Mtx Audio RT50.4M Handleiding


Lees hieronder de šŸ“– handleiding in het Nederlandse voor Mtx Audio RT50.4M (24 pagina's) in de categorie Autoradio. Deze handleiding was nuttig voor 93 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/24
mtxaudio.eu facebook.com/MTXEuropetwitter.com/MTXEurope
RT50.4M
4-Channel Class-AB Mini Ampliļ¬er
Designed by MTX in Phoenix, AZ - USA
www.mtxaudio.com - www.mtxaudio.eu
Ownerā€™s Manual - RT50.4M
Introduction
Thank you for purchasing an MTX Audio Hi-Performance ampliļ¬er. Proper installation matched with MTX speak-
ers and subwoofers provide superior sound and performance for endless hours of waking the neighbors, slam-
min' your friends or ļ¬‚at out stomping wanna-be players. Congrats and enjoy the ultimate audio experience with
MTX !
Speciļ¬cations :
ā€¢ 4-Channel Class-AB Ampliļ¬er
ā€¢ CEA2006 certiļ¬ed Power Output : 40 watts RMS x 4-channel at 4Ī© and THD+N ā‰¤1%
ā€¢ Signal-to-Noise Ratio (1 watt) : > 90dB
ā€¢ THD+Noise (Distortion) (1 watt) : ā‰¤ 1%
ā€¢ Frequency Response (Ā±1dB) : 20Hz-30000Hz
ā€¢ Input Sensitivity : 100mV to 6V
ā€¢ High level inputs on ISO connectors
ā€¢ Low level inputs on RCA connectors
ā€¢ Speaker outputs on ISO connectors
ā€¢ Dimensions : 260 x 120 x 52mm
Control Panel
Control Panel :
Ground Terminal (GND) : A proper ground is required for your ampliļ¬er to operate at peak performance. A short
ground cable the same diameter as the power cable should be used to attach the ground terminal directly to
the chassis of the vehicle. Always remove paint, dirt or debris to expose bare metal where the ground will be
attached.
Remote Terminal (REM) : The ampliļ¬er can be turned on by applying 12 volts to this terminal. Typically this volt-
age is supplied by a wire from the source unit marked ā€œremoteā€ or ā€œpower antennaā€.
(+12V) Power Terminal : This is the main power input for the ampliļ¬er and must be connected directly to the posi-
tive terminal of the vehicles battery for proper operation. Use caution when installing (+12V) power cable in the
vehicle. Avoid running this cable parallel with RCA cables, antennas, or other sensitive equipment due to massive
currents that can induce noise into the audio system. It is also very important to have a tight, secure connection
for maximum performance. MTX recommends using 8 to 10mm
2 power wire with the MTX RT50.4M ampliļ¬er.
Speaker output on ISO connector (Speaker output) : These are the speaker outputs to be connected to the car
speakers. Connect the car ISO speaker connector here. You can use the included extension cord if needed.
Speaker high level input on ISO connector (High Level Input) : This is the high level speaker input to be con-
nected to the car radio.
You can use the included extension cord if needed.
PowerOn/Protection LED - The LEDs illuminate red when the amp is switched on. When the amps is in short
circuit, low impedance or thermal protection, the LEDs are blinking.
Remote switch (Remote) : Allows you to choose between the usual wired remote (ā€œCableā€ position when using
the remote from in power connector) or automatic remote (Auto position). If a remote wire is available behind
your head unit, it is better to use it.
Gain Control (Gain) : The gain control matches the input sensitivity of the ampliļ¬er to the source unit being used.
The operating range varies from 100mv to 6V.
Adjusting the gain
1. Turn the gain control on the ampliļ¬er all the way down (counter clockwise).
2. Turn up the volume control on the source unit to approximately 3ā„4 of maximum.
3. Adjust the gain control on the ampliļ¬er until audible distortion occurs.
4. Adjust the gain control down until audible distortion disappears.
5. The ampliļ¬er is now calibrated to the output of the source unit.
RCA Inputs connector (RCA Inputs) : Used with source units that have RCA or Line level outputs. Source units
need a minimum level of 100mV output for proper operation of the ampliļ¬er. A wire harness is included in the
box. MTX recommends only high quality twisted pair cables (such as StreetWires) to decrease the possibility of
radiated noise entering the system.


Product specificaties

Merk: Mtx Audio
Categorie: Autoradio
Model: RT50.4M

Heb je hulp nodig?

Als je hulp nodig hebt met Mtx Audio RT50.4M stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Autoradio Mtx Audio

Handleiding Autoradio

Nieuwste handleidingen voor Autoradio