HBM DSA100-GL1 Handleiding

HBM Ultrasone reiniger DSA100-GL1

Lees hieronder de 📖 handleiding in het Nederlandse voor HBM DSA100-GL1 (3 pagina's) in de categorie Ultrasone reiniger. Deze handleiding was nuttig voor 67 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/3
Ford
2015 201 –8 F150
- Specially designed for the Ford F150 truck for an OEM look.
- With hole to mount OEM LED light kit. Snap cap is included to cover the hole when not used.
- 170 degree wide view angle for excellent visibility.
- With Parking Guide Lines.
- Minimum illuminaon 0.1 lux.
Tailgate Handle Camera Assembly
26 Ft. Extension Cable
Zip es & Taps
1. Remove the 8 T25 Torx screws holding the liner.
2. Once the liner is removed, the top half of the
sheet metal cover can easily be removed.
rev.011818
1 / 3
3. View with the sheet metal cover removed.
4. Remove the latch rod by pressing in the locks on
the sides then pull back.
5. Remove the two 10mm nuts holding the
tailgate handle.
6. Carefully remove the tailgate handle assembly by
liing the handle and pulling slightly upward.
Remove the OE lock and install it on the CFD-15KL.
7. Fish the video and power cables inside the
tailgate towards the bed of the truck.
8. Run the cables through the hole on the bed and
under the bed of the truck. We recommend
running the cable under the passenger side of the
truck bed.
rev.011818
2 3 /
9. Remove the OEM LED light kit and install it in
the CFD- L camera assembly. -install the 15K Re
CFD- L and secure it with the 10mm nuts. 15K
10. Remove the passenger tail light assembly by
removing the 2 screws on the side.
11. Tap the power and ground wires of the camera
cable to the reverse light wires as follows:
RED = GREEN/Black
BLACK = BLACK/Yellow
12. Run the video cable towards the front of the
truck and pass through holes found between
the truck bed and cabin.
13. Remove the passenger side door sill and run
the cable towards the radio and plug the video
RCA to the aî…¿ermarket radio or RVC Interface.
14. With the e-brake engaged, put the vehicle in
reverse and check the camera funconality. If
the camera image is seen on the screen, you
can reinstall the tail gate sheet metal cover
and bed liner.
rev.011818
3 3 /


Product specificaties

Merk: HBM
Categorie: Ultrasone reiniger
Model: DSA100-GL1

Heb je hulp nodig?

Als je hulp nodig hebt met HBM DSA100-GL1 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden