iron on a stable, level, heat-resistant surface, preferably an ironing board.

8 Don’t leave the iron unattended while plugged in, or while it’s standing on the

ironing board. It could be knocked over by you, by a child, or by a pet.

9 This iron is designed for occasional use, not regular everyday use.

10 Set the voltage switch to the local voltage. Using the wrong setting will probably

damage the iron beyond repair.

11 Unplug before ﬁlling, before cleaning, and after use.

12 Don’t ﬁll past the mark on the reservoir, or water may escape in use.max

13 Unplug the appliance when not in use, before moving and before cleaning. Let it

cool down fully before cleaning and storing away.

14 Don’t ﬁt any attachment or accessory other than those we supply.

15 Keep the iron and the cable away from hotplates, hobs or burners.

16 Don’t use the iron for any purpose other than those described in these instructions.

17 Take care not to scratch the soleplate – avoid buttons, zips, etc.

18 The iron has a protective thermal fuse, which will blow if it overheats. If this happens,

the iron will stop working, and must be returned for repair.

19 Don’t operate the appliance if it’s dropped or damaged or if it malfunctions or leaks.

20 If the cable is damaged, return the iron, in order to avoid hazard.

domestic use only

before using for the ﬁrst time

• Remove any labels, stickers or packaging from the iron and soleplate.

• Don’t worry if the iron smokes a bit at ﬁrst, it’ll stop as the element cures.

• Iron an old piece of cotton fabric, to clean the soleplate.

• * Press the button 3 or 4 times, to check it out.

check the voltage before use

1 Check the local voltage.

2 The voltage switch is under the rear of the iron.

3 Set the voltage switch to 115V for a local voltage of 100-120 volts a.c., set it to

230V if the local voltage is in the range 220-240 volts a.c.

4 Using the wrong setting will probably damage the iron beyond repair.

5 On lower voltages, the iron may take longer to heat up.

travel adaptor

6 Use an earthed travel adaptor suitable for the wall sockets in the area you’re visiting.

ﬁlling

7 Turn the temperature control to •, and unplug the iron.

8 The iron is tap-water tolerant, so you may ﬁll the reservoir with tap-water, but if

you’re in a hard-water area, you should use distilled water.

9 If you buy distilled water, check that it’s marketed as suitable for irons.

10 Don’t use chemically descaled water, or water from a water softening installation,

and don’t put anything in the water.

11 Pour water from the jug into the water inlet.

12 Pour slowly, and try to pour down one side of the inlet, to allow the air in the

reservoir to escape, otherwise you’ll cause an air lock and the water will overﬂow.

13 Don’t ﬁll past the mark on the reservoir.max

14 Wipe up any spillage.

preparation

15 Check for textile care symbols ( ).i j k l

16 Iron fabrics needing low temperatures ﬁrst, then those that need medium j

temperatures , and ﬁnish with those needing high temperatures (or max).k l

Product specificaties

Merk:	Russell Hobbs
Categorie:	Strijkijzer
Model:	Steamglide 14033
Kleur van het product:	Blue, White
Snoerlengte:	- m
Soort:	Droog- & stoomstrijkijzer
Vermogen:	- W
LED-indicatoren:	Stroom
Sproeifunctie:	Ja
Maatbeker:	Ja
Continu stoom uitvoering:	- g/min
Variabele stoom:	Ja
Zoolplaat materiaal/coating:	Roestvrijstalen zoolplaat
Steam boost performance:	- g/min
Eenvoudig opbergen:	Ja